Nigel B Design NB-2075 Bedienungsanleitung
45 WATT MONO / STEREO AMPLIFIER
45 Watts RMS Mono / Stereo Output into 4 Ohms gives you plenty of output for one or two 4 or 8 Ohm Speakers. In Multiple Speaker
Installations, 8 Ohm Speakers work best in this type of Installation. Information on Speaker Wiring is published on our Web Site
www.nigelbdesign.com under “Tech Manuals,” which explains why 8 Ohm Speakers are the preferred choice in these situations.
CHOSEYOURINPUT
Please see over for other helpful Ideas
Part # NB-2075
Requires NB-PS75 AC Power Supply
Internal circuity enables the user to configure the Amplifier to be used in either Balanced or Unbalanced Modes depending on the connections used.
Shown below are the different Line In Connections that allow the Amplifier to accept either Balanced or Unbalanced Stereo, or Balanced Bridged
Mono Inputs, depending on the user's requirements.
BALANCED STEREO UNBALANCED STEREO UNBALANCED BRIDGED MONO BALANCED BRIDGED MONO
-
-
-
++
++ ++ ++
.. ..
SPEAKEROUTS
BRIDGED
8 Ohms
SHEILD
SHEILD
SHEILD
SHEILD
C
C
C
MONO/ STEREOBALANCEDOR
UNBALANCEDINPUT/OUTPUT
ENERGY SAVING FEATURE
The Amplifier features our ADC (Auto Detection Circuit) that reduces the power Consumption by a significant amount when the Amplifier is not in use.
ADC works within 2 milliseconds of receiving an audio signal and the Amplifier will stay on until no Audio Signal is Present. This way no On/Off Switch
is needed. As soon as Audio is again present the Amplifier will resume operation. After 30 second the Amplifier will go off until activated again.
All our Amplifiers use (Automatic Detection Circuit) that saves Energy. All our Amplifiers
meet an Energy Star Rating allowing us to Display the Energy Star Logo on our Products
Amplifier reduces Engery Use from
4.5 Amps to .025 Amps in "Stand By" Mode
INSTRUCTIONS
THRESHOLD ADJUST
THRESHOLD ENABLED
AMPLIFIER POWER
INDICATOR
ADC
Right Left
-
Nigel B Design, Inc. California, USA. Tel: (818) 487-9323 Fax: (818) 766-9805
Two diffferent Models of our Plenum Rated Equipment Box can be installed in the Plenum or Ceiling Space. The 14" x 14" x 5" High Units allow many
different types of equipment to fit inside, including our Amplifiers. All Cable and Wiring Runs, In and Out are routed internally using the Projector Pole or
Conduit in and out ofto the Boxes, so that both units meets UL 2034 and all Electrical Codes for Plenum Rating. Because the entire
assembly is hidden, the chance of theft is eliminated.
PLENUM RATED EQUIPMENT BOXES
Inside the Plenum
Equipment Box
showing the Amplifier
Power Supply
and Built-In
Power Receptacle
Both Units fit into any Plenum or Ceiling Space
POLE MOUNT PLATFORM
Fits on any 1 /12" Projector Pole
Without Modification to the Pole
Need more Outlets
Fit an Extension Tap
Pole Mount Version
Hanging or Flat Surface Version
ASK US ABOUT OUR LIMPET™ ANTI THEFT ALARM SYSTEM
This device provides 24 hour 7 days Security to any Projector, Plasma Screen or in fact any Equipment you want to protect
fromtheft.
All Wiring and Cabling runs inside the Pole without Modification
Eliminating the need to Tie Wrap anything outside the Pole
3 OUTLET
POWER PANEL
Inhaltsverzeichnis
Andere Nigel B Design Verstärker Handbücher
