OBERON 1044-CCOAP3800-B Bedienungsanleitung

Installation Instructions

Model Number 1044-CCOAP3800-B

(877) 867-2312 •www.oberonwireless.com

Rev. 08/30/17 Oberon, Inc. •

••

•1315 South Allen Street •

••

Assembly Components:

- Suspended Ceiling Kit Model 1044-CCOAP assembly – 1 each

- Trim with Mounting Bracket – 1 each

- #8-32 x 1/4" Screw – 4 each

- #8-32 x 1/4" M/F Standoff – 4 each

- 1/4" - 20 Wing Nuts – 2 each

- Firestop Grommet – 1 each

- 1" Conduit Connector – 1 each

- Hanger wire – 4 each

If any of these items are missing,

contact your Oberon representative.

Find a flat work surface to assemble

the ceiling kit, access point and

antenna(s) prior to mounting in ceiling.

Step 1 – Remove any knockouts from

the back box needed for cable egress.

Fasten the conduit connector to the

back box through the now open

knockout (Figure 1).

Step 2 – Remove the ceiling tile and cut an 11" x 9" opening. Be

sure to center the opening along the centerlines of the tile. (Figure

2).

Page 2

Step 3 – Place the tile back in the ceiling with the

back box and tile bridge over top. Attach the

hanger wires to the four tabs located on the

corners of the back box and then to a permanent

structure within the ceiling. Slide the cables

through the conduit connector and snap the

Firestop Grommet over the cables (Figure 3).

Make sure there is enough slack in the cabling to

attach to the access point.

NOTE: A surface mount box (or biscuit jack) and

equipment cord can be conveniently mounted

inside the Model 1044. (Non-plenum rated cables

can be used inside a plenum rated enclosure).

Use an adhesive backed surface mount box.

Consider bend radius of horizontal cable and

equipment cord when attaching the surface mount

box.

Step 4 – To attach the access point to the trim, first remove

the two hex nuts that hold the aluminum mounting plate to

the painted trim piece. Next attach the Cisco AIR--

_BRACKET-2 to the mounting plate using the four (4)

screws provided. The Cisco mounting bracket should be

aligned so that the Ethernet jacks of the access point will

face toward the cut out area of Oberon mounting plate

(Figure 4).

Step 5 - After the Cisco mounting bracket has been installed

on the Oberon mounting plate, attach the Cisco 3800 to the

Cisco AIR-BRACKET-2. To finish the trim assembly, re-

attach the painted trim using the nuts removed in Step 4.

Page 3

Figure 1 - Conduit Connector Installation.

Figure 2 - Ceiling Tile Cutout.

Figure 4 - AP and Trim Installation.

Figure 3 - Firestop Grommet Installation

Step 6 - Insert trim assembly through the cutout hole

in the ceiling tile so that the threaded studs go

through the outer holes in the tile bridge. Use the

supplied wing nuts to tighten the trim us to the

ceiling tile. The trim should be tightened so the it is

snug against tile, however, do not over tighten as it

may damage either the tile or trim

Note: Take proper safety precautions as many

wall/ceiling areas may have electrical or plumbing

located behind them.

Page 4

MODEL 1044-CCOAP3800-B

Installation Instructions

**** WARNING ****

Please thoroughly read the product warning below

before installation to provide for a safe work

environment.

1. The Cabinet System Communications are intended to be installed in accordance with the

applicable requirements of the NFPA 70, “National Electrical Code” (NEC), and/or the applicable

sections of ANSI C2, “National Electrical Safety Code” (NESC). The Authority Having Jurisdiction

will be responsible over the final installation to determine if the final configuration meets the

necessary criteria for the installation and use.

2. The Cabinet System Communication is configured in the field by qualified service personnel.

3. Ambient Temperature - A manufacturer's maximum specified operating ambient of 55°C; so that

the installer is able to determine acceptability of use of Accessories and components in the

operating state.

4. A readily accessible disconnect device shall be incorporated in the building installation wiring.

5. The instructions may include the product Load Ratings or those ratings shall be placed on the

product. Maximum weight to be installed in the unit is 25 lbs.

6. Only Listed ITE products shall be installed within the enclosure.

7. This product is to be repaired by personnel trained by the manufacturer or returned to the

manufacturer for repair or replacement.

8. All knockouts, openings, and holes shall be sealed with a plug constructed of metal, or a non-

metal material that complies with UL 2043 or UL 1479.

9. All unused mounting holes should be sealed with tape or other material that complies with UL

1479.

10.AC power is NOT to be used inside the enclosure.

Page 1

Figure 5 - Final Assembly

Inhaltsverzeichnis

Andere OBERON Rack & Stand Handbücher

OBERON

OBERON 1013-00 Bedienungsanleitung

OBERON

OBERON Aruba 1044-ARAP5 Series Bedienungsanleitung

OBERON

OBERON 1042-CCOAP3800 Bedienungsanleitung

OBERON

OBERON 39-1015-RAB Bedienungsanleitung

OBERON

OBERON 1042-MIST43 Bedienungsanleitung

OBERON

OBERON 950-AP303 Bedienungsanleitung

OBERON

OBERON 1016-ANTPLATE Series Bedienungsanleitung

OBERON

OBERON 1006-MIST43 Bedienungsanleitung

OBERON

OBERON 1020-00-USM30 Bedienungsanleitung

OBERON

OBERON 1043-ARAP5 Series Bedienungsanleitung

OBERON

OBERON 1012-00 Bedienungsanleitung

OBERON

OBERON 1021-00-ANTPLATE Bedienungsanleitung

OBERON

OBERON 1006-CCOAP Bedienungsanleitung

OBERON

OBERON 1074-SC-6-ANT Bedienungsanleitung

OBERON

OBERON 1042-FL Bedienungsanleitung

OBERON

OBERON 1040-CCOAP3800 Bedienungs- und Wartungsanleitung

OBERON

OBERON 1064-00 Bedienungsanleitung

OBERON

OBERON 39-1008-SPKRMNT Bedienungsanleitung

OBERON

OBERON Skybar 3001-00 Series Bedienungsanleitung

OBERON

OBERON 39-1020-PMK Bedienungsanleitung

OBERON

OBERON Aruba Series Bedienungsanleitung

OBERON

OBERON NetPoint 3032 Series Bedienungsanleitung

OBERON

OBERON Aruba 1042-ARAP5 Series Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung