Nilfisk-Advance CS7000 Fuel Cell EcoFlex Bedienungsanleitung

(page 1 of 3)

FIGURE 1

FUEL CELL MODULE USER INTERFACE PANEL INSTALLATION

CS7000 Fuel Cell EcoFlex™

INSTALLATION INSTRUCTIONS

This interface panel is supplied/acquired thru Plug Power®, typically at the same time as the fuel cell module.

WARNING!

DISCONNECT BATTERIES BEFORE SERVICING.

UN-INSTALL STEERING WHEELASSEMBLY

1Open the hood and operator side panel for access to steering wheel assembly.

2See ﬁgure 1. Disconnect the Steering Wheel Rotation Sensor Connector (A) from the Wiring Harness (B).

3Remove (2) Bolts (C) holding the Back Plate (J). This requires a 9/16” standard socket. NOTE: Impact sockets or other

thick-wall sockets may not work due to P Clamp (K).

4See ﬁgure 2. Remove the (4) Screws (D) that mount the Steering WheelAssembly (E) using a #3 Phillips screwdriver.

NOTE: It may be helpful to use the steering wheel Tilt Lever (G) to gain access to all the screws.

5Remove Steering WheelAssembly (E). NOTE: The steering assembly is very heavy, use caution when removing.

FIGURE 2

(page 2 of 3)

INSTALL FUEL CELL MODULE CONTROL

6See ﬁgure 3. Place the Fuel Cell Module Control cable (F) through the opening as shown. The cable will lay in the depression in the center

bottom of the opening.

FIGURE 3

RE-INSTALL STEERING WHEELASSEMBLY

7Seeﬁgure 4. Re-InstalltheSteering WheelAssembly(E).Make surethatthe FuelCellModule Controlcable(F)liesinthecenteroftheopening.

The cable will exit below the Tilt Lever (G). Install the (4) Screws (D) and tighten. The Fuel Cell Module Control Panel (H) attaches magnetically

totherightsideof thesteeringwheel onthe steeringassemblyweldment asshown.Verifythatthe cableliesas suchthat theTiltLever(G) works

freely.

FIGURE 4

(page 3 of 3)

FIGURE 5 FIGURE 6

RE-INSTALL STEERING WHEELASSEMBLY (CONTINUED)

8See ﬁgure 5. Install the Back Plate (J) and route the Fuel Cell Module Control cable (F) thru either one of the notched openings as shown. The

Steering Wheel Rotation Sensor Connector (A) exits through the large opening.

9 See ﬁgure 6. Install the P Clamp (K) for the Wiring Harness (B) as shown and reconnect the Steering Wheel Rotation Sensor Connector (A) to

the Wiring harness.

Install P Clamp (K) and loop wire behind the harness as shown.

10 The Fuel Cell Module Control Cable (F) is now ready to be connected to the fuel cell module when it is installed.

11 Make sure all wires and cables are clear of opening when installing the fuel cell module so that they are not damaged.

Notched openings

Andere Handbücher für CS7000 Fuel Cell EcoFlex

Inhaltsverzeichnis

Andere Nilfisk-Advance Bodenreinigungsmaschine Handbücher

Nilfisk-Advance

Nilfisk-Advance AquaPlus AXP BAT PKG 255AH AGM Installations- und Benutzerhandbuch

Nilfisk-Advance

Nilfisk-Advance Advenger BR 855 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance QuickStar Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1900 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Retriever 4600 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Adphibian AX 651 Multi EDS Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance PBU Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance ba 755 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BU800 Administratorhandbuch

Nilfisk-Advance

Nilfisk-Advance Shadow 17 Montage- und Wartungsanleitung

Nilfisk-Advance

Nilfisk-Advance SW5500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56115530 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CA 331 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 750C Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1100S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 421 A/B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56262054 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 430 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Clarke Focus II Large Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance AX 310 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC6000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Clarke EX20 100 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56397010 Bedienungsanleitung

Beliebte Bodenreinigungsmaschine Handbücher anderer Marken

Numatic

Numatic ET 4045 Bedienungsanleitung

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Bedienungsanleitung

Mytee

Mytee 8070 Mytee-Lite Bedienungsanleitung

Kärcher

Kärcher B 140 R Bedienungsanleitung

Triple S

Triple S Ace 26T1 Bedienungsanleitung

Tornado

Tornado Marathon 2000 98190 Handbuch

Windsor

Windsor ADMIRAL Admiral 8 Bedienungsanleitung

Numatic

Numatic TTB 1117/100 Bedienungsanleitung

Tennant

Tennant 8210D Bedienungsanleitung

Nobles

Nobles Frontier Produkthandbuch

lavina

lavina 21-X Bedienungsanleitung

KENT

KENT Edge 28B Bedienungsanleitung

Tennant

Tennant 215 Produkthandbuch

Windsor

Windsor BDP 51/2000C Bedienungsanleitung

CleanFreak

CleanFreak DURA-18HD Bedienungsanleitung

BETCO

BETCO PB24 Bedienungsanleitung

IPC

IPC CT51-71 BT Bedienungsanleitung

Isoplam

Isoplam L010001 Bedienungsanleitung