Mitel 480 Bedienungsanleitung

Andere Handbücher für 480

3

Dieses Handbuch passt für folgende Modelle

2

Andere Mitel IP-Telefon Handbücher

Mitel

Mitel OfficeConnect 5212 Bedienungsanleitung

Mitel

Mitel MiVOICE 6930 Bedienungsanleitung

Mitel

Mitel MiVoice 5312 Bedienungsanleitung

Mitel

Mitel MiVoice 5312 Bedienungsanleitung

Mitel

Mitel 7433 Bedienungsanleitung

Mitel

Mitel 5300 Series Bedienungsanleitung

Mitel

Mitel 6863i Bedienungsanleitung

Mitel

Mitel MIVOICE OFFICE 250 Bedienungsanleitung

Mitel

Mitel 112 Bedienungsanleitung

Mitel

Mitel NETWORKS 5010 Bedienungsanleitung

Mitel

Mitel 6869i Bedienungsanleitung

Mitel

Mitel MiVoice 5340e Bedienungsanleitung

Mitel

Mitel networks 5240 Bedienungsanleitung

Mitel

Mitel 480 Bedienungsanleitung

Mitel

Mitel MiVOICE 6920 Bedienungsanleitung

Mitel

Mitel MiVoice 5312 Bedienungsanleitung

Mitel

Mitel 5207 Bedienungsanleitung

Mitel

Mitel OfficeConnect 5212 Bedienungsanleitung

Mitel

Mitel 5005 Bedienungsanleitung

Mitel

Mitel MiVoice Connect IP480 Bedienungsanleitung

Mitel

Mitel OfficeConnect 5212 Produktinformationsblatt

Mitel

Mitel MiVoice 6910 Bedienungsanleitung

Mitel

Mitel MiVoice 6940 Bedienungsanleitung

Mitel

Mitel 480 Bedienungsanleitung

Beliebte IP-Telefon Handbücher anderer Marken

Alcatel

Alcatel 4028 Bedienungsanleitung

Polycom

Polycom Polycom VVX 600 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 450 Bedienungsanleitung

Cisco

Cisco SPA-500 Series Bedienungsanleitung

Polycom

Polycom SoundPoint IP 650 Bedienungsanleitung

Proximus

Proximus Maestro 3016 IP Bedienungsanleitung

Fanvil

Fanvil X4 Bedienungsanleitung

Cisco

Cisco 7962 Bedienungsanleitung

Snom

Snom 320 Bedienungsanleitung

Yealink

Yealink Yealink SIP-T46G Bedienungsanleitung

Avaya

Avaya 4625SW Bedienungsanleitung

Yealink

Yealink SIP-T52S Bedienungsanleitung

Nortel

Nortel 1140E Bedienungsanleitung

Nexotek

Nexotek NT-P500 Bedienungsanleitung

Avaya

Avaya Integral 5 R3.0 Bedienungsanleitung

GE

GE 28320EE2 - Dect 6.0 InfoLink 2 Bedienungsanleitung

Avaya

Avaya 4600 Series Service-Handbuch

Nortel

Nortel i2050 Bedienungsanleitung

1

2

2

1

Adjusng the Viewing Angle of the Phone

(Oponal)

The IP Phone stand supports two lt angles for the phone on desk.

The stand is shipped in the low posion. Use these instrucons to change the lt angle.

Remove the Stand:

1. Grasp the phone base in one hand and the stand in the other.

2. Pull the stand o the base unl it unsnaps.

Replace the Stand:

1. Rotate the stand 180 degrees. Seat the stand rmly in the hooks.

2. Push the stand into the base unl it snaps into place.

Connecng to Power over Ethernet

Required Items:

l Ethernet cable for IP Phone (included)

l Network wall port that supports power or Power over Ethernet (PoE)

Note: This conguraon describes a Power over Ethernet connecon. Refer to Connecng to Power

and the Network on page 2 if your network wall port or data switch does not support Power over

Ethernet.

IP Phone 480/480g/485g

Quick Install Guide

Connecng a Headset (Oponal)

The IP Phone supports use of an oponal Headset, as shown. Aer connecng the headset,

select the Headset buon on the front panel of the IP Phone.

Remove Replace

Copyright © 2017 Mitel Networks Corporaon. All Rights Reserved. The Mitel word and logo are trademarks of Mitel Networks Corporaon.

Any reference to third-party trademarks is for reference only and Mitel makes no representaon of ownership of these marks.

Part Number: 800-1540-10

41

Connect Power over Ethernet:

1. Connect one end of the Ethernet cable to the Ethernet port on the IP Phone.

2. Connect the other end of the Ethernet cable to a network wall port that supports Power over

Ethernet. Aer a few seconds, the IP Phone powers on and runs through a series of system tests.

Note: IP Phone 480 supports 10/100 Ethernet network speed. IP Phones 480g/485g support 10/100/1000 network speed.

Low angle High angle

1

2

4

5

12 3

AB

3

2

1

C

Connecng to Power and the Network

Required Items for connecng to Power and the Network:

l PoE (Power over Ethernet) Adapter. One Ethernet cable and AC power cable included.

l Ethernet cable for connecng IP Phone to PoE Adapter (included with phone)

Note: This conguraon requires a PoE adapter and two Ethernet cables.

Refer to Connecng to Power over Ethernet on page 1 if your network wall port

supports Power over Ethernet.

Connecng to a Computer (Oponal)

The IP Phone supports connecng to a PC or laptop.

Required Items for connecng the IP Phone to a computer:

l Computer

l Ethernet cable for connecng IP Phone to computer (not included)

3

2

Connect to Power and the Network:

1. Connect one end of ETHERNET CABLE A to the Ethernet port on the IP Phone.

2. Connect the other end of ETHERNET CABLE A to the DATA AND POWER OUT port on the PoE

adapter.

3. Connect one end of ETHERNET CABLE B to the DATA IN port on the PoE adapter.

4. Connect the other end of ETHERNET CABLE B to a network wall port.

5. Connect power from the PoE adapter to an appropriate power source. Aer a few

seconds, the IP Phone powers on and runs through a series of system tests.

Connect to a Computer:

1. Follow instrucons Connecng to Power over Ethernet on page 1 or Connecng to Power and

the Network on page 2.

2. Connect one end of ETHERNET CABLE C to the PC port on the IP Phone.

3. Connect the other end of ETHERNET CABLE C to the Ethernet port on a PC or laptop.