Moxa Technologies OnCell G3111 Bedienungsanleitung
– 1 – – 2 – – 3 –
P/N: 1802031010011
OnCell G3101/G3201 Series
Quick Installation Guide
Second Edition, April 2014
Overview
There are currently four models in the OnCell G3101/G3201 series
of IP-modems: the OnCell G3111, OnCell G3151, OnCell G3211,
and OnCell G3251. The main difference between the models is the
serial interface type and number of ports. The OnCell
G3101/G3201 industrial RS-232, RS-232/422/485 GSM/GPRS IP
modems are some of the most affordable, and versatile products
available in the cellular networking market today. These modems
also provide remote access and TCP/IP support, and can be
configured over a network.
Package Checklist
Before Installing the OnCell G3101/G3201 series, verify that the
package contains the following items:
Standard Accessories
•Document & Software CD
•Omni 1 dBi rubber SMA antenna
•(model name: ANT-CQB-ASM-01)
•DIN-Rail Kit
•DC Power Supply (screw-on)
•Rubber stand
•Product warranty statement
•Quick Installation Guide
Optional Accessories
•Quad-band GSM/GPRS antennas for OnCell G3101/G3201
series (impedance = 50 ohms):
ANT-CQB-AHSM-00-3m: Omni 0dBi/10cm, magnetic
SMA quad-band antenna (impedance = 50 ohms), 3 m
ANT-CQB-AHSM-03-3m: Omni 3dBi/25cm, magnetic
SMA quad-band antenna (impedance = 50 ohms), 3 m
ANT-CQB-AHSM-05-3m: Omni 5dBi/37cm, magnetic
SMA quad-band antenna (impedance = 50 ohms), 3 m
Note: Please notify your sales representative if any of the above
items are missing or damaged.
Hardware Introduction
Top View
Front Views
Rear Views
Bottom Views
Reset Button—Press and hold the Reset button for 5 sec to load
factory defaults: Use a pointed object, such as a straightened
paper clip or toothpick, to press the reset button. This will cause
the Ready LED to blink on and off. The factory defaults will be
loaded once the Ready LED stops blinking (after about 5 seconds).
At this point, you should release the reset button (the default IP is
192.168.127.254).
LED Indicators
The LED indicators on the front panel of the OnCell G3101/G3201
are described in the following table.
Type
Color
LED Function
PWR
Green
Activation of DC Power.
Off
Power is off, or power error condition exists.
TX/RX
Green
The serial port is transmitting data
Amber
The serial port is receiving data.
Off No data is being transmitted or received
through the serial port.
GSM/GPRS
Green
GSM is connected.
Amber
GPRS is connected.
Off
GSM/GPRS is disconnected.
Ready
Green
Steady on: Software Ready.
Blinking slowly (1 sec):
The OnCell has been
located by the OnCell Search Utility.
Red
(Over
Green)
Steady on: Booting up, or IP fault.
Blinking rapidly (0.5 sec): IP conflict.
Blinking slowly (1 sec): Cannot get an IP
address from the DHCP server.
Off
Booting up or there is no error condition.
Signal
(3 LEDs) Green
Number of lit LEDs indicates signal level
(at least 2 LEDs must illuminated for data
transmission)
Adjustable pull high/low resistor for RS-485 Port
DIP switches on the bottom of the OnCell G3151/G3251 are used
to set the pull high/low resistor value for each serial port.
SW
1
2
3
4
Pull High
Pull Low
Terminator
---
ON
1 K
Ω
1 K
Ω
120
Ω
---
OFF
150 K
Ω
150 K
Ω
---
---
NOTE
If the pull high/low resistor on your device is already set for
RS
-485, make sure the default SW for RS-232 is “OFF”
when you switch back to RS-232 interface.
Hardware Installation Procedure
STEP 1: Open the SIM cover, and insert the SIM card in the SIM
card slot.
STEP 2: Connect the 12-48 VDC power adaptor to the OnCell
G3101/G3201 series and then plug the power adaptor into a DC
outlet.
STEP 3: To configure the OnCell, use an Ethernet cable to connect
the OnCell directly to your computer’s Ethernet interface.
STEP 4: Connect the OnCell G3101/G3201 series’s serial port to a
serial device.
– 4 – – 5 – – 6 –
www.moxa.com/support
The Americas:
+1-714-528-6777 (toll-free: 1-888-669-2872)
Europe:
+49-89-3 70 03 99-0
Asia-Pacific:
+886-2-8919-1230
China:
+86-21-5258-9955 (toll-free: 800-820-5036)
2014 Moxa Inc. All rights reserved.
DIN-Rail Mounting
The OnCell G3101 and G3201 series have
built
-
in “ears” for attaching the IP modem to a
w
all or the inside of a cabinet. We suggest using
two screws per ear to attach the IP modem to a
wall or the inside of a cabinet. The heads of the
screws should be less than 6.0 mm in diameter,
and the shafts should be less than 3.5 mm in
diameter, as shown in the figure at the right.
Software Installation Information
The Document & Software CD contains the User’s Manual, OnCell
Search Utility, and OnCell Driver Manager. Insert the CD and follow
the on-screen instructions. Please refer to the User’s Manual for
additional details on using the OnCell Search Utility and Driver
Manager.
Pin Assignments and Cable Wiring
DB9 Male Port Pinouts
Note that the OnCell G3111 and G3211 only support RS-232. The
RS-422/485 pin assignments only apply to the OnCell G3151 and
G3251.
DB9 Male
OnCell G3111/G3211 (RS-232)
Pin
RS-232
1
DCD
2
RxD
3
TxD
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
---
DB9 Male
OnCell G3151/G3251 (RS-232/422/485)
Pin
RS-232
RS-422/485-4w
RS-485-2w
1
DCD
TxD-(A)
---
2
RxD
TxD+(B)
---
3
TxD
RxD+(B)
Data+(B)
4
DTR
RxD-(A)
Data-(A)
5
GND
GND
GND
6
DSR
---
---
7
RTS
---
---
8
CTS
---
---
9
---
---
---
Specifications
Cellular Interface
Standards
GSM/GPRS
Band Options
Quad-band 850/900 and 1800/1900 MHz
GPRS Multi-slot Class
Class 10
GPRS Terminal Device
Class
Class B
GPRS Coding Schemes
CS1 to CS4
Tx Power
1 watt GSM 1800/1900, 2 watts EGSM
850/900
SIM Control
3 V
LAN Interface
Number of Ports
1 (For configuration only)
Ethernet
10/100 Mbps, RJ45 connector, Auto
MDI/MDIX
Magnetic Isolation
Protection
1.5 KV built-in
SIM Interface
Number of SIMs
1
SIM Control
3 V
Serial Interface
Number of Ports
1 or 2
Serial Standards
G31
11: 1 RS-232 port
G315
1: 1 RS-232/422/485 port
G3211:
2 RS-232 ports
G3251: 2 RS-232/422/485 ports
ESD Protection
15 KV
Power EFT/
Surge Protection
2 KV
Serial Communication Parameters
Parity
None, Even, Odd, Space, Mark
Data Bits
5, 6, 7, 8
Stop Bit(s)
1, 1.5, 2 (when parity = None)
Flow Control
RTS/CTS, XON/XOFF
Baudrate
50 bps to 921.6 Kbps
Serial Signals
RS-232
TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND
RS-422
Tx+, Tx-, Rx+, Rx-, GND
RS-485-4w
Tx+, Tx-, Rx+, Rx-, GND
RS-485-2w
Data+, Data-, GND
Management Software
OnCell Central
Manager
Centralized management solution for
accessing private IPs from the Internet
(For Software download, Please check on www.moxa.com)
Physical Characteristics
Housing
Aluminum, providing IP30 protection
Dimensions
111 x 77 x 26 mm (4.37 x 3.03 x 1.02 in)
Power Requirements
Number of
Power
Inputs
1 power jack
Input Voltage
12 to 48 VDC
Data Link
335 to 900 mA (peak) @ 12 V
Environmental Limits
Operating
Temperature
-30 to 55°C (-22 to 131°F)
Operating Humidity
5 to 95% RH
Storage Temperature
-40 to 75°C (-40 to 167°F)
Regulatory Approvals
EMC
CE Class A , FCC Class A, UL
Warranty
Warranty Period
5 years
Andere Handbücher für OnCell G3111
4
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Moxa Technologies Modem Handbücher
Moxa Technologies
Moxa Technologies OnCell G3100 Series Bedienungsanleitung
Moxa Technologies
Moxa Technologies OnCell G2151I Series Bedienungsanleitung
Moxa Technologies
Moxa Technologies oncell G2100 Series Bedienungsanleitung
Moxa Technologies
Moxa Technologies OnCell G3111 Bedienungsanleitung
Moxa Technologies
Moxa Technologies OnCell G3100 Series Bedienungsanleitung
Moxa Technologies
Moxa Technologies OnCell G3111 Bedienungsanleitung
Moxa Technologies
Moxa Technologies NPort Express Bedienungsanleitung
Beliebte Modem Handbücher anderer Marken
Davicom
Davicom DM562AP Bedienungsanleitung
EpiValley
EpiValley TATA indicom SXC-1080 Bedienungsanleitung
Zte
Zte WiMAX Bedienungsanleitung
Intelimax
Intelimax MA-2060 Bedienungsanleitung
SMC Networks
SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch
Telstra
Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung
US Robotics
US Robotics 3453C Bedienungsanleitung
MaxTech
MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung
Zte
Zte MF823 Bedienungsanleitung
Four-Faith
Four-Faith F1403 Bedienungsanleitung
Sierra Wireless
Sierra Wireless AIRLINK MP595W Bedienungsanleitung
Gemtek
Gemtek WiMAX WIXFBR-103 Bedienungsanleitung