Panasonic SH-ALL1C Bedienungsanleitung

SQT0184

until

2014/03/24

Owner’s Manual

Network Audio Connector

Model No. SH-ALL1C

Thank you for purchasing this product.

Please read these instructions carefully before using this product,

and save this manual for future use.

- 2 -

Table of contents

Accessories........................................................................................ 3

Unit care............................................................................................. 4

Control reference guide...................................................................... 5

Indicator illumination .......................................................................... 6

Connections ....................................................................................... 8

Network settings............................................................................... 12

Enjoying music ................................................................................. 19

Firmware updates ............................................................................ 23

Others .............................................................................................. 24

Troubleshooting................................................................................ 27

Specifications ................................................................................... 30

How to use this manual

Click/Tap this icon to jump to “Table of contents”.

≥Pages to be referred to are indicated as “l±±”. You can jump to the

corresponding page by clicking/tapping this.

- 3 -

Accessories



≥Do not use AC power supply cord (AC mains lead) with other equipment.

≥Product numbers provided in this owner’s manual are correct as of May 2014.

These may be subject to change.

1 AC power supply cord (AC mains lead)

(K2CB2CB00022)

(K2CT2YY00097)

(K2CQ2YY00119)

(K2CJ2YY00101)

1 Audio cable

(K2KYYYY00242)

2 Stands

(RYQ1443-K1)

For the United Kingdom and Ireland

For Continental Europe

For Australia and New Zealand

- 4 -

Unit care

Clean this unit with a soft, dry cloth.

≥Never use alcohol, paint thinner or benzine to clean this unit.

≥Before using chemically treated cloth, carefully read the cloth’s instructions.

∫To dispose or transfer this unit

The unit may keep the user settings information in the unit. If you discard

this unit either by disposal or transfer, then follow the procedure to return

all the settings to the factory defaults to delete the user settings.

(l27, “To return all settings to the factory defaults”)

≥The operation history may be recorded in the memory of this unit.

Disposal of Old Equipment

Only for European Union and countries with recycling

systems

This symbol on the products, packaging, and/or

accompanying documents means that used electrical and

electronic products must not be mixed with general household

waste.

For proper treatment, recovery and recycling of old products,

please take them to applicable collection points in accordance

with your national legislation.

By disposing of them correctly, you will help to save valuable

resources and prevent any potential negative effects on

human health and the environment.

For more information about collection and recycling, please

contact your local municipality.

Penalties may be applicable for incorrect disposal of this

waste, in accordance with national legislation.

- 5 -

Control reference guide

1Mode switch [MODE]

Set the downsampling setting (l24)/

Turn the beep sound on/off (l25)

2WPS pairing switch [-WPS]

Enter WPS pairing mode (l16) / firmware update mode (l23)

3Standby/on switch [Í/I]

Touch to switch the unit from on to standby mode or vice versa. In standby

mode, the unit is still consuming a small amount of power.

4Mode indicator (amber)

5Network indicator (blue/red)

6Operation indicator (amber)

–WPS

MODE

: Touch area

- 6 -

Indicator illumination

The indicator patterns illustrated below are displayed during normal

operational conditions.

Indicator Description

Operation indicator (amber) Blinks once

≥The unit detects the switch touched.

Blinks twice

≥The unit detects a valid operation

performed by touching and holding

the switch.

Mode indicator (amber) Blinks once

≥The following setting is turned on.

“Downsampling” (l24)

“Operation sound setting” (l25)

– When the setting is turned off, it blinks

twice.

Blinks

≥The unit is in process of turning to

standby mode.

– Do not disconnect the AC power

supply cord (AC mains lead). Doing

so may cause malfunction or

damage.



≥The mode indicator also blinks when

the volume is changed on the app.

(l19)

–WPS

MODE

–WPS

MODE

- 7 -

Indicator Description

Network indicator (blue/red) Blinks alternately

≥The unit is carrying out an internal

process.

– Wait for maximum of approximately

60 seconds before the blinking stops.

– Do not disconnect the AC power

supply cord (AC mains lead). Doing

so may cause malfunction or

damage.

Network indicator (blue) Blinks slowly

≥The unit is ready for network setup.

(l12)

Blinks

≥The unit is waiting for the WPS

connection. (l16)

Blinks fast

≥The unit is waiting for the WPS PIN

code connection. (l16)

Network indicator (blue) Lights up

≥The unit is connected to the

network.

Network indicator (red) Blinks

≥The unit is connecting to the

network.

– When the network connection cannot

be established, the blinking keeps

going. Check the network connection.

(l12)

–WPS

MODE

–WPS

MODE

–WPS

MODE

–WPS

MODE

–WPS

MODE

- 8 -

Connections

You can enjoy music from a device on the network by using this unit.

At first, you must connect an audio system, amplifier or receiver, etc. to

this unit.

This unit can be installed either vertically or horizontally.

∫Horizontal

Install the unit with the rubber feet side down as shown below.

STEP1: Installation

Ex. Connecting to an audio system

Rubber feet

- 9 -

∫Vertical

Place the stands and fit the unit into them.

Install the unit with the AllPlay

icon side up.

Stands (supplied)

Rubber feet

When placing the stands, align

them with the rubber feet.

Stands (supplied)

- 10 -

Connect an audio system, amplifier or receiver, etc. to this unit using an

audio cable (supplied) or an optical cable (not supplied).

∫Using an audio cable (supplied)

∫Using an optical cable (not supplied)



≥For details, refer to the operating instructions of the connected device.

STEP2: Connecting to an audio system, etc.

AUDIO OUT

AUDIO IN AUDIO OUT L

Audio cable (supplied)

Optical cable (not supplied)

Andere Handbücher für SH-ALL1C

Inhaltsverzeichnis

Andere Panasonic Medienkonverter Handbücher

Panasonic

Panasonic WJ-GXE500E Bedienungsanleitung

Panasonic

Panasonic EVB-MV103HFXX-KIT Bedienungs- und Wartungshandbuch

Panasonic

Panasonic LonWorks CZ-CLNC2 Bedienungsanleitung

Panasonic

Panasonic PC8 Bedienungsanleitung

Panasonic

Panasonic AJUFC1800 - HD STANDARDS CONVERT Benutzerhandbuch

Panasonic

Panasonic WJ-GXE500 Bedienungsanleitung

Panasonic

Panasonic AWEX500N - SIGNAL CONVERTER Bedienungsanleitung

Panasonic

Panasonic WJ-GXE100 Bedienungsanleitung

Panasonic

Panasonic Ramsa WZ-AD96 Bedienungsanleitung

Panasonic

Panasonic AWIF400G - PROTOCOL CONVERTER Bedienungsanleitung

Panasonic

Panasonic WJ-PR204 Bedienungsanleitung

Panasonic

Panasonic BY-HPE11KTA Bedienungsanleitung

Panasonic

Panasonic KS1 Bedienungsanleitung

Panasonic

Panasonic AJ-LT95 Bedienungsanleitung

Panasonic

Panasonic WJDC108AD - DATA CONVERTER Bedienungsanleitung

Panasonic

Panasonic AJ-UDC3700P Bedienungsanleitung

Panasonic

Panasonic Ramsa WZ-DA96 Bedienungsanleitung

Panasonic

Panasonic i-pro WJ-NT304 Bedienungsanleitung

Panasonic

Panasonic Ramsa WZ-DA96 Bedienungsanleitung

Panasonic

Panasonic WJ-GXD400 Handbuch

Panasonic

Panasonic AJ-UDC150AP Bedienungsanleitung

Panasonic

Panasonic WJGXE900 - MPEG2 ENCODER Bedienungsanleitung

Panasonic

Panasonic TU-DST50 Operating Bedienungsanleitung

Panasonic

Panasonic WJ-GXE100 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung