mxr Thump Bedienungsanleitung
Thump Bass Preamp
This pedal combines the tone-sweetening magic of
the Echoplex®Preamp with a three-band EQ and
midrange frequency adjustment so that you can dial
in the perfect bass tone. Whether you need to punch
up a solo, boost your signal in a live mix, or sculpt
more edge into the sound of a passive bass, the
Thump Bass Preamp packs incredible versatility into
an MXR mini housing.
M281
jimdunlop.com/m281
™
M281 | Thump™Bass Preamp 2
1OUTPUT knob sets output level of effect
2TREBLE knob boosts or cuts high end frequencies at 4 kHz
3MID knob boosts or cuts midrange as set by FREQUENCY knob
4BASS knob boosts or cuts bass frequencies at 40 Hz
5FREQUENCY knob sets midrange frequency from 250 Hz to 1 kHz
6 FOOTSWITCH toggles effect on/bypass (blue LED indicates on)
1
24
3
5
External Controls
5
M281 | Thump™Bass Preamp 3
Basic Operation
1. Run a cable from your instrument to M281’s INPUT
jack and another cable from M281’s OUTPUT jack to your
amplifier.
2. Start with all controls at 12 o’clock.
3. Turn the effect on by depressing the footswitch.
4. Rotate OUTPUT knob clockwise to increase volume or
counterclockwise to decrease it.
5. Rotate TREBLE knob clockwise to boost high end
frequencies or counterclockwise to cut them.
6. Rotate FREQUENCY knob clockwise for a higher
midrange frequency center or counterclockwise for a
lower midrange frequency center.
7. Rotate MID knob clockwise to boost midrange
frequencies or counterclockwise to cut them.
8. Rotate BASS knob clockwise to boost low end
frequencies or counterclockwise to cut them.
The Thump™Bass Preamp is powered by the Dunlop ECB003
9-volt adapter or the DC Brick™
, Iso-Brick™
, and Mini Iso-Brick™
power supplies. This pedal cannot be powered by a battery.
Power
Directions
M281 | Thump™Bass Preamp 4
Specications
Specications at 1 kHZ
* A-weighted, all controls at mid position
Input Impedance 1 MΩ
Output Impedance 100 Ω
IMPEDANCE
TONE CONTROLS
Bass + 15/-7 dBV, 40 Hz
Mid ±16 dBV, 1 kHz
Treb ±10 dBV, 4 kHz
Freq Sweep 250 Hz to 1 kHz
Noise Floor -95 dBV
Bypass True Hardwire
Current Draw 9 mA
Power Supply 9 Volts DC
Dieses Handbuch passt für folgende Modelle
2
Andere mxr Verstärker Handbücher
