Nilfisk-Advance SC500 Administratorhandbuch



SC500 How To

Prepare for Use

This is how the machine

should look when you

enter the room.

Disconnect battery

charger, store onboard

charger cord and lower

the recovery tank lid.

Inspect and prepare to

Install proper pad or

brush under the deck.

Pad and Brush Installation REV Model

Install pad under deck.

Line up evenly

(do not

remove center section of

pad)

To remove primary

pad, slide hand between

pad and scrub-head face

Floor finish removal –

First - Install a new

primary floor pad (red or

white only). Pre-wet spp

pad. Then install SPP pad

(between the primary floor pad

and the floor).

Rev brush is optional. To

install align brush tabs

and scrub head then

tighten thumb screws.

Disc Pad or Brush Installation & Preparation for Use Continued

Install brush manually by

lifting brush into place

then slightly rotate to lock

in place.

2Install brush automatically –

center brush or pad under

scrub head, set to minimum

speed, activate scrub

system then press motion

paddle to start scrub system.

Verify recovery tank is

empty, inspect ball float

and cage and inspect

debris catch cage.

Inspect blades for wear. If

worn, remove retaining

strap, flip or replace

blades, install squeegee.

Do not over tighten

knobs.

3Do a walk-around

inspection.

Fill machine

with clean water (water should

not exceed 104°F).

EcoFlex

system – add correct

detergent.

4Turn on machine and verify

battery power. Press paddle

forward or pull for backward

motion

(adjust speed if needed).

Change steering direction by

pushing handle to left or

right. Transport to cleaning

area.

PrepareforUseContinued

www.totalwarehouse.com

833-868-2500

www.totalwarehouse.com

833-868-2500



SC500 How To

Scrubbing

1Familiarize yourself

with the operator

controls. Yellow Super

user access key allows

operator to adjust

settings.

2Gray operator key

allows user to begin

cleaning without

changing/adjusting

machine settings.

3Turn machine on.

Lower squeegee to the

floor. Press the one

touch scrub button then

press motion paddles

to activate scrubbing.

Adjustments while Scrubbing

1Adjust water flow

(as

needed)

. EcoFlex

Chemical Settings for

dilution ratio

(must have

yellow super-user key)

2Burst of power delivers

more water, detergent

and pressure to clean

stubborn areas.

Remaining battery

power displayed by

Battery Power

Indicator.

3Adjust Scrub Pressure

settings to increase

scrub pressure.

Vacuum systems

settings can be

adjusted to normal,

quiet or vacuum off.

Vacuum off is used during

double-scrubbing.

Use settings above to

remove finish

(REV model

only).

Buffer pad must be

used between the SPP

pad and the velcro

surface face on the

scrub head

(this prevents

damage to scrub head)

For efficient and safe

use:

3If scrubbing is

complete, empty

solution and recovery

tank into proper drain.

Prepare machine for

storage and

maintenance.

www.totalwarehouse.com

833-868-2500

www.totalwarehouse.com

833-868-2500



SC500 How To

Store the Machine (Daily Maintenance)

Empty and clean

recovery tank. Remove,

empty and clean debris

catch cage. Rinse and

clean ball float cage.

Remove, rinse and

inspect squeegee and

blades.

Remove and inspect

the brush or pad. Rinse

pad then set aside to

dry.

4Lift up recovery tank lid

for ventilation. Charge

the batteries. Take a

clean damp cloth and

wipe down exterior of

machine.

Check battery fluid level

– refill as needed

(wet

batteries only)

. Clean

solution filter. Purge

EcoFlex System by

pressing both the

solution and chemical

buttons.

For uneven wear

across the squeegee,

adjust the squeegee

pitch by turn the knob

until squeegee glides

evenly on the floor.

Annual Maintenance

Check motor carbon

brushes

(vacuum motor and

scrub deck motor)

Refer to

operator manual for

instructions or an

Authorized Advance

Service Center for

carbon brush inspection

and replacement help

Inspect and replace scrub

deck brush vibration

dampers

(REV models)

Refer to operator manual

for instructions or an

Authorized Advance

Service Center for

carbon brush inspection

and replacement help.

Refer to the SC500

operator’s manual for

proper operation and

maintenance

instructions.



WeeklyMaintenance

www.totalwarehouse.com

833-868-2500

www.totalwarehouse.com

833-868-2500

Andere Handbücher für SC500

Andere Nilfisk-Advance Bodenreinigungsmaschine Handbücher

Nilfisk-Advance

Nilfisk-Advance SC400 43E Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BR 1100S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Clarke EX40 18LX Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1300H P Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 34 RST EcoFlex Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Kent SelectLine 17TS Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SW5500 B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SelectLine 13 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance P17-150HD Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56344200 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance RS 500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Kent 56010815 Montage- und Wartungsanleitung

Nilfisk-Advance

Nilfisk-Advance Hydro-Retriever BR 850 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BRV 900 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Matador Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance DuraGloss 2000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1100S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Warrior ST Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance R 253 9087362020 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SELECTGLOSS 1500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Cr 1100 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Adhancer BA 855 TRIO EDS Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 825 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 500 Bedienungsanleitung

Beliebte Bodenreinigungsmaschine Handbücher anderer Marken

Numatic

Numatic ET 4045 Bedienungsanleitung

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Bedienungsanleitung

Mytee

Mytee 8070 Mytee-Lite Bedienungsanleitung

Kärcher

Kärcher B 140 R Bedienungsanleitung

Triple S

Triple S Ace 26T1 Bedienungsanleitung

Tornado

Tornado Marathon 2000 98190 Handbuch

Windsor

Windsor ADMIRAL Admiral 8 Bedienungsanleitung

Numatic

Numatic TTB 1117/100 Bedienungsanleitung

Tennant

Tennant 8210D Bedienungsanleitung

Nobles

Nobles Frontier Produkthandbuch

lavina

lavina 21-X Bedienungsanleitung

KENT

KENT Edge 28B Bedienungsanleitung

Tennant

Tennant 215 Produkthandbuch

Windsor

Windsor BDP 51/2000C Bedienungsanleitung

CleanFreak

CleanFreak DURA-18HD Bedienungsanleitung

BETCO

BETCO PB24 Bedienungsanleitung

IPC

IPC CT51-71 BT Bedienungsanleitung

Isoplam

Isoplam L010001 Bedienungsanleitung