2
Important Safety Instructions
Caution
Fire Hazard
•Do not install the inverter / charger or any part of it supplies wiring in engine components.
•Never charge a frozen battery
• Wheninstallingorremovingthebatteries,alwaysremovethenegativeterminalfromthebatteryrstforsystemswithgroundednegative
•Make sure all loads and accessories connected to the unit are off so you don’t cause an arc.
•Use extra caution to reduce risk short-circuit, batteries can produce a short circuit current high enough to weld a ring or metal bracelet or the
like to the battery terminal, causing a severe burn.
Failure to fallow the instructions can damage the unit or damage other equipment.
SAVE THESE INSTRUCTIONS!
This manual contains important instructions and warnings that should be fallowed during the installations and operation of this product.
Battery Connections Warnings
The battery should be connected before operating the cart and the remote voltage meter.
Spark may result during final battery connection. Always observe proper polarity as batteries are connected.
Do not allow objects to contact the two DC inputs terminals. Do not short or bridge these terminals together. Serious personal injury or property
damage could result.
Equipment Connection Warnings
You may experience uneven performance result if you connect a surge suppressor, line conditioner or UPS system to the power stripe or the output
of the inverter/charger.
Connect your Power Swap System only to a properly grounded AC power outlet or hardware source. Do not plug the unit into itself; this may damage
the inverter/charger.
Operation Warning
Your unit does not required routine maintenance. Do not open the inverter/charger for any reason. There are not serviceable parts inside.
Do not connect or disconnect batteries while the unit is operation in either inverting or charging mode. Operating mode should be in the DC OFF
position; Dangerous arcing may result.
WARNING!
LIMITATIONS ON USE
Do not use in connection with life support systems,
