Nady Systems DKW-1 Bedienungsanleitung

Congratulations on your purchase. The Nady DKW-1 is the perfect entry level professional wireless, and delivers clear,

transparent audio for a variety of singing and speech applications. Although offered at a breakthrough new low price for a

professional wireless, this system is loaded with features:

• High-band VHF (170-216 MHz) operation for interference-free performance

•

Companding circuitry for a wide dynamic range (no overloading for loud inputs or background hiss during quiet use)

• Full frequency response from 40 –20,000 Hz

• 250 ft. typical, up to 500 ft. line-of-sight operating range

• Choice of transmitters:

• WHT-14 Handheld mic with a powerful neodymium cartridge that delivers unsurpassed audio, low handling

noise and enhanced feedback rejection

• WLT-14 Bodypack for lavalier/lapel headworn mic

• DKW-1receiver with unique vertical space-saving mini portable design and jumbo LED indicators for power ON,

transmitter ON and audio peak. Special added circuitry eliminates transmitter ON/OFF"pop" noise.

DKW-1 WIRELESS MICROPHONE SYSTEM

OPERATING INSTRUCTIONS

DKW-1 WIRELESS MICROPHONE SYSTEM

OPERATING INSTRUCTIONS

OPERATION

DKW-1

WHT-14

12 10 11

A. DKW-1 RECEIVER

1. Plug the AC/DC adapter (provided) into the 12VDC INPUT JACK (3)

on the back of the receiver. Then plug the power supply into an AC

outlet. Slide the POWER SWITCH (1) to the ON position. The

POWER ON LED (6) will now light and the receiver is operational.

2. Rotate and extend ANTENNA (7) to the full vertical position.

3. The 1/4” AUDIO OUTPUT JACK (2) provides a fixed, unbalanced

MIC level audio output for connection to your mixer with the 3 ft.

1/4” to 1/4” cord supplied. As when making any connection, make sure the

mixing board’s volume is at the minimum level before plugging in the

receiver to avoid possible sound system damage.

B. WHT-14 HANDHELD MIC TRANSMITTER

1. Unscrew the BATTERY COMPARTMENT COVER (8) and remove,

exposing the BATTERY HOLDER (11). Insert a fresh 9V BATTERY (9),

observing correct polarity as marked, and screw the cover back on to the

microphone. To ensure proper battery contact, the cover must be screwed

on completely.

2. Turn on the WHT-14 by sliding the OFF/MUTE/ON SWITCH (10)

to the MUTE position (transmitter on, audio muted) or the ON position

(transmitter and audio both on). The BATTERY INDICATOR LED (12)

will give a single quick flash, indicating usable battery strength. In the case of

a dead or low battery, the LED will either not go on at all or will stay on

continuously, indicating that the battery should be replaced with a fresh one.

3. The microphone is now ready to use. The TRANSMITTER SIGNAL

RECEIVED LED (5) on the DKW-1 receiver should now be lit. When ready

to speak, slide the transmitter switch to the ON position and adjust the mixing

board volume level as needed. The AUDIO PEAK LED (4) will flicker on the

receiver with the audio peaks of the microphone input. This is normal. If the

indicator lights continuously, it means the signal is too loud and there is the

possibility of overload distortion. Back off from the microphone until the

indicator only flickers on peaks.

[Note: Observe care in selecting P.A. volume,

transmitter location and speaker placement so that acoustic feedback (howling

or screeching) will be avoided. See also Section C 3 below.]

(U.S.) Should your Nady DKW-1 Wireless Microphone System require service, please contact the Nady Customer Service

Department via telephone: (510) 652-2411 or e-mail: ser[email protected].

(INTERNATIONAL) For service, please contact the Nady distributor in your country through the dealer from whom you

purchased this product.

The warranty card supplied with this system provides valuable warranty and service information. Store it in a safe place

for future reference. Do not attempt to service this unit yourself as it will void your warranty.

C. WLT-14 LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER

1. Snap open the BATTERY COMPARTMENT (13) and insert a fresh 9V BATTERY (14), observing the correct polarity.

Close the compartment.

2. The WLT-14 is provided with a 3.5mm LOCKING JACK (18) for connecting the microphone. Plug in either the

LAVALIER/LAPEL (19) or the HEADWORN MICROPHONE, as supplied. To secure the connection, turn the metal slip

ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process. Slip the transmit

ter into a pocket or clip on to your clothes. To use the lavalier mic, attach it at chest level. Do not place too close to

the mouth—a distance of about six inches usually works best. To use the headworn mic, place it on the head and

adjust the mic boom so that the mic is about one inch to the side of the front of the mouth. (

Note: the lavalier or

headworn mic wire is also the transmit antenna, and rolling up or shortening the wire may reduce the effective

operating range. Extend the wire fully during use, and keep it as straight as possible.)

3. Turn on the WLT-14 by sliding the OFF/MUTE/ON SWITCH (15) to the MUTE position (transmitter on, audio

muted) or the ON position (transmitter and audio both on). The BATTERY INDICATOR LED (16) will give a single

quick flash, indicating usable battery strength. In the case of a dead or low battery, the LED either will not go on at

all or will stay on continuously, indicating that the battery should be replaced with a fresh one.

4. The microphone is now ready to use. The TRANSMITTER SIGNAL RECEIVED LED (5) on the DKW-1 receiver should

now be lit. When ready to speak, slide the transmitter switch to the ON position and adjust the mixing board volume

level as needed.

[Note: Observe care in selecting P.A. volume, transmitter location and speaker placement so that

acoustic feedback (howling and screeching) will be avoided. Please also observe the pickup patterns of the

microphone selected: omnidirectional mics pick up sound equally from all directions and are prone to feedback if

not used carefully. Unidirectional mics are more resistant to feedback, but pick up sound sources best that are

directly in front of the mic. Also, mics that are farther from the sound source, such as lavaliers, require more

acoustic gain and thus are also more prone to feedback than close-source mics such as handheld or headworn mics

that are used close to the mouth.]

5. For optimum performance, an AUDIO INPUT LEVEL CONTROL (17) is provided. Adjust the microphone gain with a

small slot-head screwdriver. Set for maximum possible gain without noticeable distortion on the high level peaks.

Turning the trim control clockwise increases the audio level; turning it counterclockwise decreases the audio level.

Experiment for the best sound for your application. The AUDIO PEAK LED (4) will flicker on the receiver with audio

peaks on the microphone input. This is normal. If the indicator lights continuously, it means the signal is too loud and

there is the possibility of overload distortion. Re-position the microphone farther from the source or adjust the AUDIO

INPUT LEVEL CONTROL (17) until the indicator flickers only on the loudest inputs.

SERVICE

15 16

Nady Systems, Inc.

6701 Shellmound Street

Emeryville, CA 94608

www.nadywireless.com

WLT-14

Opening Battery Compartment

Inhaltsverzeichnis

Andere Nady Systems Mikrofonsystem Handbücher

Nady Systems

Nady Systems Encore I Bedienungsanleitung

Nady Systems

Nady Systems W-1KU Bedienungsanleitung

Nady Systems

Nady Systems Personal in Ear Monitor E03 Bedienungsanleitung

Nady Systems

Nady Systems 151 VR Bedienungsanleitung

Nady Systems

Nady Systems VR-3U Bedienungsanleitung

Nady Systems

Nady Systems DKW-3 Bedienungsanleitung

Nady Systems

Nady Systems PEM-500 Bedienungsanleitung

Nady Systems

Nady Systems DigiTRU Diversity UHF-3 Bedienungsanleitung

Nady Systems

Nady Systems UHF-3 Bedienungsanleitung

Nady Systems

Nady Systems UHF-16 Bedienungsanleitung

Nady Systems

Nady Systems UB-10 Bedienungsanleitung

Nady Systems

Nady Systems IRW-220X Bedienungsanleitung

Nady Systems

Nady Systems DKW-8U Bedienungsanleitung

Nady Systems

Nady Systems DKW Duo Bedienungsanleitung

Nady Systems

Nady Systems U-1100 Bedienungsanleitung

Nady Systems

Nady Systems U-800 Bedienungsanleitung

Nady Systems

Nady Systems AMERICAN STARPOWER X2 Bedienungsanleitung

Nady Systems

Nady Systems OCTAVO U-81 Bedienungsanleitung

Nady Systems

Nady Systems 4W-1KU Bedienungsanleitung

Nady Systems

Nady Systems IRW-220X HT/LT/O - Nady Ir Wireless System Bedienungsanleitung

Nady Systems

Nady Systems DKW-3 HT Bedienungsanleitung

Nady Systems

Nady Systems ENCORE 200 Bedienungsanleitung

Nady Systems

Nady Systems UWS-100 Bedienungsanleitung

Nady Systems

Nady Systems 9E3W1KUH Bedienungsanleitung

Beliebte Mikrofonsystem Handbücher anderer Marken

Paso

Paso R824 Bedienungsanleitung

Naxa

Naxa NAM-982 Bedienungsanleitung

Motorola

Motorola PMNN4461 Bedienungsanleitung

Xvive

Xvive U3 Bedienungsanleitung

Tekon

Tekon DUOS Bedienungsanleitung

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Bedienungsanleitung

Devine

Devine WMD-IE Bedienungsanleitung

LG LF-D7150 Bedienungsanleitung

GE S768DAV Bedienungsanleitung

LD U305 HBH 2 Bedienungsanleitung

Chainway

Chainway URA8 Bedienungsanleitung

ORATOR

ORATOR D860TD Bedienungsanleitung

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Bedienungsanleitung

Alpha Technologies

Alpha Technologies RBMS Bedienungsanleitung

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Bedienungsanleitung

Shure

Shure UA844 Bedienungsanleitung

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Bedienungsanleitung

Pyle

Pyle PDWM5000 Bedienungsanleitung