
www.nerotapware.com.au
3. Slide both top and bottom back plate onto
the rail assembly, as shown on the picture.
2. Screw the adapter onto the outlet.
Push wall plug into drilled hole. Fit
lower mounting pillar in place with
screw. Tighten firmly.
1.Drill a φ6mm hole at the downwards
outlet verticaldownward position
in the recomendation range.
500-600(recomendation)
6
outlet
4. Push shower rail assembly onto
the wall/tile face.
Tighten grub screws firmly.
Slide the back plates against the
wall/tile face properly.
G1/2
Apply thread
sealant or
teflon tape
rubber
washer
rubber
washer
5. Connect shower rail and hand shower with hose.
TEST & CHECK FOR LEAKS.
All products must be installed by licensed plumbers.
All pipework must be thoroughly flushed prior to installation, as foreign materials
may block the flow regulating device and reduce the flow of water.
Important