Nilfisk-Advance Advance SC400 Bedienungsanleitung

Nilﬁsk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk-advance.com

www.nilﬁsk.com

ATTENTION! Do not use the machine before you have read and understood the User Manual

2. Fill the tank with a solution suitable

for the work to be performed.

Always follow the dilution instructions

on the label of the chemical product

used to prepare the solution. Its tem-

perature must not exceed 40°C.

1 Disconnect the battery charger cable

from the electrical main.

3. Install the squeegee and fasten it

with the handwheels, then connect

the vacuum hose to the squeegee.

4. Place the brush or the pad-holder

under the deck. Use the appropriate

brush to clean the ﬂoor.

17. Charge the batteries: Connect the

battery charger cable to the

electrical main

15. Check and clean the squeegee

blades

16. Clean the machine using a damp

cloth and where needed use a

neutral cleaning product

18. Park the machine with the recovery

tank cover open

12. Clean the ﬁlter by: Remove the

transparent cover and the gasket

10. At the end of the work. Empty

the recovery tank with the hose. Then

empty the solution tank with the

trasparent hose

11. Wash with clean water the recovery

tank and the vacuum grid

13. Remove the brush/pad and clean

them

14. Take the squeegee off and remove

debris.

7. Press the solution ﬂow control

switch as necessary, depending on the

type of cleaning to be performed

5. Switch on the brush and vac motors

to activate the machine

6. Press the handle switch to engage

the brush and run the machine

8. Lower the squeegee with the lever. 9. Press the enabling push-button together

with the brush levers for starting ﬂoor

cleaning. If solution applied ﬂows outside

the brush housing during use, reduce the

ﬂow of solution.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to

carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

OPERATING GUIDELINES

SC400

Nilﬁsk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk-advance.com

www.nilﬁsk.com

ATTENTION! Do not use the machine before you have read and understood the User Manual

The machine

doesn’t work

as it should?

The suction

doesn’t work

as it should?

The machine

doesn’t clean

as it should?

The brush

don’t work as they

should?

TROUBLESHOOTING

SC400

1Check if the power cable is correctly

connected.

1Check if the suction hose is

correctly installed and cleaned.

1Check if you have the right water

settings.

1Check if the brush are correctly in-

stalled and not worn out.

2Check if the battery is charged.

2Open the recovery tank and check

if the vacuum grid and gasket are

cleaned.

2Check if the solution tap is open.

2Check if there isn’t any brush motor

overload i.e. 3 battery Ledsﬂash si-

multaneously.

3Check if squeegee blades are

damaged or dirty.

3Check if there are external materials

avoiding brush rotating.

4Close the recovery tank cover prop-

erly and/or verify the gasket wear.

3Check if the solution ﬁlter is

cleaned.

Andere Handbücher für Advance SC400

Inhaltsverzeichnis

Andere Nilfisk-Advance Schrubber Handbücher

Nilfisk-Advance

Nilfisk-Advance MX 521 H Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CA 340 ET Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC6500 Stücklistenhandbuch

Nilfisk-Advance

Nilfisk-Advance BA 5321 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC6000 36C Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC901 ST-28D Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC6000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Clarke CA60 Benutzerhandbuch

Nilfisk-Advance

Nilfisk-Advance BR 752 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SCRUBTEC 545B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Spintec 551 UH Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC800 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance HSC 585 Betriebsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance Retriever 6250 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance Condor 56413000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance PS 333 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC1500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56303004 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Liberty SC60 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BR 1100S SBG SPECIAL Service-Handbuch

Nilfisk-Advance

Nilfisk-Advance SR 1101 B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance Advenger 2800ST Series Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC351 Benutzerhandbuch

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

FIORENTINI

FIORENTINI ET 65-75 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung