ONYA F-19 Bedienungsanleitung

WARRANTY

USER

MANUAL

ONYA F-19

F-19

Congratulations

on your

purchase!

Damage resulting from misuse, not maintaining the

bicycle, or not following the guidelines within this User

Guide.

Damage resulting from an accident or deliberate damage.

Failure to meet the 1-month/200km service check, or 6-

monthly/1000km servicing schedule

Damage due to private repair or alteration by

unauthorized service centre

Failure to produce invoice or proof of purchase

EXCEPTIONS TO WARRANTY

WARRANTY

Battery: 2 years (warranted to still supply at least 60% of rated

capacity after 2 years)

Motor: 1 year

Frame: 3 years (frame structural integrity - not including general

wear and tear)

Other components: 1 year (not including consumables such as

tyres, cables, rubber bungees, handgrips)

Only use genuine replacement parts available through your local

ONYA Dealer.

YOUR ONYA-F19 IS COVERED BY THE

FOLLOWING WARRANTY

ONYA F-19 electric-assist bike

Battery (36V, 10ah in bike frame) Lithium

ion battery charger

2 x battery keys

Front and rear lights (installed)

Your brand new ONYA F-19 comes with:

The e-bike is shipped inside a protective

cardboard carton and packaged to avoid

damage. We ship them 90% assembled.

Follow these steps to get it ready and safe for

you to ride.

1. Lift your ONYA F-19 carefully out of the box.

We recommend you have 2 people to do this

task. Remove the nylon zip ties, bubble wrap,

and packaging from the bike.

2. Fold out the bike frame completely. Move

the black safety catch into lock position. See

image (2).

3. Pump air into the tyres. We recommend

between 40 and 50 psi

4. Insert the handlebar into the steering

column. This might require some gentle

maneuvering of the brake/gear cables. See

image (3).

ASSEMBLING YOUR F-19

5. Before standing the steering column up,

make sure that the column is at it’s lowest

position, and certainly that it is not fully

extended. If the column is too extended then

you will stretch, and possibly break the gear

and brake cables!!

6. Stand astride the front wheel and gently

align the handle bars such that they are

perpendicular to the frame

7. Stand the steering column up again (gently),

hold down the safety latch and set into

position. See image (4).

8. Use the nr. 5 Allen key to tighten the 2 side

nuts on the steering column. See image (5).

9. Use the kickstand and stand the bike on its

own.

10. Put the pedals onto the cranks. Ensure

that:

a. you place the washers onto the pedal

splines. See image (6) AND

b. you have the correct left pedal going

into the left crank, and vice versa. They are

marked with an ‘L’ and ‘R’ accordingly. The

left pedal tightens anti-clockwise, and the

right pedal tightens clockwise. See image

(7).

ASSEMBLING YOUR F-19

11. Loosen the grip on the seat column and

twist the seat into forward-facing position

12. Open the side panel flap on left-hand side

of the frame. Turn the master switch to ON

position. See image (8).

13. To turn you bike ON, goto to control panel

switch on the handle bar and hold the

ON/OFF switch down until the control panel

lights up (takes about 2 seconds)

14. The initial charge is very limited. We

recommend that you give the battery a full

deep charge before riding her for the first

time (ie. charge overnight)

ASSEMBLING YOUR F-19

Important: The following steps should be performed by a qualified cycle

or electric-assist bicycle technician:

Ensure the brake lever sequence is correct for your country before riding.

In NZ, Australia, and UK: the left-hand brake lever is for the rear brake,

and the right-hand level is for the front brake. In all other countries, it is

the other way (left for front, and right for rear).

Check the tyres for any visible damage.

Check tyre pressures are 40-50psi, and adjust if necessary.

Check for any loose nuts, bolts, or fixings. Check the center allen-hinge-

fold bolt regularly and tighten if necessary.

Check brake functions, cable tension, pad clearance, etc.

Check all electronic functions are OK (see the insert: KT-LCD3 eBike

Display User Manual for instructions on how to use the control panel

fitted to your ONYA F-19).

Check all lights and reflectors are in place and functioning correctly

(detailed later in this manual).

PRE-RIDE CHECKLIST

The above steps should be performed by a qualified cycle or electric-

assist bicycle technician.

Respect the traffic regulations. Don’t lend your bicycle to anyone who is

unfamiliar with it. The bicycle can be legally only used on the road by a

person aged 14 years or over.

Wear a bike helmet (on your head). If you are unfamiliar with cycling, we’d

also recommend that you take a cycle proficiency course before using it, or

get some advice from your local ONYA dealer. Your F-19 is a serious

transport vehicle.

As with all bicycles, it is important to respect safe speed limits. If you feel

you are traveling too quickly for the road conditions, then slow down. High

speed will increase forces in the case of an accident and likely compound

further the risk of injury.

Test the brakes each time before you use your bike. Remember that your

brakes will not perform as effectively in wet or icy conditions compared to

riding on dry road.

Check tyres, rims, pedals, steering stem, cables, chain etc for general

condition, regularly.

Visibility while riding is vital at all times. Be aware that it’s particularly

difficult for motorists and pedestrians to see cyclists at dusk, night, fog, or

rainy conditions. If you must ride in such conditions that you take necessary

precautions and follow the rules of the road.

Suggestions for additional precautions are:

- wearing reflective clothing, or arm/foot bands

- equipping your bike with additional reflectors (front and/or rear)

- riding at speeds that are appropriate to the condition

RECOMMENDATIONS FOR

SAFE-RIDING

Check the front and rear rim’s safety line. Replace wheel when any part of

the Rim Wear Groove is not visible.

Do NOT fit a child seat to your ONYA F-19. The bike is not designed to carry

any child seat.

As part of warranty conditions, we require that you service the bike at an

approved ONYA e Velo dealer: - after 1 month or 200km of riding (whichever

comes first) to re-tension spokes - every 6 months or 1000km (whichever

comes first) for general service and inspection

RECOMMENDATIONS FOR

SAFE-RIDING

CONTROL PANEL

The rear-wheel drive F-19s are fitted with the Key Disp 21C LED displays.

REAR-WHEEL DRIVE MOTOR

The mid-drive F-19s are fitted with the DasKit C6/7 displays.

MID-DRIVE MOTOR

Andere Handbücher für F-19

Inhaltsverzeichnis

Andere ONYA Fahrrad Handbücher

ONYA

ONYA F-19 Bedienungs- und Wartungshandbuch

Beliebte Fahrrad Handbücher anderer Marken

RAMBO

RAMBO R1000X2M-FF-BFD Bedienungsanleitung

Vermeiren

Vermeiren SAFARI Bedienungsanleitung

Velec

Velec A2/36V Bedienungsanleitung

Coswheel

Coswheel A-ONE Bedienungsanleitung

Betzold

Betzold 97869 Bedienungsanleitung

Cervélo

Cervélo S3 2019 Bedienungsanleitung

Tenways

Tenways AGO X Bedienungsanleitung

Festo

Festo EGSC-BS-KF Stücklistenhandbuch

Gio Electric

Gio Electric H1 Volt Bedienungsanleitung

GOGOBEST

GOGOBEST GM30 Bedienungsanleitung

DAHON

DAHON CIAO - 2009 Bedienungsanleitung

Aprimatic

Aprimatic ONDA 500 Kurzanleitung

MV Agusta

MV Agusta Lucky Explorer GRAVEL Gebrauchsanweisung

Greyp

Greyp G6 Series Bedienungsanleitung

Babboe

Babboe Carve-E Bedienungsanleitung

Huka

Huka orthros Bedienungsanleitung

Xtracycle

Xtracycle Stoker 2021 Bedienungsanleitung

APRILIA

APRILIA DORSODURO 750 ABS 2015 Bedienungsanleitung