Motorola MotoWI4 PTP 600 Series Bedienungsanleitung

TECHNICAL NOTE

LIGHTNING PROTECTION GUIDE

MOTOROLA

POINT-TO-POINT BROADBAND

WIRELESS SOLUTIONS

MOTOROLA

PTP 400 and 600 SERIES

WIRELESS ETHERNET BRIDGES

2TECH NOTE: LIGHTNING PROTECTION GUIDE

Table of Contents

Introduction ……………………………………………………………………………...…. 3

Recommended Tower/Mast Installation for PTP 400 and 600 Series Bridges .… 4

Recommended Wall-Mount Installation for PTP 400 and 600 Series Bridges .… 5

Recommended Tower/Mast Installation for PTP 600 Series Bridges with T1/E1 .… 6

Recommended Wall-Mount Installation for PTP 600 Series Bridges with T1/E1 .… 7

Installation Diagrams ……………..……………………………………………....….. 8 – 10

Pre- and Post-Power Testing for the PTP 400 Series Bridges ..………………………. 11

Pre- and Post-Power Testing for the PTP 600 Series Bridges ..………………………. 12

Pre-Power Testing for the PTP 600 Series with T1/E1 .….……………………… 13

The information in this publication is subject to change without notice.

Motorola shall not be liable for technical or editorial errors or omissions nor for any

damages resulting from the use of this material.

Each conﬁguration tested or described may or may not be the only available solution.

This test or description is not a determination of product quality or correctness, nor

does it ensure compliance with any federal, state or local requirements. Motorola

does not warrant products other than its own strictly as stated in Motorola’s product

warranties.

MOTOROLA, the stylized M Logo and all other trademarks indicated as such herein are trademarks of Motorola, Inc. ® Reg. US Pat & Tm. Ofﬁce. All other product or

3TECH NOTE: LIGHTNING PROTECTION GUIDE

Introduction

This Technical Note provides you with detailed instructions for setting up lightning

arrestors to protect your Motorola PTP 400 and 600 Series bridges. The

recommendations provided in this Technical Note will provide the best protection

from the harmful effects of electro-magnetic discharge (EMD). The Surge Arrestor

(ALPU-ORT) should be used on all PTP 400 and 600 bridge interface ports, including

the Ethernet, T1/E1 and power ports. Speciﬁcally, this document includes:

• Illustrations showing the placement of your arrestors and the recommended

components for installation

• Diagrams indicating the proper wiring procedures

4TECH NOTE: LIGHTNING PROTECTION GUIDE

Recommended Tower/Mast Installation for

Motorola PTP 400 and 600 Series Bridges

(Applicable to ODUs marked MODIFICATION STRIKE 2 and above)

The recommended components for protecting an installation are:

• Grounding Kit – Andrew Type 223158 (www.andrew.com)

• Screened CAT5e cable, also known as Shielded Twisted Pair or Shielded CAT5e

– DO NOT USE “NON-shielded CAT5e cable.” It will not provide any grounding

points or protect from static discharge or lightning strike. There may be a local

regulatory requirement to cross bond the CAT5e cable at regular intervals to the

mast. This may be as frequent as every 33 feet (10 meters).

• Surge Arrestor – ALPU-ORT

• Grounding Stake

• 8 AWG Grounding Cable (minimum gauge)

NOTE: Lightning damage is not covered under the Motorola Warranty. When correctly installed, the

recommendations on this page and in this Technical Note give the user the best protection from the

harmful effects of lightning. However, 100% protection is not implied or possible.

For Use with Tower/Mast Installations

5TECH NOTE: LIGHTNING PROTECTION GUIDE

Recommended Wall-Mount Installation for

Motorola PTP 400 and 600 Series Bridges

(Applicable to ODUs marked MODIFICATION STRIKE 2 and above)

The recommended components for protecting an installation are:

• Grounding Kit – Andrew Type 223158 (www.andrew.com)

• Screened CAT5e cable, also known as Shielded Twisted Pair or Shielded CAT5e

– DO NOT USE “NON-shielded CAT5e cable.” It will not provide any grounding

points or protect from static discharge or lightning strike.

• Surge Arrestor – ALPU-ORT

• Grounding Stake

• 8 AWG Grounding Cable (minimum gauge)

NOTE: Lightning damage is not covered under the Motorola Warranty. When correctly installed, the

recommendations on this page and in this Technical Note give the user the best protection from the

harmful effects of lightning. However, 100% protection is not implied or possible.

For Use with Wall-Mount Installations

6TECH NOTE: LIGHTNING PROTECTION GUIDE

Recommended Tower/Mast Installation for

Motorola PTP 600 Series Bridges with T1/E1

The recommended components for protecting an installation are:

• Grounding Kit – Andrew Type 223158 (www.andrew.com)

• Screened CAT5e cable, also known as Shielded Twisted Pair or Shielded CAT5e

– DO NOT USE “NON-shielded CAT5e cable.” It will not provide any grounding

points or protect from static discharge or lightning strike. There may be a local

regulatory requirement to cross bond the CAT5e cable at regular intervals to the

mast. This may be as frequent as every 33 feet (10 meters).

• Surge Arrestor – ALPU-ORT – 4 per link (or 8 per link with T1/E1)

• Grounding Stake

• 8 AWG Grounding Cable (minimum gauge)

NOTE: Lightning damage is not covered under the Motorola Warranty. When correctly installed, the

recommendations on this page and in this Technical Note give the user the best protection from the

harmful effects of lightning. However, 100% protection is not implied or possible.

For Use with Tower/Mast Installations with T1/E1 Cable

7TECH NOTE: LIGHTNING PROTECTION GUIDE

Recommended Wall-Mount Installation for

Motorola PTP 600 Series Bridges with T1/E1

The recommended components for protecting an installation are:

• Grounding Kit – Andrew Type 223158 (www.andrew.com)

• Screened CAT5e cable, also known as Shielded Twisted Pair or Shielded CAT5e

– DO NOT USE “NON-shielded CAT5e cable.” It will not provide any grounding

points or protect from static discharge or lightning strike.

• Surge Arrestor – ALPU-ORT – 4 per link (or 8 per link with T1/E1)

• Grounding Stake

• 8 AWG Grounding Cable (minimum gauge)

NOTE: Lightning damage is not covered under the Motorola Warranty. When correctly installed, the

recommendations on this page and in this Technical Note give the user the best protection from the

harmful effects of lightning. However, 100% protection is not implied or possible.

For Use with Wall-Mount Installations with T1/E1 cable

8TECH NOTE: LIGHTNING PROTECTION GUIDE

110 Punch-Down Tool

Make sure the surge arrestor box is

mounted vertically with the cable

glands at the bottom.

Cable to the Motorola PTP 400

or PTP 600 PIDU Plus inside the

building.

Cable from the Motorola PTP 400

or PTP 600 outdoor unit (ODU).

Installation

Diagram 1

9TECH NOTE: LIGHTNING PROTECTION GUIDE

Attach a 6- or 8-gauge ground wire from a veriﬁed building ground point to the

lug on the side of the suppressor.

Installation

Diagram 2

10 TECH NOTE: LIGHTNING PROTECTION GUIDE

After terminating the

cables, push the

cables into the box

and secure the cover

with the screws.

Shield drain wire

from cable.

Punch down the remaining wires in the color sequence shown above.

(See the following wiring charts for details.)

Shield drain wire from

cable.

Secure both shield

drain wires onto the

grounding lug.

CON3CON1

CON4CON2

Terminal

Identiﬁcation Conductor RJ45 Pin

CON3 PIN 1 Orange/White 1

CON3 PIN 2 Orange 2

CON3 PIN 3 Green/White 3

CON3 PIN 6 Green 6

CON1 PIN 4 Blue 4

CON1 PIN 5 Blue/White 5

CON1 PIN 7 Brown/White 7

CON1 PIN 8 Brown 8

Terminal

Identiﬁcation Conductor RJ45 Pin

CON4 PIN 1 Orange/White 1

CON4 PIN 2 Orange 2

CON4 PIN 3 Green/White 3

CON4 PIN 6 Green 6

CON2 PIN 4 Blue 4

CON2 PIN 5 Blue/White 5

CON2 PIN 7 Brown/White 7

CON2 PIN 8 Brown 8

ALPU-ORT Cable 1 Termination ALPU-ORT Cable 2 Termination

Installation

Diagram 3

Andere Handbücher für MotoWI4 PTP 600 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Motorola Netzwerk-Router Handbücher

Motorola

Motorola RFS6000 - Wireless RF Switch Bedienungsanleitung

Motorola

Motorola 110502USM001 - Vanguard 60 Router Bedienungsanleitung

Motorola

Motorola CPEI 890 Bedienungsanleitung

Motorola

Motorola CPEI 775 Series Bedienungsanleitung

Motorola

Motorola PTP 300 Series Kurzanleitung

Motorola

Motorola Netopia 7000 Bedienungsanleitung

Motorola

Motorola 2108-N9 Bedienungsanleitung

Motorola

Motorola BSR 64000 Bedienungsanleitung

Motorola

Motorola PTP 48600 Bedienungsanleitung

Motorola

Motorola MT7711 Bedienungsanleitung

Motorola

Motorola VL-RISC MCF5202 Bedienungsanleitung

Motorola

Motorola BSR 2000 Bedienungsanleitung

Motorola

Motorola BSR 2000 Bedienungsanleitung

Motorola

Motorola WR850G - Wireless Broadband Router Bedienungsanleitung

Motorola

Motorola MH7021 Bedienungsanleitung

Motorola

Motorola PTP 300Series Kurzanleitung

Motorola

Motorola MR1700 Bedienungsanleitung

Motorola

Motorola 68390 - Vanguard 320 Router Bedienungsanleitung

Motorola

Motorola 7640-47 Handbuch

Motorola

Motorola WE800G - Wireless EN Bridge Bedienungsanleitung

Motorola

Motorola EX-3524 Bedienungsanleitung

Motorola

Motorola EX-3524 Bedienungsanleitung

Motorola

Motorola Wireless Broadband Platform Bedienungsanleitung

Motorola

Motorola PTP 600 Series Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise

LevelOne

LevelOne FBR-1416 Bedienungsanleitung

Dynacord

Dynacord Promatrix 6000 Bedienungsanleitung