Motorola RMN5104 Bedienungsanleitung

BLUETOOTH ® ADAPTER

RMN5104

EN LAS BP FRC

Wirelesssolution.book Page 1 Monday, November 5, 2007 8:48 PM

Wirelesssolution.book Page 2 Monday, November 5, 2007 8:48 PM

English

FOREWORD

Product Safety and RF Exposure

Compliance

ATTENTION!

The radio is restricted to occupational use only to satisfy

FCC RF energy exposure requirements. Before using

this product, read the RF energy awareness information

and operating instructions in the Product Safety and RF

Exposure booklet enclosed with your radio (Motorola

Publication part number 6881095C98) to ensure

compliance with RF energy exposure limits.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept any interference received,

including interference that may cause undesired

Any changes or

modificationsBefore using this product, read

the operating instructions for

safe usage contained in the

Product Safety and RF

Exposure booklet enclosed with

your radio.

C a u t i o n

Bluetooth® is a registered trademark of the

Bluetooth Special Interest Group.

Wirelesssolution.book Page 1 Monday, November 5, 2007 8:48 PM

operation. Any changes or modifications not expressly

approved by Motorola may void the user's authority to

operate this device.

English

DESCRIPTION

The RMN5104 Bluetooth Adapter is an accessory

designed to complement Radio Models PR1500,

XTS 1500, XTS 2500, XTS 5000 and HT1000.

OPERATION

Removing the Radio's Universal

Connector Cover

If the radio's universal connector cover is installed

on the radio, refer to Figure 1 and perform the

following steps:

1. Looking at the antenna side of the radio, insert

a flat blade screwdriver between the lower end

of the universal connector cover and the slot

below the universal connector.

2. Pry upwards on the cover's lower end until it

disengages from the radio.

Figure 1: Removing the radio cover

Wirelesssolution.book Page 2 Monday, November 5, 2007 8:48 PM

English

Attaching the Bluetooth Adapter to the

radio's Universal Connector

Ensure that the radio is turned off before attaching

the Bluetooth adapter to the radio. Refer to

“Attaching the Bluetooth Adapter to the radio's

Universal Connector” on page 3 and attach the

adapter to the radio as follows:

1. Inspect the seal of the adapter to ensure that it

is not damaged and is free of contamination.

2. Align the adapter to the radio's universal

connector.

3. Looking at the antenna side of the radio, insert

the bottom hooked end of the adapter into the

bottom slot below the universal connector on

the radio.

4. While holding the adapter seated in the bottom

slot, pivot the top of the adapter towards the

radio, then engage the adapter’s spring loaded

latch in the radio's top slot.

Wirelesssolution.book Page 3 Monday, November 5, 2007 8:48 PM

English

5. Secure the adapter to the radio using the

tethered screw.

Figure 2: Attaching the Bluetooth Adapter

to the Radio’s Universal Connector

Top

Slot

Bottom

Slot

Bottom

Hooked End

Screw

Spring

Latch

Wirelesssolution.book Page 4 Monday, November 5, 2007 8:48 PM

English

Pairing The Adapter And Headset

1. Turn ON the radio.

2. Place the headset in pairing mode (see

headset manual). Place the adapter in pairing

mode by pressing and holding the adapter PTT

switch for 3 seconds (see Figure 3).

Figure 3: The PTT Switch

3. Determine the adapter mode by observing the

LED:

• The LED blinks rapidly (ON twice per

second) when the adapter is attempting to

pair with the headset.

• The LED blinks slowly (ON once per

LED

Indicator

PTT

Switch

Wirelesssolution.book Page 5 Monday, November 5, 2007 8:48 PM

English

second) when the adapter is attempting to

reconnect with the previously paired

headset.

• The LED blinks very slowly (ON once every

4 seconds) when the adapter and headset

are paired.

4. When the adapter and headset pair, the LED

will light for 3 seconds and then blink once

every 4 seconds thereafter. It is recommended

to verify proper pairing by performing an audio

check such as squelch or keypad tone.

5. If the adapter and headset fail to pair within 30

seconds (the LED continues to blink once per

second), then turn them off and repeat Steps 1

to 3.

6. Once the adapter and headset are paired,

received audio is routed to the headset. To

transmit, press the adapter PTT switch and

speak into the headset microphone.

Reconnecting The Adapter and Headset

1. Turn ON the headset.

2. Attach the adapter to the radio.

3. Turn ON the radio.

4. The adapter and headset will automatically

reconnect within 30 seconds. The LED will

blink once every second during this time.

When they reconnect, the LED will light for 3

seconds, then blink once every 4 seconds

thereafter.

Wirelesssolution.book Page 6 Monday, November 5, 2007 8:48 PM

English

5. If the adapter and headset do not reconnect

within 30 seconds, then turn them off and

follow the steps under “Pairing The Adapter

And Headset” on page 5.

Lost Bluetooth Link

In the presence of interference, or if the radio and

adapter are out of range of the paired headset, it is

possible that the Bluetooth link between the

adapter and headset may be dropped. In this

case, received audio will be routed back to the

radio, and the radio's microphone will be active.

The adapter will attempt to reconnect to the

headset for 15 seconds. After this time, to

reestablish the Bluetooth link, it will be necessary

to repeat the process of “Pairing The Adapter And

Headset” on page 5.

Wirelesssolution.book Page 7 Monday, November 5, 2007 8:48 PM

English

Audio Routing Toggle Switch

The toggle switch on top of the adapter allows the

user to switch audio between the Bluetooth

adapter and the radio.

Figure 4: Audio Routing Toggle Switch

• With the toggle switch positioned away from

the radio, audio will be routed to the radio

speaker, and the radio microphone is active

during transmit.

• With the toggle switch positioned towards

the radio, audio will be routed to the

Bluetooth headset ear piece, and the

headset microphone will be active. The

LED

Indicator

Toggle

Switch

Wirelesssolution.book Page 8 Monday, November 5, 2007 8:48 PM

Inhaltsverzeichnis

Sprachen:

Andere Motorola Adapter Handbücher

Motorola

Motorola QG-PC850 Bedienungsanleitung

Motorola

Motorola MM1000 Bedienungs- und Wartungsanleitung

Motorola

Motorola M68CPA08QF80 Bedienungsanleitung

Motorola

Motorola UTA220/UTA220k Bedienungsanleitung

Motorola

Motorola BT02 Bedienungsanleitung

Motorola

Motorola PC800 Bedienungsanleitung

Motorola

Motorola WIRELESS NOTEBOOK ADAPTER WN825G - annexe 1 Kurzanleitung

Motorola

Motorola HS830 HANSFREE Bedienungsanleitung

Motorola

Motorola Motostart D200 Bedienungsanleitung

Motorola

Motorola PMLN6396 Bedienungsanleitung

Motorola

Motorola LPCI810 Bedienungsanleitung

Motorola

Motorola PMLN5792 Bedienungsanleitung

Motorola

Motorola GP Professional Series Bedienungsanleitung

Motorola

Motorola WN825Gv2 Bedienungsanleitung

Motorola

Motorola USBw 100 Series Bedienungsanleitung

Motorola

Motorola HLN9742 Bedienungsanleitung

Motorola

Motorola DCT700 Bedienungsanleitung

Motorola

Motorola WN825G Bedienungsanleitung

Motorola

Motorola PMLN8397 Bedienungsanleitung

Motorola

Motorola PC850 Bedienungsanleitung

Motorola

Motorola SURFboard SBM1100 Bedienungsanleitung

Motorola

Motorola MPMC221 Kurzanleitung

Motorola

Motorola LPCI810 Bedienungsanleitung

Motorola

Motorola D670 Montageanleitung

Beliebte Adapter Handbücher anderer Marken

PCB Piezotronics

PCB Piezotronics 090B274 Bedienungsanleitung

Gossen MetraWatt

Gossen MetraWatt AT3-III E Bedienungsanleitung

Akribis

Akribis ITF-21-BISS-MIT Bedienungsanleitung

Auvidea

Auvidea J20 Produkthandbuch

Tenda

Tenda W54U Bedienungsanleitung

ROHO

ROHO AGILITY Bedienungsanleitung

PROLiNK

PROLiNK WN2001 Bedienungsanleitung

Hawking

Hawking HUF2 Bedienungsanleitung

Airlink101

Airlink101 AWLC4030 Bedienungsanleitung

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Bedienungsanleitung

Philips

Philips SWA4554S/10 Bedienungsanleitung

JVC

JVC TS-C9D2B Gebrauchsanweisung

NETGEAR

NETGEAR A6100 Bedienungsanleitung

D-Link

D-Link DWA-121 Bedienungsanleitung

Philips

Philips SWA2037 Bedienungsanleitung

Basalte

Basalte 0610-20 Bedienungsanleitung

Yealink

Yealink EHS40 Bedienungsanleitung

RCA

RCA AH57R Bedienungsanleitung