Napoleon Tabletop Patio Heater Bedienungsanleitung

Tabletop Patio

Heater

Owner’s Manual

Standard: ANSI Z83.26-2007 / CSA 2.37-2007



ANSI Z83.26a-2008 / CSA 2.37a-2008

Gas-Fired Outdoor Infrared Patio Heaters.

Questions, problems, missing / replacement parts? Before returning to your retailer,

call our customer service department at 1-866-814-0585, 8 a.m.-5 p.m., EST,

Monday-Friday.

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. If odor continues, keep away from

the appliance and immediately call

your gas supplier or fire department.

Do not store or use gasoline or

other flammable vapors and liquids

in the vicinity of this or any other

appliance.

An LP-cylinder not connected for use

shall not be stored in the vicinity of

this or any other appliance.

DANGER

WARNING

For Outdoor Use Only.

CAUTION:

Installer: Leave the manual instructions

to the user for future use.

Consumer: Please keep this manual

for future reference.

Read the instructions before use.

This appliance must be installed in

accordance with such regulations as

are in force.

Model#: SRPT03-XXXX

02/25/2011

This appliance can produce carbon monoxide

which has no odor.

Using it in an enclosed space can kill you.

Never use this appliance in an enclosed space such

as a camper, tent or home.

DANGER CARBON MONOXIDE HAZARD

WARNING:

Improper installation, adjustment, alteration, services or maintenance can cause injury,

death or property damage. Read the installation, operating and maintenance instructions

thoroughly before installing or servicing this equipment.

PRECAUTIONS

SPECIFICATION

Certification CSA

Rated Heat Input

Fuel

Gas Supply

Manifold Pressure

Injector Size(diameter)

10000BTU/hr

LPG

16.4oz LP-Gas cylinder

11.0" W.C.

0.91mm

Safety Features Flame failure device, anti-tilt switch & Oxygen

Depletion Safety (ODS) pilot

Gas Supply Pressure Max 250PSI, min 5PSI

PRECAUTIONS

The installation must conform with local codes

or, in the absence of local codes, with the

National Fuel Gas Code, ANSI Z223.1/NFPA54,

NFPA58 Natural Gas and Propane Installation

Code, CSA B149.1, or Propane Storage and

Handling Code, B149.2

The heater, when installed, must be electrically

grounded in accordance with local codes or, in

the absence of local codes, with the National

Electrical Code, ANSI/NFPA70, or the Canadian

Electrical Code, CSA C22.1.

Children and adults should be alerted to

the hazards of high surface temperatures

and should stay away to avoid burns or

clothing ignition.

Young children should be carefully

supervised when they are in the area of

the heater.

Clothing or other flammable materials

should not be hung from the heater, or

placed on or near the heater.

Prior to use, check for damaged parts such as

tube, regulator, pilot or burner.

All leak tests should be done with a soapy solu-

tion. NEVER USE AN OPEN FLAME TO

CHECK FOR LEAKAGE.

Installation and repair should be done by

a qualified service person. The heater

should be inspected before use and at

least annually by a qualified service

person.

More frequent cleaning may be required

as necessary. It is imperative that control

compartment, burners and circulating air

passageways of the heater be kept clean.

Keeping the appliance area clear and free from

combustible materials, gasoline and other flam-

mable vapors and liquids.

Not obstructing the flow of combustion and venti-

lation air.

Keeping the ventilation opening(s) of the cylin-

der enclosure free and clear from debris.

This appliance shall be used only in a well-

ventilated space and shall not be used in a build-

ing, garage or any other enclosed area.

An appliance may be installed with shelter no

more inclusive than:

With walls on all sides, but with no overhead

cover.

Within a partial enclosure which includes an

overhead cover and no more than two side

walls. These side walls may be parallel, as in a

breezeway, or at right angles to each other.

NOTE:PLEASE READ THE FOLLOWING SAFETY RULES

WARNING:

Any guard or other protective device

removed for servicing the heater must be

replaced prior to operating the heater.

PRECAUTIONS

Within a partial enclosure which includes an

overhead cover and three side walls, as long as

30 percent or more of the horizontal periphery of

the enclosure is permanently open.

This appliance requires 16.4oz (1lb) LP_gas

supply cylinder.

The LP-gas supply cylinder to be used must be:

Constructed and marked in accordance with the

Specifications for LP-gas cylinders of the U.S.

Department of Transportation (DOT); or the

Standard for Cylinders, Spheres and Tubes for

Transportation of Dangerous Goods and Com-

mission, CAN/CSA-B339, as applicable;

Provided with a listed overfilling prevention

device; and provided with a cylinder connection

device compatible with the connection for the

appliance.

The cylinder be disconnected when the appli-

ance is not is use.

Storage of an appliance indoors is permissible

only if the cylinder is disconnected and removed

from the appliance.

A cylinder must be stored outdoors in a well-

ventilated area out of the reach of children. A

disconnected cylinder must have dust caps

tightly installed and must not be stored in a build-

ing, garage or any other enclosed area.

Do not store a spare LP-gas cylinder under or

near this appliance;

Never fill the cylinder beyond 80 percent full;

Do not clean the heater with cleaners that are

combustible or corrosive.

NOTE:PLEASE READ THE FOLLOWING SAFETY RULES

WARNING:

Place the dust cap on the cylinder valve outlet

whenever the cylinder is not in use. Only install

the type of dust cap on the cylinder valve that is

provided with the cylinder valve. Other types of

caps or plugs may result in leakage of propane.

35(&$87,216

WARNINGS AND CAUTIONS

This heater is designed to operate with a standard 1 Ib propane cylinder with Approved Cylinder

Connection.

NOTE: PLEASE READ THE FOLLOWING SAFETY RULES:

TOOLS NEEDED: (NOT INCLUDED)

Adjustable open end wrench

Philips screwdriver

Estimated time for assembly: 15 minutes.

PREPARATION

Before beginning assembly of product, make sure all parts are present. If any part is missing or

damaged, do not attempt to assemble the product. Contact customer service for replacement parts.

Perform a leak test with a soapy solution:

1. To check gas connections.

2. After connecting a new cylinder.

3. Upon re-assembly after disassembly.

PARTS LIST

Please check the contents of the packaging as to whether anything is missing!

The fastenersused comply with ANSI/BL.1

1 Base

1 Housing

1 Burner Column

2 Emitter Screen Shield

1 Emitter Screen

1 Reflector Dome

1 Dome Cap

1 Decorative Dome Cap Nut

7 M4 x 8 Bolts

7 M4 x 6 Bolts

3 M6 Nuts

6 6mm Washers

1 Regulator

11 12

Step 1

Step 2

ASSEMBLY

WARNING : ONLY AN AUTHORIZED GAS TECHNICIAN SHOULD INSTALL THIS PRODUCT.

Step 2

Insert the three clamps of the burner column (3)

into the three spring pieces of the housing (2)

per the picture and screw over. Make sure the

clamp and the spring piece fit together.

Step 1

Attach housing (2) to base (1) using seven

M4 x 6 bolts (10).

Hardware Used

10 M4 x 6 bolt X 7

Step 4

ASSEMBLY

Step 3

Attach emitter screen (5) to burner column (3)

using three M4 x 8 bolts (9)

Note: The ignition hole on emitter screen must

line to the control knob.

Step 4

Attach reflector dome (6) to emitter screen (5)

using six 6mm washers (12) and three M6 nuts

(11).

Then attach dome cap (7) and decorative dome

cap nut (8) to reflector dome (6).

Hardware Used

X 3

X 6

Hardware Used

9M4 x 8 bolt

3M6 nut

6mm Washer

Step 2

Ignition

Hole

ODS Hole

ASSEMBLY

Step 5

Step 6

Step 5

Attach emitter screen shield (4) to burner

column (3) using four M4 x 8 bolts (9).

Step 6

Open the access door. Open up the gas bottle

cover. Attach it to the regulator.

Aim at the screw thread. Turn counter clockwise

and tighten.

Hardware Used

9M4 x 8 bolt X 4

Regulator

Gas bottle

Tighten

SAFETY CHECK

Check for leak

Your patio heater has been checked at all factory

connections for leakage. To check the connections

at the tube/regulator/cylinder.

1) Make leakage solution by mixing 1 part liquid

dish soap and 3 parts water.

2) Spoon several drops (or use squirt bottle) of the

solution onto the tube/regulator/cylinder

connections.

3) Inspect the connections and look for bubbles.

4) If no bubble appears, the connection is safe.

5) If bubble appears, there is leak; loosen and

re-tighten this connection. If still leak, please

call customer service: 1-888-831-1899.

Disconnected cylinder when storage or

transportation

1) Turn the knob at “OFF” position.

2) Open the access door, turn clockwise to

disconnect cylinder from regulator.

Regulator & cylinder

connection

Tube & regulator

connection

Inhaltsverzeichnis

Andere Napoleon Terrassenheizung Handbücher

Napoleon

Napoleon PATIOFLAME GPFR40 Bedienungsanleitung

Napoleon

Napoleon PTHC38PK Bedienungsanleitung

Napoleon

Napoleon PTH31GT Bedienungsanleitung

Napoleon

Napoleon PTH31GT Bedienungsanleitung

Napoleon

Napoleon PATIOFLAME HAMP2 Bedienungsanleitung

Napoleon

Napoleon SRPH02S Bedienungsanleitung

Napoleon

Napoleon PTHC38PK Bedienungsanleitung

Napoleon

Napoleon PATIOFLAME GPFS40 Bedienungsanleitung

Napoleon

Napoleon Patioflame Bedienungsanleitung

Napoleon

Napoleon PTH10PSS Bedienungsanleitung

Napoleon

Napoleon SkyFire Bellagio PTH31GTSS Bedienungsanleitung

Napoleon

Napoleon PTH31GT Bedienungsanleitung

Napoleon

Napoleon BELLAGIO PTH31GTSSP Bedienungsanleitung

Napoleon

Napoleon PTH31GT Bedienungsanleitung

Napoleon

Napoleon SRPH02-XXXX Bedienungsanleitung

Napoleon

Napoleon PTH55PSS-1 Betriebsanleitung

Napoleon

Napoleon PTH40PGM Bedienungsanleitung

Napoleon

Napoleon PTH-103-3G Handbuch

Napoleon

Napoleon TERRACE AND PATIO HEATER Betriebsanleitung

Napoleon

Napoleon PTH38PSS, PTH38PCP, PTH38PGM Bedienungsanleitung

Beliebte Terrassenheizung Handbücher anderer Marken

empasa

empasa HMXD-E-NHS Bedienungsanleitung

Sunred

Sunred Indus Bedienungsanleitung

HEAT1

HEAT1 ECO pro-line 2300W Bedienungsanleitung

Heatmaxx

Heatmaxx SRPH98 Bedienungsanleitung

Sunjoy

Sunjoy A30600640 Bedienungsanleitung

Event Furniture

Event Furniture 16091 Fehlerbehebungshandbuch

Prem-I-Air

Prem-I-Air EH1462 Bedienungsanleitung

Blumfeldt

Blumfeldt 10028637 Bedienungsanleitung

Sunjoy

Sunjoy L-PH011PSS-2 Bedienungsanleitung

Melissa

Melissa 670-202 Bedienungsanleitung

Quality Heating

Quality Heating THE-12DW Bedienungsanleitung

DCS

DCS PHFS-P4 Installationsanleitung

EUROM

EUROM 334241 Bedienungsanleitung

Lava Heat

Lava Heat Venetian Bedienungsanleitung

EHS Ltd.

EHS Ltd. HQH-2000W Bedienungsanleitung

VONROC

VONROC ALICUDI PH515AC Bedienungsanleitung

OZONA

OZONA Heatflow IF010997 Bedienungs- und Wartungshandbuch

theBBQshop

theBBQshop 51611010 Einrichtungshandbuch