NHE Vision NHE-N09MPD Bedienungsanleitung
Franchiser：
Specifications
Item List
Item Name Quantity
1Mouse 1
2CD 1
3Power Adapter 1
4Quick Installation Guide 1
5Network Video Recorder 1
Thank you for using our product, please read
this manual carefully before use.
Please refer to the complete User manual for
more information from the CD.
Instructions
◆ This equipment should be installed in a well-ventilated
environment at proper distance away from the ground for
heat dissipation. Do not block the vents and please avoid
heat.
◆ This equipment should be kept horizontal during
installation and avoid installing in locations subject to
excessive vibration.
◆ Please keep it dry in case a short-circuit may cause
fire or other hazard. This equipment is not weatherproof.
◆ To meet the needs of reading and writing extensive
data in the long run, please select the hard disk recom-
mended by manufacturer, which is suitable for the NVR,
and purchase it from the formal channels to guarantee its
quality.
◆ This product can not bear heavy weight, please do
not place heavy objects on it or pile up.
Model 9CH
Operating system LINUX
Compression Standard Standard H.264
IPC Input 9CH(1920×1080, 1280×960, 1280×720 etc.)
HD Output 1CH，HD port; resolution:1920x1080P/60Hz
VGA Output 1CH，VGA port; resolution:1920x1080P/60Hz
Preview resolution 9xD1/1x1080P(single channel for the IPC main stream, multi-channel for sub
-stream)
Video Resolution 9CH×1080P/ 9CH×960P/8CH×720P, etc.（according to IPC input）
Video Frame Rate PAL: 25 frames / sec; NTSC: 30 frames / sec.
Local Playback Single-channel playback 1x1080P
Backup Support local, network backup
Hard disk One SATA hard drive (maximum 4TB)
Network interface 1 RJ-45 port(10/100Mbps)
Support mobile iPhone, iPad, Android
Browser IE8.0 and above,Firefox,Google
Support Agreement ONVIF2.4
USB Interface Two USB2.0 interface
Multi-operation Support for recording, playback, network, backup, mobile monitoring and
interface operation
Dual-stream Yes
Operating Voltage DC 12V
Operating Temperature -10℃ —55℃
Humidity 10%～90%
Power Consumption ≤ 24 W
Instructions
Network Video Recorder
Quick Installation Guide
V2.0-MINI
NHE-N09MPD
3.Local System Login
Rear Panel
4.Web Login
If the plug-ins cannot be loaded, you need to set IE as follows:
Tools —>Internet Options—>Custom Level—>ActiveX controls and
plug-ins, to enable all, and click OK.
Enter the IP address of the recorder in the browser address bar, and
connect. After a successful connection, it will pop up an input box as
shown below.
Enter the user name and password The factory default administrator
user name is admin, password is 12345.
Interface Name Interface Function
VGA VGA output
1080P HD output
RJ45 Ethernet
USB 2.0 USB storage device and mouse
DC-12V Power input
5. Connection with the IPC
2. Hard Disk Installation
Compatible with 2.5-inch and 3.5-inch hard disks, with maximum capacity
of 4TB.
Take the following model as an example
1. Product Appearance Introduction
Item Name Function
1Power Indicator Steady light when the power connection
works.
2HDD Indicator Steady light when the HDD works.
3Network Indicator Steady or flashing light when the network
connection works.
After the normal startup, click the right mouse button and there will be a
login dialogue. Then enters the user name and password in the input box.
In the factory default state, the user is admin, and the password is 12345.
Admin is the default high-privileged user.
Note: Make sure the NVR and IPC are in the same LAN, but different
IP address.
2 ↑4 ↑
3 ↓Select search to the camera
5 →
1 Right-click in the main interface.
1080P
HDD
② Align the screw holes on the hard
disk with screw holes on the base plate.
① Loosen the screws on the base
plate.
③ Turn the device and use screws
to tighten the hard disk to the
bottom.
⑤ Align the top cover with the
base plate and gently close.
⑥ Use screws to tighten the top
cover to the base plate.
HDD
④ Plug in the hard drive cable
and power cable.
Top Cover
1
2
3
Take the following model as an example:
The appearance of products, including buttons, interfaces
and layout, are for reference only, and the actual delivered
goods shall prevail.
Item Name Function
1Power Indicator Steady light when the power connection
works.
2HDD Indicator Steady light when the HDD works.
3Network Indicator Steady or flashing light when the network
connection works.
Item Name Function
1Power Indicator Steady light when the power connection
works.
2HDD Indicator Steady light when the HDD works.
3Network Indicator Steady or flashing light when the network
connection works.
Inhaltsverzeichnis
Andere NHE Vision Netzwerk-Hardware Handbücher
Beliebte Netzwerk-Hardware Handbücher anderer Marken
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung
Yudor
Yudor YDS-16 Bedienungsanleitung
D-Link
D-Link ShareCenter DNS-320L Bedienungsanleitung
Samsung
Samsung ES1642dc Gebrauchsanweisung
Honeywell Home
Honeywell Home LTEM-PV Montageanleitung
