NEC SL1000 Installationsanleitung
-Technical Training -
(System Installation)
Next Topaz
Part 1 : Hardware Installation
NEC Confidential
© NEC Corporation 2009
Page 3
Important Notice
To avoid shock or damage, do not plug in or turn the system on before completing the
installation process. <No Power-ON Maintenance>
Avoid working with the KSU during electrical storms.
Use only commercial AC Power to prevent shock or fire.
Use the power cord supplied for the KSU.
Do NOT bundle AC Power cords together, the cords may over heat.
Make sure the KSU has proper Earth Ground.
The system should be “Wall-Mounting” only.
A dedicated 110/240VAC circuit located within 2 meters of the KSU is required. A
separate AC outlet is necessary for each KSU.
Meeting established environmental standards maximizes the life of the system.
Be sure the site is NOT :
In direct sunlight or in hot, cold or humid places.
In dusty areas or in areas where sulfuric gases are produced.
In places where shocks or vibrations are frequent or strong.
In places where water or other fluids comes in contact with the equipment.
In areas near high-frequency machines or electric welders.
Near computers, telexes, microwaves, air conditioners, etc.
Near radio antennas (including short-wave)
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 4
Wall Mounting (1)
The Main KSU (1632M-A)and Expansion KSU s (1632ME-A)must be mounted
onto the wall. Before installing, secure appropriate spacing as below.
KSU Wall Mounting (arrange lengthways)
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 5
Wall Mounting (2)
KSU Wall Mounting (arrange sideways)
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 6
Appendix : Notice for No.4 KSU
Any trunk (Analog, ISDN BRI/PRI) does NOT work.
Power Failure circuits are not available because of no trunks support.
Multi-Line Terminals, SLTs and DSS Consoles work but Door phone and Relay do NOT work.
Due to the cable length limitation, installation position of No.4 KSU must be careful.
No.4 KSU (No.3 Expansion KSU) has following limitations.
Main KSU
(1632M KSU)
No.1 Exp KSU
(1632ME KSU)
No.2 Exp KSU
(1632ME KSU)
No.3 Exp KSU
(1632ME KSU)
Cable length is
not enough!!
Main KSU
(1632M KSU)
No.1 Exp KSU
(1632ME KSU)
No.2 Exp KSU
(1632ME KSU)
No.3 Exp KSU
(1632ME KSU)
Expansion cable is special design and can NOT be extended by yourself to avoid any transmission error.
Newly
added
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 7
Grounding
•The “ETH” lug is located near Power supply unit on each KSU.
•Connect “ ETH” lug to the verified Earth Ground point by using 14AWG (2.0mm) wire.
KSU Grounding
Grounding must be done each KSU respectively.
Grounding is required not only for system protection
but also for Caller-ID detection.
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 8
Power Failure Transfer
•SLT is connected to the Extension Port No. 8/16/24/32.
•Change the switch position of “J6” from “KT” to “PF”. (Default : KT)
Connected extension must be SLT.
Trunk Port Ext. Port
No. 1No. 8
No. 4No. 16
No. 7No. 24
All terminals on Slot No.4must be Analog
Terminals.
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 9
Cabling (1)
•Each I/F card provides “RJ11” connectors.
•One “RJ11”connector is provided each Trunk and Extension port.
DO NOT wire the cable with an AC Cable, computer, etc.
DO NOT run the cable near the high frequency generating device.
Use cable protectors in case the cables are run on the floor.
Aerial distribution wiring is NOT allowed.
Trunks must be installed with Lightning Arresters.
T R
L H
T R
Modular Plug
Trunk Extension
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
NEC Confidential
© NEC Corporation 2009
Page 10
Cabling (2)
Modular Cable
(4-wire, Straight)
T R
L H T R
L H
Modular Cable
(2-wire, Straight)
Key Telephone DSS Console SLT
Key TEL / DSS Console wiring have “Polarity”.
SLT wiring does not have “Polarity”.
บริษัท โปรเฟสชั�นแนล พีเอบีเอ็กซ์ จํากัด โทร. 02-519-1718 Hotline. 084-920-5065
Andere Handbücher für SL1000
14
Inhaltsverzeichnis
Andere NEC Telefonsystem Handbücher
NEC
NEC ELECTRA ELITE IPK II Bedienungsanleitung
NEC
NEC Univerge SV9100 Bedienungsanleitung
NEC
NEC DSX Montageanleitung
NEC
NEC Electra Elite DSS Bedienungsanleitung
NEC
NEC DSX-40 DEMO KIT Bedienungsanleitung
NEC
NEC DSX-160 Bedienungsanleitung
NEC
NEC Nitsuko 32i Bedienungsanleitung
NEC
NEC UNIVERGE SL2100 Bedienungsanleitung
NEC
NEC DSX Bedienungsanleitung
NEC
NEC SL1100 Bedienungsanleitung
NEC
NEC SL1100 Bedienungsanleitung
NEC
NEC DSX INTRAMAIL FEATURE Bedienungsanleitung
NEC
NEC 1090030 - DSX Systems PHONE SuperDisp Phone... Bedienungsanleitung
NEC
NEC Xen Topaz Benutzerhandbuch
NEC
NEC NEAX 2000IVS2 Bedienungsanleitung
NEC
NEC Univerge SV8100 Bedienungsanleitung
NEC
NEC SL1000 Betriebsanleitung
NEC
NEC ELECTRA ELITE IPK II Handbuch
NEC
NEC SL1100 Betriebsanleitung
NEC
NEC NEAX 2000 IVS Montageanleitung
