Motorola MVME6100 Bedienungsanleitung

Important Information

V6100A/LT1

July 2004

MVME6100 Starter Kit Getting Started Guide

Dear Customer:

This document provides information to help you start evaluation and development using the

MVME6100single-boardcomputer.Itdocumentsthehardware componentsof yourStarterKit,

how to assemble the components, and where to obtain Linux or VxWorks development

information

The following components are included in your kit:

❏VME 3U, 6 slot chassis with 5-row backplane, AC power, fans, alarm card

❏MVME6100 series board with 2eSST performance sustaining 300 MB/s data

transfers

❏Power cord

❏Ethernet and serial cables

ESD Precautions

Use ESD

Wrist Strap

Motorola strongly recommends that you use an antistatic wrist strap and a

conductive foam pad when installing or upgrading a system. Electronic

components, such as disk drives, computer boards, and memory modules, can

be extremely sensitive to electrostatic discharge (ESD). After removing the

component from its protective wrapper or from the system, place the

component flat on a grounded, static-free surface (and, inthe case of a board,

component side up). Do not slide the component over any surface.

If an ESD station is not available, you can avoid damage resulting from ESD

by wearing an antistatic wrist strap (available at electronic stores) that is

attached to an active electrical ground. Note that a system chassis may not be

grounded if it is unplugged.

MVME6100 Starter Kit Getting Started Guide

System Assembly

The following paragraphs briefly describe the steps required to assemble the components of

your MVME6100 Starter Kit.

Installing the MVME6100 into the Chassis

Consult Chapter 1 of the MVME6100 Single-Board Computer Installation and Use manual at

http://www.motorola.com/computer/literature for configuration of the MVME6100 board.

Use the following steps to install the MVME6100 into your computer chassis:

1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an

electrical ground. The ESD strap must be secured to your wrist and to ground

throughout the procedure.

2. Remove any filler panel that might fill that slot.

3. Install the top and bottom edge of the MVME6100 into the guides of the chassis.

Warning

Only use injector handles for board insertion to avoid damage/deformation to

the front panel and/or PCB. Deformation of the front panel can cause an

electrical short or other board malfunction.

4. Ensure that the levers of the two injector/ejectors are in the outward position.

5. Slide the MVME6100 into the chassis until resistance is felt.

6. Simultaneously move the injector/ejector levers in an upward direction.

7. Verify that the MVME6100 is properly seated and secure it to the chassis using

the two screws located adjacent to the injector/ejector levels.

8. Connect the appropriate cables to the MVME6100 as stated below.

To remove the board from the chassis, press the red locking tabs (IEEE handles only) and

reverse the procedure.

V6100A/LT1

Populate the chassis according to the rules of the VITA 1.1 Specification. Refer to

http://www.vita.com for information.

Connecting The Serial Cable

When the MVME6100 is installed in the chassis, you are ready to connect the serial cable, if

required. Use the DB9-to-RJ45 adapter supplied in your kit. The following table shows the

pinouts for the DB9 female-to-RJ45 adapter assembly.

4289 0504

MVME6100 Starter Kit Getting Started Guide

Connecting The Ethernet Cable

You are now ready to attach the RJ45 Ethernet connector to your network, if required. Ensure

that you are connecting the cable to the port that you have configured the software to use.

Software Information

Depending on the development platform you are using, you can obtain the software and related

information at the following web sites:

❏For Linux: http://www.motorola.com/linux and click on the Downloads &

Support link.

❏For VxWorks Board Support Package (BSP): consult the Wind River web site at:

http://www.windriver.com and type MVME6100 into the Search window to

easily access the mv6100 BSP.

RJ45

Signal

RJ45

Socket

8 Position To Color

DB9

Socket

9 Position DB9

Signal

DCD 1 Blue 4 DTR

RTS 2 Orange 8 CTS

GND 3 Black 5 GND

GND 6 Yellow 5 GND

TxD 4 Red 2 RxD

RxD 5 Green 3 TxD

CTS 7 Brown 7 RTS

DTR 8 White 6 DSR

DTR 8 White 1 DCD

Andere Handbücher für MVME6100

Inhaltsverzeichnis

Andere Motorola Einplatinencomputer Handbücher

Motorola

Motorola MCPN750A Kurzanleitung

Motorola

Motorola MVME1603 Kurzanleitung

Motorola

Motorola MVME297-002 Bedienungsanleitung

Motorola

Motorola MVME197LE Bedienungsanleitung

Motorola

Motorola MVME5100 Series Kurzanleitung

Motorola

Motorola M68MPFB1632 Bedienungsanleitung

Motorola

Motorola MVME177 Leitfaden

Motorola

Motorola MVME167-32 Bedienungsanleitung

Motorola

Motorola MVME197DP Bedienungsanleitung

Motorola

Motorola McIAS 1610 Series Benutzerhandbuch

Motorola

Motorola CompactPCI CPV5350 Installations- und Betriebsanleitung

Motorola

Motorola MVME2600 Series Bedienungsanleitung

Motorola

Motorola MCP750HA Series Kurzanleitung

Motorola

Motorola CompactPCI CPN5365 Betriebsanleitung

Motorola

Motorola MVME2600 Series Leitfaden

Motorola

Motorola IXP/CPCI-9120 Bedienungsanleitung

Motorola

Motorola MVME187 Bedienungsanleitung

Motorola

Motorola MVME177P Kurzanleitung

Motorola

Motorola MVME2400 Series Bedienungsanleitung

Motorola

Motorola MVME2100 Bedienungsanleitung

Motorola

Motorola MVME1603 Kurzanleitung

Motorola

Motorola CPIP5430 Kurzanleitung

Beliebte Einplatinencomputer Handbücher anderer Marken

WIN Enterprises

WIN Enterprises PL-80910 Bedienungsanleitung

AXIOMTEK

AXIOMTEK SBC81206 Series Bedienungsanleitung

Embest

Embest SOM-PH8800 Bedienungsanleitung

SeaLevel

SeaLevel SBC-R9 Bedienungsanleitung

SMART Embedded Computing

SMART Embedded Computing ATCA-8310 Bedienungsanleitung

WinSystems

WinSystems PPM-LX800-G Bedienungsanleitung

GIGAIPC

GIGAIPC QBiX-PPC Series Bedienungsanleitung

OLIMEX

OLIMEX A10S-OLinuXino-MICRO Bedienungsanleitung

Commell

Commell FS-978 Bedienungsanleitung

GIGAIPC

GIGAIPC QBiP-8665A/ Bedienungsanleitung

VersaLogic

VersaLogic Python EBX-11 Bedienungsanleitung

Micro Computer Specialists

Micro Computer Specialists IRV-3702 Bedienungsanleitung

CompuLab

CompuLab SB-A510 Bedienungsanleitung

Boser

Boser HS-7321 Bedienungsanleitung

Premier Farnell

Premier Farnell Embest SBC8530 Bedienungsanleitung

MicroSys Electronics

MicroSys Electronics miriac SBC-LS1043A2 Bedienungsanleitung

Aaeon

Aaeon UP Bedienungsanleitung

Portwell

Portwell WUX Series Bedienungsanleitung