NI Climbing Frames Double Mississippi Bedienungsanleitung
Double Mississippi Swing Set Instruction Manual
Parts List
Item
Number
Description
Image
Quantity
1
3m post
4
2
2.4m post
for swing
bar
1 (holes
pre-drilled
for swing
hooks)
3
1755mm x
3” x 1.5”
2
4
Square
Corner
Brackets
2
5
Swing
(varies
depending
on
customers
choice)
2
6
M10 Swing
Hooks
4
7
Decking
screws
8
8
6x60
screws
10
Tools needed:
•Cordless drill
•Handsaw
•Spirit Level
•Hammer
•Shovel
•Stepladder
•Pencil
•Measuring tape
•10mm Hex bit
•PZ 2 Drill Bit
Assembly Instructions
All components needed during the assembly are numbered with reference to the parts list, please
refer back to the parts list to ensure you are assembling the correct components for each step.
Step 1: Fitting your o-hooks to your swing bar
•Your swing bar will already be drilled with the number of holes required to suit your swing
choices. Most swings will take 2 o-hooks, but the likes of vertical tyres and button swings
only need one
•To secure your o-hooks, simply hammer them through the pre-drilled holes, and using a
spanner, tighten the nut down on top of the washer on the top side of the post. When
tightening, be sure to keep the ‘eye’ of the o-hook running parallel to the length of the post.
Step 2: Securing the posts to the metal brackets
•You should find that the posts fit snuggly into the brackets. Ensure they are pushed in as far
as they can go, then using the 6x60 screws, screw in through all the pre-drilled holes on the
metal bracket
Step 3:
•When all five posts have been secured to the brackets, you can use the 3” x 1.5” timbers to
brace each side of frame together. To do this measure 900mm down each post from the
bracket and use the decking screws to secure it to each post. Trim the timber flush to the
posts once secure
Step 4:
•You are now ready to level your frame. Ensure that the swing bar is level, as well as the two
3” x 1.5” braces you just screwed on. If you are concreting your posts into the ground, which
we recommend, we suggest digging holes roughly 300mm x 300mm wide, and the depth will
depend on the slope of your garden. Ideally you would want to put at least 200mm of
concrete around each post, leaving enough room to replace the sod of grass on top, once
the concrete has fully dried
•Using postcrete and following the manufacturers instruction concrete all 6 posts into the
ground
•The frame should be left overnight before it is used to ensure the postcrete has dried
Step 5: Swing Attachment
•The final thing to do is attach your swings to the o-hooks. All your swings can be adjusted in
height, so set the height of the swings to suit your children by pulling the ropes through the
clasp
Andere NI Climbing Frames Schaukel Handbücher
Beliebte Schaukel Handbücher anderer Marken
Ledon
Ledon 1185 Bedienungsanleitung
Backyard
Backyard LITTLE BRUTUS 2051171 Gebrauchs- und Pflegehandbuch
Component Playgrounds
Component Playgrounds CP-PS24-8x10 Bedienungsanleitung
Kettler
Kettler 0S01053-0000 Bedienungsanleitung
Lemeks
Lemeks Palmako MV70-3121-4 Installationshandbuch
Lifetime
Lifetime 90143 Bedienungsanleitung
Component Playgrounds
Component Playgrounds AF30 Bedienungsanleitung
OOGarden
OOGarden FOSSA Bedienungsanleitung
Lakeland Mills
Lakeland Mills CF1128 Bedienungsanleitung
Backyard Discovery
Backyard Discovery MONTPELIER 30211F Bedienungsanleitung
LifeSpan Kids
LifeSpan Kids AMBER PE83 Bedienungsanleitung
SPORTSPOWER
SPORTSPOWER MSC- 4132 Montageanleitung