Optex PRO WAVE Bedienungsanleitung
Angle plate
4. Drill holes at the 2 marks using
a 3/16” drill bit.
3. Mark the center of the two
mounting holes.
6. Install housing with supplied screws.
( DO NOT FULLY TIGHTEN )
1. Drill two 1/8” mounting holes on
back of housing.
2. Hold housing at desired mounting
location ensuring it is level.
8. Close the sensor casing.
7. Ensure housing is level and tighten
screws.
Detection
area
Less than 8”
30 - 44”
Sensitive area
7 feet
7-8”
Within 12” from mounting wall
PIR Sensor
Receiver
Touch free
5. Knock in the two plastic anchors.
Holes with
plastic anchors
THICK
THIN
7to8”
30 to 44”
For hand sticker: 30 to 44”
Touch Free
Wave hand here
to open door
Touch Free
Wave hand here
to open door
Angle plate
Thin
Angle Plate
Angle Plate
Thick
5918741
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Optex Sender Handbücher
Optex
Optex TD-20U Bedienungsanleitung
Optex
Optex SS Checker SC-T4 Bedienungsanleitung
Optex
Optex Wireless 1000 Annunciator System TC-10U Bedienungsanleitung
Optex
Optex TD-20U Bedienungsanleitung
Optex
Optex SC-U1 Bedienungsanleitung
Optex
Optex SS Checker SC-T4 Bedienungsanleitung
Optex
Optex Redwall Wire-Free WF-100DT Bedienungsanleitung
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
