neo-tools.com neo-tools.com
8
• Insert 3 new AA batteries, observe correct polarity indicated on the battery lid with +/- symbols.
• Close the battery lid, make sure the latch snaps in place.
"Pulse" feature changes laser beam frequency, using it is recommended in sunlight. Depending on ambient
conditions (light intensity, colour and roughness of the surface the laser is projected to), this feature on or o may
improve laser visibility.
• In order to attach the cross line laser to the magnetic holder, drive the threaded pin (2) into stand thread in the
laser base, use the wheel (1).
• The wheel (1) allows to set the cross line laser to the right or le.
• The knob (3) allows to set the cross line laser up or down.
• The magnets (4) allow to attach the stand to metal surfaces.
• The holder is equipped with stand threads ¼" (5) and 3/8" (6).
The laser oers self-levelling feature. The feature is operational within ±4° of the laser tilt.
• Switch the laser on, slide the self-levelling lock switch (1) to unlocked position.
• When the laser angle does not allow the self levelling feature to work (greater than 4°), the laser will signal the
problem by intermittent sound, laser ashing and battery level indicator diode ashing.
• Set up the laser so it does not signal incorrect position, only then it will be possible to set vertical and horizontal
line.
• Press the feature toggle button (2) to toggle between showing horizontal line, vertical line and both.
• Line visibility can be improved with the "Pulse" feature. To switch this feature on, press the button (3).
• To switch the laser o, slide the self-levelling lock switch (1) to locked position.
The laser lock feature allows to project straight lines at any chosen angle.
• Leave the lock switch (1) in locked position.
• Press the Pulse button (3) to switch the laser on.
• Press the Pulse button (3) again to toggle between showing horizontal line, vertical line, both lines and
switching the device o.
KREUZLASER
75-101
