National Cycle N5113 Montageanleitung
INSTALLATION AND OWNER’S MANUAL
Wing Deflectors, Fairing Mount 5113 and 5114
for 2012 HO DA GL1800 and GL1800 AB
©2011 National Cycle, Inc. PO Box 158, aywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e-mail: info@nationalcycle.com
Page 1 of 4 10-117840-000 08 /11
PARTS LIST
Item Part umber Description Qty. ote
1 Wing Deflector, Dark Tint, Upper 2 Contained in N5113
2 Wing Deflector, Dark Tint, Left, Lower 1 Contained in N5113
3 Wing Deflector, Dark Tint, Right, Lower 1 Contained in N5113
1 Wing Deflector, Light Tint, Upper 2 Contained in N5114
2 Wing Deflector, Light Tint, LH Lower 1 Contained in N5114
3 Wing Deflector, Light Tint, RH Lower 1 Contained in N5114
4 Bracket, Left 1
5 Bracket, Right 1
6 Drill Bit 1 Used in Installation
10-117841-000 Template, Left and Right Side 1 Center hole scale marked
BAG#1065
7 55-585020-000 Screw, 4-20 x 1/4” 13
8 49-490080-000 Washer 3 13
9 75-762015-000 Washer, Neoprene 12
10 34-340266-000 Stand-off 4
11 51-516000-000 Screw, 10-32 x 3/8” 4
12 75-766086-000 Circle, ylar 6
32
1
Attention ote
Special otes a d cautio ary measures
which ca preve t damage to the accessory
or motorcycle.
Tips for facilitatio of operatio , co trol
a d adjustme t, as well as mai te a ce.
Tha k you for purchasi g a Natio al Cycle® product. Please read these i structio s carefully a d thoroughly
before begi i g work. Dealers if i stalli g this product for a customer please give them this ma ual. It co -
tai s i formatio eeded to properly mai tai a d use this product.
Report any missing parts directly to ational Cycle, Inc. There is important code information located on the
back of the package that will be necessary when reporting missing parts.
10x4
11x4
8x13
9x12
12x6
7x13
Right and Left side of Motorcycle is
determined while sitting on the bike.
• 5mm Hex Key Wrench
• 1/2” Socket and Torque Wrench
• Thread Locker (Loctite 271® or equivalent)
• Scissor
• Tape
• Drill Press or Hand Drill, Not Shown
• Flat Piece of Wood (for use when drilling)
• 1/8” Hex Key Wrench
• #1 Phillips Screw Driver
6
4
5
PREPARATIO A D DRILLI G OF TRIM STRIP
1. Position motorcycle securely on center stand or side stand.
2. Carefully remove Left side trim piece located at position (a).
Start at the bottom of strip, pull strip from the inside edge towards
the outside of the fairing gently lifting as you pull. As the bottom
edge is released, work your way upward taking care not to break
the retaining tabs. Figure 1
3. Remove Screws (b) (5mm Hex Key). Figure 1
4. Apply a small amount of Thread Lock to the threaded side of the
Standoffs, item 10. Replace the screws removed in Step 3 with
these threaded fasteners. Tighten securely. 4 ft/lb (5.4 m) (1/2”
Socket, Thread Locker) Figure 2
5. Cut the Left Template from Template page. Snip at tab, area (c).
(Scissors) Figure 3
6. With markings on Template facing up, align Template between
notches on inside of trim strip. Tape Template into position. (Tape)
Figure 3
Before you drill, check position of template by holding
trim piece into position on the Left side of motorcycle.
7. ake a pilot mark on strip at center of cross marks. (Drill Bit
Provided) Figure 4
8. Carefully drill each hole using a slow speed. A drill press is pre-
ferred, however a hand drill can be used. Place the trim strip on a
clean flat piece of wood for support while drilling. Use caution as
required by the use of power equipment. Remove the paper tem-
plate. (Drill Bit Provided and Drill) Figure 5
9. Repeat procedure on Right side of motorcycle.
©2011 National Cycle, Inc. PO Box 158, aywood, IL 60153-0158 USA
Page 2 of 4 10-17840-000 08/11
Figure 1
Figure 4
Figure 5
Figure 2
Figure 3
a
b
b
RL
c
c
c
c
©2011 National Cycle, Inc. PO Box 158, aywood, IL 60153-0158 USA
Page 3 of 4 10-117840-000 08/11
I STALLATIO OF BRACKET and WI G DEFLECTORS
1. Replace the trim strips to the fairing working opposite of the way
they were removed. Starting at the top push the top edge of the
trim strip into the slot and work the outside edges strip into the
notches and gently push in the back edges. Work your way down
to the bottom of the trim strip. Holes in trim should align with
standoffs. Figure 6.
Figures 7, 8 and 9 are not photographed on the 2012
model, however installation remains the same.
2. Install Right Bracket with 3/8” Screws. (1/8” Hex Key) Figure 7
3. Position Swivel Ratchet so studs face toward rider. Figure 7
4. Install Neoprene Washers on studs. Figure 8
5. Use a Washer and a 1/4” Screw to attach Upper and Lower
Deflectors to Swivel Ratchet. (Phillips Screw Driver) Figure 9
6. Tighten Screws firmly, do not over-tighten. (Phillips Screw
Driver) 6 in/lb (.7 m)
7. Repeat procedure on Left side of motorcycle.
Figure 8
Figure 6
Figure 7
Figure 9 Installed view includes N5108 irror Deflector
©2011 National Cycle, Inc. PO Box 158, aywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e-mail: info@nationalcycle.com
Page 4 of 4 10-117840-000 08/11
Never ride yo r motorcycle with loose accessory mo nting hardware. Check the hardware for tightness reg larly.
Today’s motorcycles are b ilt with eno gh frame rigidity to withstand the moderate loads imposed on them by the foreseeable addition of an
accessory. If the accessory(ies) adversely affects yo r motorcycle’s stability, immediately remove the accessory(ies). Do not ride a motorcycle
that exhibits nsafe handling traits.
Have experienced service personnel correct any problem before riding with the accessory(ies) installed. For f rther q estions concerning han-
dling problems associated with an accessory(ies), contact yo r dealer, motorcycle man fact rer, or accessory man fact rer.
MAI TE A CE
Cleaning: Wash with a clean soft cloth, plenty of warm water
and, if necessary, a non-abrasive soap such as dishwashing Do
not allow brake fluid, alcohol, or strong solvents to contact the
plastic. National Cycle Windshield Wash Part number N1401-01
is recommended for everyday cleaning. Product is supplied with
a handy travel size container and rag for easy storage on the
motorcycle. Inquire with your local dealer or visit:
www.nationalcycle.com
Figure 10
CHECK CLEARA CES
1. Refer to USING YOUR WING DEFLECTORS below and, if
desired, place the mylar disks over the contact points on the
fairing where the deflectors touch. Figure 10
Gently turn handle bar left and right to full fork lock to
assure that no interference occurs between the Wing
Deflector and any part of the motorcycle or other accessory
mounted to the motorcycle. Make adjustments or remove
accessory as necessary.
USI G YOUR WI G DEFLECTORS™
1. Cool Air Relief
In moderate to hot weather open deflectors for desired air flow.
Closing lower deflector in hot weather can help deflect hot air
from the radiator away.
2. Warm Air Comfort
In cold and or wet weather close deflectors up to fairing for max-
imum wind and rain deflection. Opening the lower deflector in
cool weather can help pull in hot air from the radiator.
3. For ultimate performance use Wing Deflectors™ in conjunc-
tion with our irror ount Deflectors and VStream® windshield.
ational Cycle 3-Year Limited Warranty
Register your Wing Deflectors on Line at: www.nationalcycle.com/register.html
Customer Service, ational Cycle, Inc. / PO Box 158 / Maywood, IL 60153 / USA 708/343/0400
National Cycle hereby warrants to the original registered owner of a National Cycle polycarbonate product for a
period of three years from the date of purchase against breakage. This limited warranty is expressly limited to
the replacement of the polycarbonate deflectors. This limited warranty does not include scratches, coating fail-
ure, cosmetic wear and tear, replacement of hardware, or any consequential damages or expenses including labor cost of installa-
tion, removal and/or replacement, inconvenience, inbound freight expenses or damage to any other component of the motorcycle or
any other accessories. Certain chemicals, generally known as acidic hydrocarbons, are known to cause polycarbonate damage and
will not be covered under this limited warranty. Please refer to the cleaning instructions supplied.
Dieses Handbuch passt für folgende Modelle
1
Andere National Cycle Motorradzubehör Handbücher
National Cycle
National Cycle Quantum hardcoated N30214-WK Kurzanleitung
National Cycle
National Cycle SwitchBlade Deflector UQ01 Bedienungsanleitung
National Cycle
National Cycle ZTechnik VStream Bedienungsanleitung
National Cycle
National Cycle KIT-JL Bedienungsanleitung
National Cycle
National Cycle VStream N20124 Bedienungsanleitung
National Cycle
National Cycle ZTechnik VStream Z2497 Service-Handbuch
National Cycle
National Cycle N20331 Bedienungsanleitung
National Cycle
National Cycle JE Montageanleitung
National Cycle
National Cycle Paladin P4008 Montageanleitung
National Cycle
National Cycle Quantum VStream N20340 Bedienungsanleitung
National Cycle
National Cycle Spartan N21202 Bedienungsanleitung
National Cycle
National Cycle VStream N20014 Montageanleitung
National Cycle
National Cycle Paladin P4306 Montageanleitung
National Cycle
National Cycle Quantum Wash'n'Wipe N30003 Kurzanleitung
National Cycle
National Cycle N2594 Montageanleitung
National Cycle
National Cycle Quantum N50001 Montageanleitung
National Cycle
National Cycle ZTechnik VStream Z2392 Bedienungsanleitung
National Cycle
National Cycle ZTechnik VStream R1200RS Bedienungsanleitung
National Cycle
National Cycle VStream+ N20133 Service-Handbuch
National Cycle
National Cycle N941 Montageanleitung
Beliebte Motorradzubehör Handbücher anderer Marken
SRC
SRC B-TRK502-01-01-SL Bedienungsanleitung
3M
3M Speedglas 9100 MP Bedienungsanleitung
hepco & becker
hepco & becker 6307520 00 01 Bedienungsanleitung
HOMCOM
HOMCOM AA0-077 Bedienungsanleitung
hepco & becker
hepco & becker 6307558 00 01 Bedienungsanleitung
Wunderkind Custom
Wunderkind Custom 106503-F15 Benutzerhandbuch
