Njoy 20050 Bedienungsanleitung


(UK) Warning: Never insert the plug into the wall socket when the fan is disassembled, this can cause an electrical hazard. Read and keep
this manual before using the product.
Safety instructions
-Connect the device to an earthed socket with an agreed voltage as stated on the device.
-Only use the fan as described in this manual.
-This product is suitable for domestic use only
-This product is not suitable for outdoor, commercial or industrial use.
-Never immerse this product in water or any other liquid.
-Do not spray liquids over the fan
-Do not cover this product
-Do not place this device in a damp room or next to a sink.
-Do not use this product in the presence of explosive and/or flammable vapours
-Never place this product or any part of it near open fire or other heat sources.
-Place this product out of the reach of children
-Always place this product on a stable surface
-Remove all objects in the immediate vicinity of this product so that the swivel mechanism is not obstructed.
-Never insert anything through the fan grille and supervise when the fan is switched on.
-Do not place that product near an open window
-This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience or knowledge, unless they are supervised by someone responsible for their safety or have been instructed in the use of
the device.

THE POWER PLUG SHALL BE DISCONNECTED FROM THE MAINS SUPPLY
-When the fan is not in use
-When it is moved
-When servicing the fan
-When cleaning the fan
DO NOT USE THE FAN:
-When the plug or cord is damaged
-When the fan has fallen
-When the fan is not working properly
-If the fan is damaged in any way
Do not hang this product on a wall or ceiling.
Do not operate this product if the fan grilles are not correctly in place.
If the cord is damaged, have it replaced by a qualified electrician.
ASSEMBLY OF THE STAND
1. Put the 2 pedestals together like a cross (8). Place the upright on top of this (9) and screw it down firmly with the screws provided. (4
pieces). Use a PH1 Phillips screwdriver (not supplied).
2. Remove the height adjustment screw and pull up the extendable tube, make sure it does not sink! Slide the protective cap (10) down
over the upright so that it falls over the two pedestals, and screw back the adjustment screw.
3. Place the fan on the extendable pipe and secure it with the clamping nut (11).

MOUNTING GRID AND PROPELLER
1. Place the rear part of the fan grille over the motor shaft (1). Make sure the locking bolt and nut are at the bottom (2), then secure
the rear fan grille with the plastic fixing nut (3).
2. Place the propeller on the motor shaft up to the spindle pin and secure the propeller with the propeller nut (4).
3. Place the front side of the fan grille on the rear side and check that both grilles are flush before fastening both with the 4 clamps (5).
4. Secure the fan grille by tightening the locking bolt and nut (6)
INSTRUCTIONS FOR USE
Check that the fan is placed on a solid and level surface.
THE FAN HAS THE FOLLOWING CONTROLS
0 = Off
1 = Quiet soft breeze
2 = Normal speed
3 = Maximum speed
The automatic swivel can be switched on by pulling the swivel button upwards. Press the swivel button down again to deactivate the swing.
The direction of blow can be set by loosening the tilting pad (7).

MAINTENANCE AND CLEANING
BE THE FIRST TO UNPLUG THE POWER CORD FROM THE WALL SOCKET.
Only use the fan in a dry clean room to minimize contamination.
Remove dirt with a damp cloth. Do not use aggressive cleaning agents
If the fan is disassembled, make sure that it is reassembled according to these operating instructions. NEVER plug the power plug into the wall
socket when the fan is disassembled.
THE ENVIRONMENT
When this product reaches the end of its service life, return it to a collection point for reuse of electrical and electronic equipment. Pay
attention to the references and symbols on the product, in the instruction manual or on the packaging. Contact your local authority for the
address of the appropriate collection point in your area.

(NL) Waarschuwing: Steek nooit de stekker in het stopcontact als de ventilator gedemonteerd is, dit kan elektrisch gevaar opleveren. Lees
en bewaar deze gebruiksaanwijzing voordat u het product gaat gebruiken.
Veiligheidsinstructies
-Sluit het apparaat aan op een geaard stopcontact met overeengekomen voltage zoals op het apparaat vermeld staat.
-Gebruik de ventilator alleen zoals staat beschreven in deze gebruiksaanwijzing
-Dit product is alleen geschikt voor huishoudelijke gebruik
-Dit product is niet geschikt voor buiten of voor commerciële en industriële doeleinden
-Dompel dit product nooit onder in water of een andere vloeistof
-Sproei geen vloeistoffen over de ventilator
-Dit product niet afdekken
-Plaats dit apparaat niet in een vochtige ruimte of vlak naast een wastafel
-Dit product niet gebruiken in aanwezigheid van explosieve en/of ontvlambare dampen
-Plaats dit product of een deel ervan nooit bij openvuur of andere warmte bronnen
-Plaats dit product buiten bereik van kinderen
-Plaats dit product altijd op een stabiele ondergrond
-Verwijder alle voorwerpen uit de direct omgeving van dit product zodat het zwenkmechanisme niet wordt geblokkeerd
-Steek nooit iets door het ventilatorrooster en houd toezicht als de ventilator is ingeschakeld
-Plaats die product niet bij een open raam
-Dit apparaat is niet bedoeld voor gebruik door personen (waaronder kinderen) met verminderde lichamelijke, zintuigelijke of
geestelijke vermogens, of die gebrek aan ervaring of kennis hebben, tenzij er iemand aanwezig is die verantwoordelijk is voor hun
veiligheid toezicht op hen houdt, of hen heeft uitgelegd hoe het apparaat dient te worden gebruikt.

DE STEKKER DIENT UIT HET STOPCONTACT TE WORDEN VERWIJDERD
-Wanneer de ventilator niet in gebruik is
-Wanneer deze wordt verplaatst
-Wanneer er onderhoud wordt gepleegd aan de ventilator
-Wanneer de ventilator wordt schoongemaakt
GEBRUIK DE VENTILATOR NIET:
-Wanneer de stekker of het snoer is beschadigd
-Wanneer de ventilator is gevallen
-Wanneer de ventilator niet goed functioneert
-Wanneer de ventilator op welke wijze dan ook is beschadigd
Dit product niet ophangen aan een muur of plafond bevestigen
Dit product niet in gebruik nemen als de ventilatorroosters niet correct op hun plaats zitten.
Als het snoer is beschadigd dient het te worden vervangen door een erkend elektricien.
MONTAGE VAN DE STANDAARD
1. Plaats de 2 voetstukken als een kruis in elkaar (8). Plaats de staander hier bovenop (9) en schroef deze stevig vast met de
meegeleverde schroeven. (4stuks). Gebruik een PH1 kruiskopschroevendraaier (niet meegeleverd)
2. Verwijder de hoogte verstelschroef en trek de uitschuifbare buis omhoog, zorg ervoor dat deze niet wegzakt!. Schuif het
beschermkapje (10) over de staander naar beneden zodat deze over de twee voetstukken valt, en schroef de verstelschroef terug
3. Plaats de ventilator op de uitschuifbare buis en zet deze vast met de klemmoer (11)

MONTAGE ROOSTER EN PROPELLER
1. Plaats het achterste gedeelte van het ventilatorrooster over de motor-as (1). Zorg dat het borg boutje en moertje onderaan zit (2),
Zet vervolgens het achterste ventilatorrooster vast met de kunststof bevestigingsmoer (3).
2. Plaats de propeller op de motor-as tot tegen de as pin en zet de propeller vast met de propelormoer (4)
3. Plaats de voorkant van het ventilatorrooster op de achterkant en controleer of beide roosters gelijk zitten voordat beide met de 4
klemmen vast te zetten (5)
4. Borg het ventilatorrooster door de borg bout en moer vast te draaien (6)
GEBRUIKSINSTRUCTIES
Controleer dat de ventilator op een stevige en vlakke ondergrond is geplaatst
DE VENTILATOR HEEFT DE VOLGENDE BEDIENINGSKNOPPEN
0 = Uit
1 = Rustige zachte bries
2 = Normale snelheid
3 = Maximale snelheid
Het automatisch zwenken kan worden aangezet door de zwenkknop omhoog te trekken. Druk de zwenkknop weer omlaag om het zwenken uit
te schakelen.
Door de kantelschroef los te draaien kan de blaasrichting worden ingesteld (7)

ONDERHOUD EN REINIGEN
ZORG ER ALS EERSTE VOOR DE STEKKER UIT HET STOPCONTACT TE HALEN
Gebruik de ventilator alleen in een droge schone ruimte om vervuiling te minimaliseren
Verwijder vuil met een vochtige doek. Gebruik geen agressieve schoonmaakmiddelen
Indien de ventilator wordt gedemonteerd, zorg er dan voor dat de ventilator weer volgens deze gebruiksaanwijzing wordt gemonteerd. Steek
de stekker NOOIT in het stopcontact als de ventilator is gedemonteerd
HET MILIEU
Wanneer dit product het einde van zijn levensduur heeft bereikt, inleveren bij een inzamelpunt voor hergebruik van elektrische en
elektronische apparatuur. Let op de verwijzingen en symbolen op het product, in de instructie of op de verpakking. Neem contact op met uw
gemeente voor het adres van het daarvoor bestemde inzamelpunt in uw buurt.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere Njoy Lüfter Handbücher




















