Olympia electronics KLD-30 Bedienungsanleitung

KLD-30, KLD-22, & KLR-20

922502050_09_008

MAINS VOLTAGE

MAXIMUM POWER CONSUMPTION

BATTERY (Ni-Cd)

BATTERY PROTECTION

INDICATIONS

RECHARGING TIME

VIEWING DISTANCE

MINIMUM EMERGENCY DURATION

LIGHT SOURCE INTENSITY (230V / EMERG.)

DEGREES OF COVER PROTECTION

OPERATION TEMPERATURE RANGE

PRODUCED IN ACCORDANCE WITH

RELATIVE HUMIDITY

CONSTRUCTION MATERIALS

EXTERNAL DIMENSIONS (LXWXH)

GUARANTEE

KLD-30

KLD-22

KLR-20

LED Characteristics

Charge LED/ Test button

220-240V AC / 50-60Hz

3 hours

24 hours

22m 20m30m

Overcharging and deep discharging protection

3.6V/1 Ah

3.2W / 3.4VA

EN 60598-1, EN 60598-2-22, EN 55015,

EN 61547, EN 61000-3-2, EN 61000-3-3

75lm/75lm

IP54

5 to 40 C

up to 95%

PC, Acrylic plate PC

3 years (1 year for the battery)

Olympia Electronics S.A.

45 °C max. across the board

11.2-13.2V DC

0.72W

0405183

Built-in main board

Warranty

IP54

Maintained

75lm

Light output

Duration

30m22m20m

KLD-22 & KLD-30

KLR-20

The light source of this luminary is not replaceable when the light source

reaches its end of life the whole luminary shall be replaced.

ATTENTION!!!

KLD-30

KLD-22

KLR-20

MAINTAINED EMERGENCY ILLUMINATION SIGNS

Thank you for your trust in our products

Olympia Electronics - European manufacturer

European

manufacturers

Technical Characteristics

MANUFACTURER

MODEL NUMBER

VOLTAGE RANGE

CONNECTIONS

NOMINAL POWER

TEMPERATURE (tc)

Olympia Electronics guarantees the quality, condition and operation of the goods. The

period of warranty is specified in the official catalogue of Olympia Electronics and also in

the technical leaflet, which accompanies each product. This warranty ceases to exist if

the buyer does not follow the technical instructions included in official documents given

by Olympia Electronics or if the buyer modifies the goods provided or has any repairs or

re-setting done by a third party, unless Olympia Electronics has fully agreed to them in

writing. Products that have been damaged can be returned to the premises of our

company for repair or replacement, as long as the warranty period is valid.

Olympia Electronics reserves the right to repair or to replace the returned goods and to

or not charge the buyer depending on the reason of defection. Olympia Electronics

reserves the right to charge or not the buyer the transportation cost.

NOTE: LED= Light Emitting Diode

LABELING EXPLANATION:

X: Self contained

1: Maintained (*)

A: Including test device

E: With non-replacable lamp(s) and/or battery

G: Internally illuminated safety sign

180: 3 hours duration

(*) Maintained operation: The luminary lights its illumination source, when it is

Non Maintained operation: The luminary lights its illumination source, only in

power supply’s failure.

Legend installation-replacement

72nd km. O.N.R. Thessaloniki-Katerini

P.C. 60300 P.O. Box 06 Εginio Pierias Greece

www.olympia-electronics.gr

info@olympia-electronics.gr

TYPICAL WEIGHT 520gr.920gr. 700gr.

254x35x170mm254x35x180mm310x35x216mm

922502050_09_008

These luminaries are used indoors

(ta 40 C) on th e wa ll, where

emergency light is needed. Each

luminary must be permanently

connected to mains power supply.

In normal operation the battery is

charging. In case of a mains power

supply failure the luminary will

light the led strip automatically in

emergency mode. When the mains

power supply is restored the device

turns to normal operation.

Non Maintained / maintained

operation there is an option to

select the non maintained or

maintained operation by placing

the jumper to the appropriate

position according to figure 4 (see

page 3).

Installation

T yo install the luminar follow the

installation instructions on pages 2

and 3.

ΑΤΤΕΝΤΙΟΝ!!!

1. Operations for installation,

maintainance or testing must be

done by authorized personnel only.

2. The device must be connected

to the mains power supply through

a fuse dependent by the total

amount of the line’s power load.

3. It is suggested to check every

month the indication LED for

battery charging, and by pushing

the TEST button to check the

emergency circuit. The led strip

should light as long as the TEST

b u t t o n i s p r e s s e d a n d t h e

indication LED for battery charging

should be off. If the luminary

doesn’t work as described above

contact the installer.

4. It is suggested to check every 6

months the minimum autononous

duration by disconnecting the

mains power supply. Count the

time that the led strip lights and in

case of less time than the nominal

autonomy, the battery must be

replaced. If the measured time is

considerably less than the nominal

autonomy In contact the installer.

case of battery replacement, this

must be replaced by part of the

same type, by the manufacturer or

by a competent person.

5. In case of inactive use for a

period greater than 2 months,

disconnect the battery by pulling

out the battery’s connector.

6. I s not allowed to discard t i

batteries in to common

trash bins, they must be

discarded only in battery

recycling points. Do not

incinerate.

Test Button- Manual Test for

emergency operation

The manual test can be conducted

only if the mains power supply and

the battery is connected:

After 3 seconds, the luminary

returns to normal operation.

Indication LED status

Charge

On: Fully charged.

Off: No battery (No charging

current or disconnected battery).

Blink: Charging.

Luminaire

Wall mounting accessorie

Ceiling mounting accessorie

Manual

Package contents

Γενικά

1922502050_09_008

2922502050_09_008

Installation methods

Wall mounting

Luminary disassembly

Luminary assembly

Battery replacement

Ενδεικτικά

Insert the

power cable

Insert the

power cable

Insert the

power cable

Insert the

power cable

1. Disassemble the luminary.

2. Remove the battery connector and carefully remove the battery from its base.

3. Install a new battery of the same type and rating.

4. Assemble the luminary and power the device.

Α-2130: Accessorie for ceiling (1m)

Α-2131: Accessorie for ceiling (0,5m)

Α-2132: Accessorie for ceiling (0,25m)

Α-2133: Accessorie for wall mounting

Α-2136: Accessorie for hanging installation (2,5m)

A-2520/PL: Suspended ceiling base

>5mm

General

Insert the

cable grommet

Hanging installation

After the desired installation follow the steps below

Ceiling mounting

Maintained

(default)

Non

maintained

Battery

connection

Accessories for installation

(After request)

Insert the

cable grommet

Insert the

cable grommet

Insert the

power cable

Dieses Handbuch passt für folgende Modelle

Andere olympia electronics Beleuchtungsausrüstung Handbücher

olympia electronics

olympia electronics GR-460 Bedienungsanleitung

olympia electronics

olympia electronics GR-940/15L Bedienungsanleitung

olympia electronics

olympia electronics GRL-21/H/90 Bedienungsanleitung

olympia electronics

olympia electronics GR-577/L/15/ST/WP Bedienungsanleitung

olympia electronics

olympia electronics GR-316/15L/MAR Bedienungsanleitung

olympia electronics

olympia electronics SLL-1001/WP Bedienungsanleitung

olympia electronics

olympia electronics OLY-1004/LT/WP Bedienungsanleitung

olympia electronics

olympia electronics GR-60 Bedienungsanleitung

olympia electronics

olympia electronics GR-2100 Bedienerhandbuch

olympia electronics

olympia electronics GRL-29/WL Bedienungsanleitung

olympia electronics

olympia electronics GR-938/4P/ADR Bedienungsanleitung

olympia electronics

olympia electronics KLD-30/CBS/24V/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-938/15L/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-60 Bedienungsanleitung

olympia electronics

olympia electronics GR-423/12L/MAR Bedienungsanleitung

olympia electronics

olympia electronics ZLD-28/EM/MAR Bedienungsanleitung

olympia electronics

olympia electronics GRL-22 Bedienungsanleitung

olympia electronics

olympia electronics ZLD-28/EM/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-939/15L/MAR Bedienungsanleitung

olympia electronics

olympia electronics PLD-25/NiMH Bedienungsanleitung

olympia electronics

olympia electronics GRL-37/90/WL Bedienungsanleitung

olympia electronics

olympia electronics GR-579/L/90/WP Bedienungsanleitung

olympia electronics

olympia electronics SLD-28/SP Bedienungsanleitung

olympia electronics

olympia electronics LLB-26/CBS/24V/ADR Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

olympia electronics KLD-30 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken