6Ozonode Home Ozone Generator User Manual
Ozone generator 1pc
Power adaptor 1pc
Male luer lock 2 pc
Oxygen tube 2 meters
User manual 1pc
Protocol manual 1pc
Caution: The ozone generator requires an oxygen supply (for example, an oxygen cylinder or
oxygen concentrator) to work.
Tips for using the ozone generator
Place the ozone generator on a at dry
surface where it can be kept away from
water and heat.
Plug the generator into the power. Choose
the L1 switch and allow a ve-minute warm
up before connecting to an oxygen supply.
When making ozonated water or ozonated oil
you can always connect any unused ozone
back to the inbuilt ozone destruct via the
ozone destruct port to avoid inadvertently
breathing in ozone that would otherwise off
gas into the room.
To set up your oxygen cylinder
Slide the regulator over the stem so the holes
line up correctly.
Hold the regulator in place and turn the metal
handle to secure the regulator to the cylinder
stem. Use a wrench to secure on tightly.
Once the regulator is securely fastened,
open the cylinder valve and verify there are
no leaks. You can open the regulator by
turning the click-knob on the end. Remember
to close the valve after conrmation.
Connect the oxygen tube to the regulator barb.
The other end of the oxygen tube can then
be inserted into the back of the ozone
machine via the oxygen inlet nozzle.
Set the gas ow rate of the oxygen regulator
and open the cylinder valve.
You are now ready to create medical ozone
gas by simply choosing the appropriate
ozone level button. The chart on the unit will
help you determine the right oxygen ow rate
and ozone concentration for the protocol you
wish to administer.
Ready to get started?
Remove all the pieces from their packaging and ensure the following are present.
setup
