QDPH
Sub-menus
Status information for the relevant menu can be found
on the display to the right of the sub-menus.
temperature Setting the temperature for the climate
system. The status information shows the set value for
the climate system.
temporary lux Activation of temporary increase in the
hot water temperature. Status information displays “off"
or what length of time of the temporary temperature in-
crease remains.
ventilation Setting the fan speed. The status information
shows the selected setting. This menu is only displayed
for the exhaust air heat pumps and ground source heat
pumps with the exhaust air module accessory.
op. mode Activation of manual or automatic operating
mode. The status information shows the selected operat-
ing mode.
service settings Setting which climate system is to be
controlled by the room unit. Hold the back button in for
7 seconds to access the Service menu.
Menu 1 - temperature
WHPSHUDWXUH
Setting the temperature (without room sensors
activated):
Setting range: -10 to +10
The display shows the set values for heating (curve offset).
To increase or reduce the indoor temperature, increase
or reduce the value on the display.
Use the arrow buttons to set a new value. Confirm the
new setting by pressing the OK button.
The number of steps the value has to be changed to
achieve a degree change of the indoor temperature de-
pends on the heating unit. One step for under floor
heating whilst radiators may require three.
Setting the desired value. The new value is shown on the
right-hand side of the symbol in the display.
Set the temperature (with room sensors installed
and activated):
Setting range: 5 – 30 °C
The value in the display appears as a temperature in °C
if the heating system is controlled by a room sensor.
To change the room temperature, use the arrow buttons
to set the desired temperature in the display. Confirm
the new setting by pressing the OK button. The new
temperature is shown on the right-hand side of the
symbol in the display.
Caution
An increase in the room temperature can be
slowed by the thermostats for the radiators or
under floor heating. Therefore, open the thermo-
stat valves fully, except in those rooms where a
cooler temperature is required, e.g. bedrooms.
GB
