Monogram Monogram ZIBI240PII Benutzerhandbuch
ZIBI240PII – GE Monogram Bar Refrigerator with Icemaker Module
(Custom panel required)
ZIBS240PSS – GE Monogram Bar Refrigerator with Icemaker Module
(Stainless steel)
For answers to your Monogram,
® GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Dimensions and Specifications (in inches)
Installation Space
The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and
access to the pull-out racks when installed as a built-in.
• The Bar Refrigerator with Icemaker can be free-standing.
• The stainless steel model ZIBS240PSS can be installed flush
with standard cabinetry. ZIBI240PII with custom panel will
project forward 1-3/4" of adjacent 24" deep base cabinets.
• A water line must be installed for icemaker operation.
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
Product Clearances
16" Minimum
110˚
Wall
24"
Cabinet
14" Minimum
110˚
Wall
24"
Cabinet
All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow 4" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 4-1/2" min. clearance to wall on the hinge side for models
with a custom panel and custom handle.
For a full 110° door swing:
• Allow 14" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 16" min. clearance to wall on the hinge side for models with
a custom panel and custom handle.
Stainless Steel
Models
Models with a Custom
Door Panel
34-1/2"
to
35"
24" Min.
23-3/4"
34-1/2"
23-3/4" Stainless Steel
Models
24-7/8" Framed Models
1-1/2"
1/2"
Locate Outlet
Water and
Electrical
Locations
9"
Max.
10-1/2"
Depth Including
Handle:
26" Stainless Steel
Models Only
23-3/4" Min.
Note: If installing between frameless
cabinets, a 1/2" wide filler strip or side panel
may be required. The filler strip will act as a
spacer between the door case and adjacent cabinet
and will prevent interference with cabinet door swing.
The width of the opening must include filler panels.
Specification Created 3/04
120034
Specification Created 3/04
120034
ZIBI240PII – GE Monogram Bar Refrigerator with Icemaker Module
(Custom panel required)
ZIBS240PSS – GE Monogram Bar Refrigerator with Icemaker Module
(Stainless steel)
Dimensions and Specifications (in inches)
34-1/2" - 35"
24" Min.
47-1/2" Min.
1-1/2"
Locate Outlets
9"
Max.
10-1/2"
1-1/2"
9"
Max.
10-1/2"
24"
For a complete food storage center, install two Monogram refrigeration
modules side-by-side.
Note: Reversible door swing on wine chillers/reserves and beverage
centers only. See below for combination cutout dimensions.
Important Note: Products must operate from separate, properly
grounded receptacles.
Grounding the Bar Refrigerator with Icemaker
IMPORTANT – (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with a 3-prong
(grounding) plug which mates with a standard 3-prong (grounding)
wall receptacle to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your
personal responsibility and obligation to have it replaced with a
properly grounded 3-prong wall out.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
REFRIGERATOR TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.
Note: Additional cutout width may be required for models with
custom panels.
3/4” Overlay Panel Dimensions
Model ZIBI240PII requires customer-provided
overlay door panel.
• The overlay panel must be secured to a 1/4"
thick backer panel which slides into the trim.
A .10" thick spacer panel must be placed
between the custom and backer panel.
• A custom handle, supplied by your cabinet
maker, must be installed on the overlay panels.
Overlay
Panel
1/4"
Backer
Panel
Door
.10 Inch
Spacer
3/4" Overlay Panel Dimensions (in inches)
A (Width) B (Height)
1/4" Backer 23-3/16" 29-9/16"
0.10" Spacer 22-1/2" 29-1/16"
3/4" Overlay 23-5/8" 30"
NOTE: Max. assembled drawer panel weight
is 25 lbs.
Assemble overlay panels with glue
and screws.
• Center spacer panel on the backer panel,
left to right and top to bottom. Secure
the panels with glue.
• Center the spacer/backer panel on
the overlay panel. Secure with glue
and screws. Countersink screws into
the backer panel.
Spacer Panel
Backer Panel
Overlay Panel
For answers to your Monogram,
® GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Use a 3/4" router bit to cut a notch into the back side
of the assembled panel to allow for hinge clearance.
A
B
3/4" Deep
7/8" Wide
3/8" toward
the front side
Back Side
of Panel
Specification Created 3/04
120034
Features and Benefits
• Automatic icemaker on full-extension slides – Makes ice
automatically to ensure a ready supply
• Electronic adjustable temperature control – Offers a range
of temperatures for precise chilling
• LED temperature display – Allows you to monitor the
temperature at a glance
• Removable ice bin – Holds up to 8 lbs. of ice
• Removable spillproof glass shelves – Help contain spills
for ease of cleaning
• Beverage shelf on full-extension slides – Holds up to
five wine bottles or ten 12-oz. cans
• Custom panel and handle required – Customer must install
a custom door panel and handle to complement their
décor (ZIBI240PII only)
• Ice scoop – Heavy duty scoop included
• Model ZIBS240PSS – Stainless steel
• Model ZIBI240PII – Custom panel and handle required
ZIBI240PII – GE Monogram Bar Refrigerator with Icemaker Module
(Custom panel required)
ZIBS240PSS – GE Monogram Bar Refrigerator with Icemaker Module
(Stainless steel)
ZIBS240PSS Head On
ZIFS240PSS
Andere Handbücher für Monogram ZIBI240PII
2
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Monogram Kühlschrank Handbücher
Monogram
Monogram Bottom-Freezer Built-In Refrigerators Bedienungsanleitung
Monogram
Monogram ZIBI240HII Bedienungsanleitung
Monogram
Monogram 36 Ceramic Cooktop Bedienungsanleitung
Monogram
Monogram ZSAB1 Bedienungsanleitung
Monogram
Monogram Monogram ZIRS360NX Handbuch
Monogram
Monogram Monogram ZIBI240PII Bedienungsanleitung
Monogram
Monogram Monogram ZIBI240PII Bedienungsanleitung
Monogram
Monogram Double Door, Double Drawer, Stainless Steel, Free-Standing... Bedienungsanleitung
Monogram
Monogram ZIC30GNZII Bedienungsanleitung
Monogram
Monogram ZSGS420D Bedienungsanleitung
Monogram
Monogram Monogram ZISB480DR Benutzerhandbuch
Monogram
Monogram ZIR360 Bedienungsanleitung
Monogram
Monogram ZFSB25D SS Bedienungsanleitung
Monogram
Monogram ZIF361 Bedienungsanleitung
Monogram
Monogram ZIFI240 Bedienungsanleitung
Monogram
Monogram ZIFX240HX Bedienungsanleitung
Monogram
Monogram ZFSB23DRDSS Bedienungsanleitung
Monogram
Monogram ZIDI240 Leitfaden
Monogram
Monogram ZIPS360NHSS Bedienungsanleitung
Monogram
Monogram ZIRS36N LH Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
