A. Reflector Panel and Center Cap
Head and Upper Post Assembly
Gas Hose
Regulator
Lower Post
B.
C.
D.
E.
F. Post Support Plate
Tank Housing Assembly
Tank Housing Support Bar
Tank Housing Door
LED Control Box
w/hardware
G.
H.
I.
J.
Tools Required for Assembly (NOT included):
PARTS LIST
CAUTION
• DO NOT operate the heater in an explosive environment Keep this appliance
away from areas where you have stored gas or other vapors and flammable
liquids.
•
Before use, verify that no parts are damaged, inspect gas hose.
• Never modify this appliance in any way or it will void the warranty.
• Never use the heater without the reflector shield.
• Respect minimum clearance from combustibles top 36", sides 24".
.
• Always place heater on a leveled, stable and hard surface.
• Only use this heater outdoors.
• Never clean with abrasive, corrosive or flammable cleaners.
• Do not paint the heater or any of its parts.
• When fully assembled please perform a leak test, and every time you
disconnect the hose, before lighting up the heater.
• A leak test must be performed before operating the appliance.
To perform a leak test, use a 50/50 mix of each water and soap in a spray bottle.
• NEVER LEAK TEST with an open flame or while smoking.
• The gas cylinder must be closed at all times when not using the heater.
• Children and adults should be made aware of hot surfaces on the heater.
• Do not obstruct the ventilation opening on cylinder cover.
• Installation, maintenance and repair of this heater should always be performed
by a qualified qas technician.
TOOLS AND ACCESSORIES
• Clothing and other accessories or objects are not to be hung or laid on the heater
or near it to dry.
Phillips screwdriver w/medium blade
Leak Test Solution
Adjustable wrench (2) (Note: 10mm wrench or socket should fit M6 bolt;
13mm wrench or socket should fit M8bolt.)
NOTE: This heater has an Electronic Ignition and will require the installation of 1 - AAA battery. The battery
should be installed by unscrewing the RED IGNITER BUTTON.
The LED control box also requires the use of 8 - AA batteries. BATTERIES ARE NOT INCLUDED.
Phillips screwdriver w/medium blade
Leak Test Solution
Adjustable wrench (2) (Note: 10mm wrench or socket should fit M6 bolt;
13mm wrench or socket should fit M8bolt.)
NOTE: This heater has an Electronic Ignition and will require the installation of 1 - AAA battery. The battery
should be installed by unscrewing the RED IGNITER BUTTON.
The LED control box also requires the use of 8 - AA batteries. BATTERIES ARE NOT INCLUDED.
5
