Nex-tech QC8061 Bedienungsanleitung
Instruction Manual
QC8061
Outdoor Wildlife
Trail Camera
Please study all notices carefully and diligently.
Please study this information in detail observing,
in particular, the safety instructions.
Note:
•
Remove the protective foil from the camera lens by pulling the protruding tab.
•
Caution! Keep plastic foil and bags away from babies and small children, as otherwise danger
of suocation.
1
9. SYSTEM INFORMATION, MAINTENANCE AND DISPOSAL23
9.1. Care 23
9.2. Storage 23
9.3. Disposal 23
1. FAQ 3
2. HAZARD, SAFETY AND WARNING NOTICES 4
3. INTRODUCTION6
4. YOUR CAMERA 7
4.1. Front view 7
4.2. Inside views 8
5. PREPARING THE CAMERA 10
5.1. Opening and closing the camera 10
5.2. Inserting the batteries 10
5.3. Inserting the memory card 11
5.4. External power supply 12
5.5. Assembly with strap 12
6. USING THE CAMERA 13
6.1. Mode switch 13
6.2. Operating buttons 13
6.3. Settings 15
6.4. Night recording 19
6.5. Setting up the Live mode 19
6.6. Aligning the camera 19
6.7. File format 20
7. CONNECTING TO COMPUTER 21
8. TECHNICAL SPECIFICATION22
Contents
2
3
1. FAQ:
Problem: The camera only record video at daylight, it doesn't work at night?
Solution: 1. Please check whether your battery is dry and full of energy. If not, please use some new
batteries for your camera.
2. Please check whether you have set the timer. For example, if you set the timer from 6:00
to 18:00, then it only works at daylight and doesn't record videos at night. So you should
set the timer for 24 hours.
3. If the problem still can't be resolved, please format the camera to default setting and
format your SD card ,then all the problems will be resolved.
Problem: The sensor doesn't work or it's not sensitive?
Solution: 1. Please check whether you attached your camera to a good location. If you want to record
some little animals, please measure whether the height is reasonable.
2. Please check the time interval. For example ,if you set it to 60 seconds, then the camera will
take pictures for each 60 seconds, if you want to get more pictures ,please set it to 1 seconds.
Problem: The camera doesn't work or can't switch on?
Solution: 1. Please check whether your battery is AA battery and full of energy and dry.
Problem: The camera doesn't take pictures or videos?
Solution: 1. Please check whether your battery runs out.
2. Please check whether you attched it to a good location.
3. Please check whether there is some animals in the sensor range.
4. Please attach it to a good location.
2. Hazard, safety and warning notices
Incorrect use of the camera and accessories can be dangerous for you and others and can damage or
destroy the camera.We therefore ask you to read and strictly observe the following Hazard, safety and
warning notices.
Intended use
This camera is intended for taking digital photos and video clips. It has been designed for private
use and is not suitable for commercial purposes.
Hazards for children and persons with limited ability to operate
electronic equipment
The camera, accessory and packaging are not toys for children. These should therefore always
be kept away from children. Danger of electrocution, poisoning and suocation.
The camera and accessory may not be used by children and persons with limited abilities. The
camera may only be operated by persons physically and mentally able to operate it safely.
Electrical hazard
Damage from heat-re hazard
Switch o the camera and remove the batteries if a foreign body or liquid has entered the
camera. Let all parts dry thoroughly. Otherwise danger of re or electrocution
Switch o the camera and remove the batteries if the camera hasbeen dropped or the housing is
damaged. Otherwise danger of re and electrocution.
The camera may not be dismantled, modied or repaired. Danger of re and electrocution.
Only use a power adaptor (not supplied) with the mains voltage specied on the rating plate (6V).
Otherwise danger of re or electrocution. Disconnect the power by pulling the power adaptor out of
the socket.
A plugged in power adaptor (not supplied) can continue to use power and therefore represents a
hazard source.
The power supply may not be used during thunderstorms. Otherwise danger of electrocution.
Do notleave the camera in places that are susceptible to considerableincreases in temperature
(e.g. a vehicle). The housing and internal parts may be damaged, which in turn could cause a re.
4
Ensure adequate ventilation and do not cover the mains adaptor (not supplied) to avoid overheating.
Do not place any open ignition sources, such as lit candles onto or close to the device.
Do not subject the LCD monitor to impact or pressure.This could damage the glass of the monitor or
the liquid could leak from the inside. In case of contact with eyes or skin, rinse immediately with clear
water. In case of contact with eyes contact a doctor immediately.
Damage to the electronics, the monitor or the lens caused by external inuences such as impacts,
falls or other are not covered by the warranty and must be paid for.
Do not drop or bump the camera and always handle it carefully. Otherwise the camera can be
damaged.
Do not wrap up camera or place on textiles. This could produce a build up of heat in the camera
that can cause deformation of the housing and may represent a re hazard.
Injuries and material damage
Only place the camera on sturdy surfaces. The camera could otherwise fall or topple over, causing
damage or injury.
Do not operate the camera whilst running or driving. You could fall or cause a trac accident.
Only use a mains adaptor (not supplied) for the camera, having the input voltage specied on
the rating plate (6V). We do not accept any liability for damage caused by the use of an incorrect
mains adaptor.
The 230V socket used for the mains adaptor (not supplied) must not be covered and accessible at all
times so that the mains adaptor can be quickly disconnected from the mains, when required.
5
3.
Introduction
The Wildlife Camera is a wildlife and surveillance camera with a PIR sensor. The sensor can detect sudden
changes to the ambient temperature within an evaluation area. The signals of the highly sensitive infrared
sensor (PIR, passive infrared sensor) switch on the camera, activating picture or video mode.
Features of Wildlife Camera:
• 1/4" CMOS sensor.
• During day, sharp and clear colour images and during night time clear black and white images.
• Extremely low power consumption in standby operation providing extremely long operating
times (in standby mode up to 3 months with 8 AA batteries).
• The unique sensor design oers a wider angle of detection and improves the response time of the
camera.
• Possible use under extreme temperatures of between -20° C to 60° C.
• Compact size (approx. 13.5 x 9.7 x 6.7cm). Ideally suited for covered use.
• Impressively quick shutter release time (0.5 seconds).
• Spray water protected according to standard IP66.
• The easy to operate securing strap allows quick assembly and alignment of camera.
• Using the serial number function, locations can be encoded on photos.Where several cameras are
used, this function allows easier identication of locations when viewing photos.
• Date, time, temperature and moon phase can be displayed on the images.
• Lockable and password protection.
• Alarm in case of low battery level.
Areas of application
• Camera trap for hunting.
• Animal or incident observation.
• Motion triggered security camera for domestic, oce or public use.
• Any internal and external surveillance, where evidence of an infringement has to be provided.
6
4. Your camera
4.1. Front view
7
LED infrared
light
Motion indicator,
red LED
PIR sensor
Lens
Microphone
Locking hole
for lock
Locking bracket
Locking bracket
Light sensor
4.2. Inside views
The monitor is only switched on in theTest mode for changing menu settings or viewing existing
photos and videos.
Using the operating buttons, menu settings can be changed in the test mode or existing photos and
videos can be played back.
An SD or SDHC memory card must have been inserted into the memory card slot in order to save
photos and videos.
Using the mini USB connection (USB 2.0), the camera can be connected to a computer, in order
to download photos and videos.
Using the mode switch the three operating modes OFF, TEST and ON can be selected.
Monitor
Operating
buttons
Speaker
Locking hole
for lock
Memory card
compartment Mini USB connection
Mode switch (OFF/
TEST/ON)
8
Battery compartment : Insert 8 type LR6 (AA) batteries as shown.
An external power supply can be provided via the DC connection (input 6 V, at least 1.5 A. Mains
adaptor is not included.)
Locking hole
for lock
Locking bracket
Tripod thread
Battery compartment
6V DC connection
Locking bracket
9
Andere Handbücher für QC8061
1
Inhaltsverzeichnis
