Palmer PETIMEP Bedienungsanleitung

USER´S MANUAL

BEDIENUNGSANLEITUNG

PETIMEP

Root Effects - tIMEPRESSOR

DEFINE

YOUR

TONE

INTRODUCTION

Congratulations on your purchase of the PALMER TIMEPRESSOR pedal.

This unique delay plus compressor combo provides an astonishing

range of echo sounds from classic doubling and slapback to a whole

new universe of unusual sonic spaces.

Utilizing old-school bucket brigade technology the analog delay sec-

tion is capable of perfectly recreating the natural warmth and lo-fi

vibe of vintage tape echoes with a maximum delay time of 700ms.

The compressor is switchable pre or post delay. This exclusive fea-

ture permits custom tweaking of the original and delayed signals for

startling new soundscapes. With its amazing possibilities and rich

tone the TIMEPRESSOR is for the adventurous and retro-minded alike.

PLEASE NOTE: Maxing out the delay time and repeat settings will re-

sult in signal degradation and noise. This is by no means a defect

and inherent in the pedal design which is all-analog using a bucket

brigade delay line. The benefits of this old-school technology are

the smooth coloration and increasingly diffuse decay of real-world

echo or a vintage tape unit. For pristine, high-fidelity repeats

use a digital delay.

EN FRDE ES

DEFINE

YOUR

TONE

EN FRDE ES

IMPORTANT SAFETY INFORMATION

1) Read these instructions before using this device.

2) Please comply with all safety warnings and keep these instruc-

tions in a safe place for future reference.

3) Follow all instructions.

4) Never operate the device near water or in a damp environment.

5) Use a dry cloth for cleaning.

6) Do not position the device near sources of heat such as fan

heaters, heat accumulators, ovens or other devices that generate

heat.

7) Use only the extensions/accessory parts recommended by the manu-

facturer.

8) If this device requires servicing, it should be serviced only

by qualified expert personnel. Service is required if the device

was damaged in any way, if fluids or objects have gotten inside the

housing, if the device was exposed to rain or moisture or if it

does not function normally or has fallen down.

DO NOT ATTEMPT TO REPAIR THIS DEVICE YOURSELF. ALWAYS HAVE REPAIRS

CARRIED OUT ONLY BY QUALIFIED SERVICE PERSONNEL. DO NOT MAKE ANY

INTERNAL MODIFICATIONS OR CHANGES TO THIS DEVICE AND NEVER REPLACE

THE INTERNAL ELECTRICAL COMPONENTS. FAILURE TO COMPLY WITH THESE

WARNINGS WILL EXPOSE YOU AND OTHERS TO THE RISK OF ELECTRICAL SHOCK

AND VOID THE WARRANTY FOR THIS DEVICE.

Because PALMER is constantly improving its products, the techni-

cal specifications and design are subject to change without notice.

Existing products may be changed from time to time without prior

announcement.

PANEL DESCRIPTION

FRONT

1RATE

This controls the delay time up to a maximum of 700ms when fully

clockwise.

2REPEAT

This controls the number of delay repeats from a single slapback to

infinite oscillation when fully clockwise.

3TONE

This controls the tone of the delayed signal. Clockwise rotation

adds brightness, counterclockwise rotation increases treble roll-

off adding natural warmth. In center position the delayed signal

remains unaffected.

4MIX

This controls the wet/dry ratio of the original and delayed signals

from delay only (fully counterclockwise) to original signal only

(fully clockwise). In center position equal amounts of the original

and delayed signals are fed to the output.

5THRESHOLD

This controls the amount of compression from zero (fully counter-

clockwise) to maximum (fully clockwise).

6LEVEL

This controls the output level of the pedal from zero (fully coun-

terclockwise) to unity (center position) to a massive boost (fully

clockwise).

EN FRDE ES

7FOOTSWITCH

This toggles the pedal on/off. When off the pedal’s circuitry is

completely removed from the signal path (true bypass).

8LED

When lit the pedal is on. This also serves as a battery level indi-

cator.

REAR

9IN

Using a quality instrument cable with 1/4” plugs connect your gui-

tar to this jack.

10 9V DC INPUT

Connect an optional 9V DC power supply to this socket. For details

please refer to “POWER REQUIREMENTS”.

11 PRE/POST PUSHBUTTON

This switches the compressor before (pre) or after (post) the delay

providing unique control of the delay trail level and decay.

12 OUT

Using a quality instrument cable with 1/4” plugs connect this jack

to the input of your guitar amplifier or the next stompbox in your

signal chain.

EN FRDE ES

FRONT AND REAR PANEL

EN FRDE ES

9 11

INSERTING/REPLACING A BATTERY

The Battery is of the 6LF22 blocktype (9Volts). A quick access com-

parement for easy battery replacement is located at the bottom of

the unit. Always remember to unplug your guitar cord from the Input

of the pedal to prolog battery life. Some battery drain may occur

when the unit is plugged in, even if it is bypassed.

3 4 1Pull the holder

2Open the cover

3Insert the battery

(observe correct

polarity)

4Close the holder

EN FRDE ES

POWER REQUIREMENTS

● Battery: Standard 9V battery

● Power consumption: 20 mA

● External power supply:

9V DC (regulated), 50 mA minimum

5.0 x 2.1 mm barrel style connector, center negative

SPECIFICATIONS

Product type: effect

Type: delay + compressor pedal for

guitar

Inputs: 1

Input Connectors: 6.3 mm (1/4") jack

Input Impedance: 1M ohms

Outputs: 1

Output Connectors: 6.3 mm (1/4") Jack

Output Impedance: 100k ohms

Residual Noise: - 85 dB

Controls: rate, repeat, tone, mix, thresh-

old, level, pre/post, footswitch

Indicator: power/battery status low (LED)

Power Supply: 9 V block, external power supply

Power Consumption: 20mA

Cabinet: sheet steel, powder coated

Dimensions (W x H x D): 120 x 60 x 140 mm

Weight: 0.95 kg 9

EN FRDE ES

LIMITATION OF LIABILITY

If your Adam Hall branded hardware product fails to work as war-

ranted above, your sole and exclusive remedy shall be repair or

replacement. Adam Halls’ maximum liability under this limited war-

ranty is expressly limited to the lesser of the price you have paid

for the product or the cost of repair or replacement of any hard-

ware components that malfunction in conditions of normal use.

Adam Hall is not liable for any damages caused by the product or

the failure of the product, including any lost profits or savings

or special, incidental, or consequential damages. Adam Hall is not

liable for any claim made by a third party or made by you for a

third party.

This limitation of liability applies whether damages are sought,

or claims are made, under this Limited Warranty or as a tort claim

(including negligence and strict product liability), a contract

claim, or any other claim, and cannot be rescinded or changed by

anyone. This limitation of liability will be effective even if you

have advised Adam Hall of an authorized representative of Adam Hall

of the possibility of any such damages, but not, however, in the

event of claims for damages in connection with personal injuries.

This manufacturer’s warranty grants you specific rights; depend-

ing on jurisdiction (nation or state), you may be be entitled to

additional claims. You are advised to consult applicable state or

national laws for a full determination of your rights.

REQUESTING WARRANTY-SERVICE

To request warranty service for the product, contact Adam Hall or

the Adam Hall authorized reseller from which you purchased the

product.

Inhaltsverzeichnis

Sprachen:

Andere Palmer Musikpedal Handbücher

Palmer

Palmer Pechor Chorus Bedienungsanleitung

Palmer

Palmer root effects HERRENCHOR Bedienungsanleitung

Palmer

Palmer RIVER Series Bedienungsanleitung

Palmer

Palmer RIVER Series Bedienungsanleitung

Palmer

Palmer Peptrem Bedienungsanleitung

Palmer

Palmer PEPreverb Bedienungsanleitung

Palmer

Palmer vils Bedienungsanleitung

Palmer

Palmer PEMUTT Mutterstolz Bedienungsanleitung

Palmer

Palmer PEPBOOST Bedienungsanleitung

Palmer

Palmer PEPENCORE Bedienungsanleitung

Palmer

Palmer Wupper River Series Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung