Panasonic CQ-EC167AA B Bedienungsanleitung
Panasonic Taiwan Co., Ltd.
6 CD PLAYER ／RECEIVER
with CD CHANGER CONTROL
CQ-EC167AA B Operating Instructions
page1
Contents
Function and Operation on 6 CD/MP3 Player. . . . . .9
Function and Operation on Radio. .............7
Function and Operation on CD - CHANGER. . . . .15
Function on AUX、TELEPHONE. ...........17
Notes on MP3 .........................18
Panasonic Taiwan Co., Ltd.
Specifications、Features ..................20
Cover. ................................ 1
Contents. ............................. 2
General Function and Operation...............3
CQ-EC167AA B Operating Instructions
page2
※Note：
Passwords key in times
2﹒Press [PWR/VOL] to power on the unit. Starting picture displays on the screen.
Press [PWR/VOL] again to power off the unit.
Press [PWR/VOL] calls the screen to ask for keying passwords after installation, loose power, and battery change.
General Function and Operation
①Power Control/Volume Adjustment [PWR/VOL]
A﹒Power [PWR/VOL]：
l﹒ Turn the key in the ignition(ACC). When the unit is ready, time displays on the screen. (the power of unit is off)
Function Operation
①
②
③
④
⑤
page3
B﹒Volume [PWR/VOL]：
↑ ↓
Turn the Volume [PWR/VOL] button clockwise to increase
BASS（0 ～ +12）
Turn the Volume [PWR/VOL] button clockwise to increase
TREBLE（0 ～ +12）
Turn the Volume [PWR/VOL] button counterclockwise to
decrease TREBLE（0 ～ -12）
Turn the Volume [PWR/VOL] button counterclockwise to
decrease BASS（0 ～ -12）
Turn the Volume [PWR/VOL] button clockwise/counterclockwise to increase/decrease volume(0~40)
※IF owner forgets or wishes to change the password, please take the unit to the Ford service center for service.
passwords key in: [1]~[4] stand for thousand, hundred, tenth, single respectively. Press the key once means 1;
The unit will be locked for 30 minutes if you key in the wrong passwords for more than 4 times.
General Function and Operation
Selection " BASS " to adjust：
②Audio mode [MENU]
◎Press [MENU] to select audio mode
BASS →TREBLE →BALANCE
Regular mode ← FADER
Selection " TREBLE " to adjust：
30 minutes count backwards
press the key twice means 2, etc. You can enter 0000~9999 as passwords by this way.Press [5] to confirm when password is
entered and get into the initial operation screen.
※Note：
When AUDIO Volume lower than 20 level ，ACC OFF∕POWER OFF → ON，Volume keeps the original level。
When AUDIO Volume higher than 20 level ，ACC OFF∕POWER OFF → ON，Volume reset to level of 20。
page4
※Note：
③Attention/Loud [ATT/LOUD]
Attention [ATT/LOUD]：
LOUD [ATT/LOUD]：
Selection " BALANCE " to adjust：
General Function and Operation
Press [ATT/LOUD] more than 2 second again to cancel LOUD function and " LOUD " indicator is off.
Press [ATT/LOUD] more than 2 seconds to increase BASS and TREBLE under small or medium volume.
After this operation, " LOUD " indicator lights on the screen.
Press [ATT/LOUD] again to cancel Attention function and " ATT " indicator is off.
Selection " FADER " to adjust：
Turn the Volume [PWR/VOL] button counterclockwise to
increase rear speaker（R：0 ～ R15）
Turn the Volume [PWR/VOL] button clockwise to increase
front speaker（F：0 ～ F15）
If no operation excused for more than 5 seconds in audio mode (BAS/TRE/BAL/FAD), the display returns to the regular
mode. Press [menu] again to select audio mode
Press [ATT/LOUD] to decrease Volume 20dB instantly and " ATT " indicator displays on screen
Turn the Volume [PWR/VOL] button clockwise to increase
right channel（R：0 ～ R15）
Turn the Volume [PWR/VOL] button counterclockwise to
increase left channel（L：0 ～ L15）
◎Press [MENU] more than 2 seconds to reset Bass∕Tre∕Bal∕Fad to center value (0)
page5
clock display
⑤SOURCE MODE [MODE]
RADIO DISC PLAYER
AUX CD-CH
General Function and Operation
④Clock[CLK] Adjustment
Press [CLK] again to make minute number blinks, press [SEEK∨]∕[SEEK∧] to set minute ahead∕back.
●Press [CLK] for more than 2 seconds to adjust time.(default: 12:00)
●Press [CLK] in 2 seconds to display the time, press again to cancel time display and back to the previous mode.
●Press [CLK] again to end time adjustment.
When the unit is power off, the screen shows clock display
●Press [MODE] to select sound source when the unit is power on .
First, hour number blinks, press [SEEK∨]∕[SEEK∧] to set hour ahead∕back.
Note： " ADJ " displays at the first time of clock adjustment
The sequency of sound source change as below
page6
a b c d
①Change Radio
FM1 → FM2 → FM3 → AM1 → AM2
↑↓
Auto Preset Memory
Function and Operation on Radio
●Press [BAND] to change band source in radio mode, you can select the FM∕AM channel you like.
Press [BAND] to change radio band, the sequency is shown as below.
a﹒Band display
‧The FM 1 channel
b﹒Frequency of current station
c﹒Preset station number
‧display the preset station number (1~6)
d﹒Stereo sound indicator
‧display receiving stereo sound
Press one of the preset buttons from [1] to [6] to select the preset station.
●Frequency displayed on screen will change with seek tunning.
" ST " display on screen, if the receiving station is stereo sound.
Press [BAND] to select a radio source, then press and hold [BAND] button(auto preset station) for more than 2 seconds.
●With this operation, 6 station with 1st to 6th highest in signal strength will be automaticlly preseted in preset station
buttons [1] to [6]. Once set, the preset stations are sequently scanned for 10 seconds each.
FUNCTION OPERATION
SCREEN DISPLAY
①
②
③
④ ⑤
⑥
⑦
⑧
⑨
page7
※Number of preset stations
FM1 FM2 FM3 AM1 AM2
Up to 6 Up to 6 Up to 6 Up to 6 Up to 6
②M1③M2④M3⑤M4⑥M5⑦M6 Preset station button[1] ~ [6]
Function and Operation on Radio
Use manual or seek tuning to find your favorate station
Reapeat these steps you can save preset station on [FM1] ~ [AM2].
Press preset station button[1] ~ [6] for more than 2 seconds to save current station on button [1]~[6]
②M1③M2④M3⑤M4⑥M5⑦M6 Preset Station Calling
Press [SEEK∧] and release in 2 seconds to select the higher frequency.
Manual Tuning
Press [1] to [6] to call the corresdonding preset station in memory.
Press [SEEK∨] and release in 2 seconds to select the lower frequency.
⑧SEEK∨、⑨SEEK∧
Press [BAND] to select desired band, buttons [1] to [6] remember the presaved or default station.
●The step for FM is 0.1 MHz, the step for AM is 9KHz. Band frequency displayed on screen changes with tuning.
Press and hold [ SEEK∧ ] for more 2 seconds, tuning will automatically stop when the next higher frequency station is
received.
●Press [SEEK∨] or [SEEK∧] again to stop auto tuning.
AutoTuning
Press and hold [ SEEK∨ ] for more 2 seconds, tuning will automatically stop when the next lower frequency station is
received.
※NOTE:
Repeat these steps you can change preset station.
※NOTE:
[1]~ [6 ]saved stations are overwritten with new station
after saving procedure
page8
a g
d
c e
f
g﹒Number of CD
①Insert and playback a CD
Function and Operation on CD Player
e﹒" REP " Repeat function is active
a﹒Track number
b
b﹒playing time
Note：If a disc is not well recorded, it may not be playable on this unit.
Then you can insert a disc .
2.Operation and Functuon on playback CD / CD-R / CD-RW discs
" LOAD CD " displayed on screen when the unit is ready for inserting a disc under CD mode.
c﹒type of playing CD
d﹒" RX " Random function is active
f﹒" SCAN " Scan function is active
1.The unit can playback CD / CD-R / CD-RW / MP3 disc。
⑧
⑨
FUNCTION OPERATION
SCREEN DISPLAY
①
②
③
④
⑤
⑥
⑦
page9
②▲EJECT button( To eject CD )
③SEEK∨button：
④SEEK∧button：
After reading, playback will start automatically.
Function and Operation on CD Player
Press again to cancel RANDOM PLAY function. RX indicator is off.
When reading the data on disc, screen displays " READING ".
Press [ SEEK∨ ] and release in 2 seconds back to the begin of current track.
Press [ SEEK∨ ] twice back to the previous track.
IF you do not take away the CD which will be loaded again after 10 seconds.
Press [ ▲] button to reject CD.
Press [ SEEK∨ ] and hold for more than 2 seconds to begin FAST REVERSE, release holding to
stop fast reverse and resume playback normally.
Press [SEEK∧] and release in 2 seconds back to the next track.
Press [SEEK∧] and hold for more than 2 seconds to begin FAST FORWARD, release holding to
stop fast forward and resume playback normally.
Press [SCAN] to display " SCAN " on screen, then the first 10 seconds of each tracks of all CDs is
played in sequence.
⑤SCAN button：
⑥RX button：Press [RX] to display " RX " on screen, then all available tracks are played in a random sequence.
Press again to cancel SCAN function.SCAN indicator is off.
blinks
When inserting a disc, screen displays the disc number and the number blinks.
page10
Inhaltsverzeichnis
Andere Panasonic CD-Player Handbücher
Panasonic
Panasonic SL-CT810 Bedienungsanleitung
Panasonic
Panasonic SL-SX320 Bedienungsanleitung
Panasonic
Panasonic RX-D29P Bedienungsanleitung
Panasonic
Panasonic SL-SX286J Bedienungsanleitung
Panasonic
Panasonic DVD-F85S Bedienungsanleitung
Panasonic
Panasonic SL-SV550 Bedienungsanleitung
Panasonic
Panasonic SLS232C - PORT. COMPACT DISC Bedienungsanleitung
Panasonic
Panasonic SLPH660 - PORT. CD PLAYER Bedienungsanleitung
Panasonic
Panasonic DVD-PS3 Bedienungsanleitung
Panasonic
Panasonic SLPG480A - COMPACT DISC PLAYER Bedienungsanleitung
Panasonic
Panasonic LX-200U Bedienungsanleitung
Panasonic
Panasonic WJRT208 - Digital Disk Recorder Bedienungsanleitung
Panasonic
Panasonic SL-S260 Bedienungsanleitung
Panasonic
Panasonic CQ-C1505N Bedienungsanleitung
Panasonic
Panasonic SL-SV550P Bedienungsanleitung
Panasonic
Panasonic SL-SX470 Bedienungsanleitung
Panasonic
Panasonic DVD-RV80 Bedienungsanleitung
Panasonic
Panasonic SL-CT730 Bedienungsanleitung
Panasonic
Panasonic SLMP35 - PORT. CD PLAYER Bedienungsanleitung
Panasonic
Panasonic SA-VK725DEE Bedienungsanleitung
