Paramount Fitness Clear 03 Bedienungsanleitung

295 East Corporate Place • Suite 100 • Chandler, A 85225

Toll Free: 1.800.621.5886 • Phone: 480.893.7607 • Fax: 480.753.3397

Paramount@1Paramount.com • www.1Paramount.com

004-027-8780-00 REV110711 US Patent 7,837,951

MADEINUSA

WATER PURIFYING SYSTEM

INSTALLATION MANUAL

®2008, Paramount Pool and Spa Systems

SAFETY INSTR CTIONS

IM ORTANT SAFETY INSTRUCTIONS: READ COM LETELY

BEFORE ROCEEDING WITH INSTALLATION. SAVE THESE

INSTRUCTIONS

When using this electrical equipment, basic safety precautions should

always be followed, including the following:

CAUTION: READ AND FOLLOW ALL INSTRUCTIONS

WARNING:

• Follow all applicable electrical codes.

• A qualified licensed electrician should perform electrical

hookup.

• Turn off power at main source before making any electrical

connections or servicing the unit.

• Use only liquid-tight flexible nonmetallic conduit for electrical

connections.

• A terminal marked is located inside the supply terminal

compartment. To reduce the risk of electric shock, this

terminal must be connected to the grounding means provided

in the electrical supply service panel with a continuous copper

wire equivalent in size to the circuit conductors supplying this

equipment.

• At least one lug marked “BONDIN LU ” provided on the

external surface of the unit. To reduce the risk of electric

For technical assistance call 1.800.621.5886 or contact your regional representative

shock, connect the local common bond grid in the area of the

pool or spa to this terminal with an insulated or bare copper

conductor not smaller than 6 AW .

WARNING:

• ALWAYS wear safety glasses when using power equipment

during the installation process.

• Install at least 5 ft from pool or spa water using nonmetallic

plumbing. Mount ozone generator near pool equipment at

least one (1) foot above maximum water level to prevent

water from contacting electrical equipment. Install in

accordance with the installation instructions.

• Short-term inhalation of high concentrations of ozone and

long-term inhalation of low concentrations of ozone gas can

cause serious harmful physiological affects. Do not inhale gas

produced by this unit. If installed in an enclosed space make

sure to account for adequate ventilation.

• UV LI HT PRODUCED BY THIS UNIT IS HARMFUL TO

THE EYES AND MAY CAUSE BLINDNESS. DO NOT LOOK

DIRECTLY AT A LIT BULB!

NOTICE TO OWNER:

• Save these instructions and deliver to pool owner when

installation is complete.

SAFETY INSTR CTIONS (CONT.)

For technical assistance call 1.800.621.5886 or contact your regional representative

WHAT IS OZONE AND HOW DOES IT WORK

• Ozone is created from oxygen using a simple yet powerful system of UV bulbs,

to be used as a pure shock (oxidizer) for the swimming pool.

• Ozone is injected into the pool water using the Clear O3®suction injection

system, where the ozone enriched air is mixed with the water going into the

pool circulation pump. This creates a dynamic environment that best mixes the

air and water at high pressure as it is sent into the filter

• Once in the water, the ozone breaks down materials such as ammonia, oils, and

other non-living waste that are detrimental to chlorine's function in the pool.

This occurs between the pump and filter and also

in the filter. Chlorine is in a group of the least stable elements and must be

combined with another material to become stable. In swimming pools, this

process creates the formation of combined chlorines, like chloramines, which

do not sanitize and have adverse effects on human skin. Use of ozone allows

the chlorine to work primarily as a water disinfectant.

• Pool water treatment can be broken down into three primary categories:

1. Disinfectant- The killing of living organisms (virus, bacteria, algae). This

consumes only 10-20% of the chlorine normally placed in a pool.

2. Oxidation- The removal of non-living waste from pool water. This consumes up

to 70% of the chlorine placed in standard treated pools

3. Residual- The remaining, measurable sanitizer

is left in the pool as a safety net to maintain the water quality until it is brought

through the pool equipment again. Usually less than 10% of the chlorine

originally placed in a pool is left over

as residual.

Installing a Clear O3®Water Purification system will reduce the amount of

chlorine needed to maintain

a pool by up to70%.

The benefits of using ozone include:

• Fewer chemicals to maintain the pool.

• Less work to maintain the pool water.

• More enjoyable water, being treated similar to bottled water.

• Longer filter cycles, and increased life for the salt chlorinator cells (if present).

TO COMPLETE INSTALLATION YO WILL NEED THE FOL-

LOWING ITEMS (NOT INCL DED)

(1) Six (6) feet 1/2” non-metallic conduit outdoor rated.

(1) 1/2" conduit compression fitting.

For technical assistance call 1.800.621.5886 or contact your regional representative

SELECTING LOCATION & MO NTING NIT

1. Select a location on a wall near the pool equipment or insert posts into the

ground, which will be used to hang unit. The Clear O3®unit should be at least

one (1) foot above maximum water level, and for extra safety the unit should

be mounted higher than the filter. The unit should be within five (5) feet of an

electrical source, and within nine (9) feet of plumbing connection. A solid

surface is necessary to mount unit. Mounting brackets are horizontally

adjustable to line up with hard points on the mounting surface. The unit must

be mounted horizontally and level on the wall. Electrical connections should

be facing downward.

2. Use provided screws and plastic wall inserts

or poles and pole mount clamps (not included) depending on installation

surface available.

3. Four (4) mounting

brackets are

included (two for the

top slot and two for

the bottom slot.

4. Install anchors and

screws in desired

location for the top

hangers. They must

be no further apart than twelve (12) inches. Do not tighten screws all the way.

(Fig. 1)

5. Hang the Clear O3®from the two top brackets by sliding the keyhole slots

over the screws.

Fig. 1:

12" Maximum

6. Mark the location for the two bottom brackets. (Fig. 2)

7. Remove the Clear O3®from the wall and install the wall anchors.

8. Place the Clear O3®unit back on the screws and line up the two lower

brackets with the wall anchors. (Fig. 3)

9. Install the bottom two screws and tighten all screws.

SELECTING LOCATION & MO NTING NIT

For technical assistance call 1.800.621.5886 or contact your regional representative

Fig. 3:

Fig. 2:

MAKING ELECTRICAL CONNECTIONS

For technical assistance call 1.800.621.5886 or contact your regional representative

Fig. 4:

120 Vac 50-60 Hz 0.8A

BLACK

GREEN

WHITE

PWR

GND

NEG PWR LINE 2

GND

PWR LINE 1

WHITE

GREEN

BLACK

230 Vac 50-60 Hz 0.38A

OUTPUT

30-60 Vac 700mA - 800mA

CLASS P, TYPE 1, RATING: A

"RS" ELECTRONIC BALLAST

GREEN

WIRE NUTS

LAMP

2X RED

2X BLUE

SIDE OF BALLAST

INPUTS

BLACK

GREEN

WHITE

WHITEBLACK

WHITE

WARNING:

Turn off power at main source before making any

electrical connections or servicing the unit.

1. A licensed electrician should make all electrical connections. Make

sure the unit is grounded by connecting to the pool equipments bond

wire to comply with local electrical codes. See wiring diagram (Fig. 4).

2. Turn off power to the filtration system pump at the circuit breaker.

3. Install an approved seal tight flex conduit (not included) rated for

outdoor use between the Clear O3®unit and filtration system pump

time clock with the wires running inside (Fig. 5A & 5B). Electrical

connections should be facing downward.

4. Connect green ground wire to the time clock ground bar (Fig. 6A). The

Clear O3®unit is set to 240VAC to be connected to the load side (Fig.

6B) of the filtration pump time clock. The ballast may be switched to

120VAC if needed (Fig. 7). See wiring diagram (Fig. 4). ( o to page

21-23 for complete instructions on changing the ballast setting)

MAKING ELECTRICAL CONNECTIONS (CONT.)

For technical assistance call 1.800.621.5886 or contact your regional representative

Fig. 5A Fig. 5B

Fig. 6B

Fig. 6A

Fig. 7

round Lug

MAKING ELECTRICAL CONNECTIONS (CONT.)

For technical assistance call 1.800.621.5886 or contact your regional representative

The Clear O3®should

run with the filter pump

as the filter pump

creates the air draw

through the unit needed

to create ozone. Do not

set the Clear O3®to run

when the filter pump is

off and not pulling air

through the unit.

5. Use external ground lug

to connect the Clear O3®

to the pool pump ground

bond. (Fig. 8)

6. Turn on power to filtration

system pump. Check glow

tube on the left front of the

Clear O3®. A light blue light

indicates lamp is lit and the

unit should be producing

ozone. (Fig. 9)

Fig. 9

Fig. 8

round Lug

Light Blue low Tube

WARNING:

UV light produced by this unit is harmful to the

eyes and may cause blindness! Do not look

directly at a lit bulb!

For technical assistance call 1.800.621.5886 or contact your regional representative

MAKING PL MBING CONNECTIONS

1. Turn off power to the filtration

system pump at the circuit

breaker.

2. ump strainer pot

installation: (Fig. 10)

2.1 Check pump elevation

above water level. Refer to

(Chart 1) for proper check

valve selection. The 0.5 lb

valve comes standard with

Clear O3® and others are

available to order

seperately.

2.2 Remove strainer pot plug. If

there is an O-Ring on plug

take O-Ring off of pot plug

and slide over threaded end

of check valve.

2.3 Wrap the check valve four

times with teflon tape and

install into the strainer pot

plug-hole. Add more tape

if valve does not seal.

(Fig. 11)

Fig. 10

Fig. 11

Chart 1

Pump Elevati n Ab ve

Water Level

Check Valve

Rating Part Numbers

1’ (30cm) 0.5 lb 005-402-1250-00

2’ (60cm) 1.5 lb 005-402-2502-00

4’ (120cm) 3.0 lb 005-401-2503-00

5’ (150cm) 4.0 lb 005-401-2504-00

Andere Handbücher für Clear 03

Inhaltsverzeichnis

Andere Paramount Fitness Wasserfiltersystem Handbücher

Paramount Fitness

Paramount Fitness Ultra UV2 Installationsanleitung

Paramount Fitness

Paramount Fitness MDX-R3 Programmierhandbuch

Paramount Fitness

Paramount Fitness UltraUV Gebrauchs- und Pflegehandbuch

Paramount Fitness

Paramount Fitness clear o3 Bedienungsanleitung

Paramount Fitness

Paramount Fitness ClearO3 Bedienungsanleitung

Paramount Fitness

Paramount Fitness Paralevel Installations- und Betriebshandbuch

Paramount Fitness

Paramount Fitness Clear 03 Bedienungsanleitung

Paramount Fitness

Paramount Fitness clear o3 Bedienungsanleitung

Paramount Fitness

Paramount Fitness SDX 2 Bedienungsanleitung

Paramount Fitness

Paramount Fitness MDX2 retro Bedienungsanleitung

Beliebte Wasserfiltersystem Handbücher anderer Marken

Wisy

Wisy LineAir 100 Bedienungsanleitung

Schaffner

Schaffner Ecosine FN3446 Series Betriebsanleitung

Pentair

Pentair FLECK 4600 SXT Benutzerhandbuch

H2O International

H2O International H20-500 Bedienungsanleitung

Renkforce

Renkforce 2306241 Bedienungsanleitung

Neo-Pure

Neo-Pure TL3-A502 Bedienungsanleitung

FLTR

FLTR OBF Bedienungsanleitung

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Bedienungsanleitung

Applied Membranes

Applied Membranes W-G844EM Bedienungsanleitung

BEGA

BEGA 116 Bedienungsanleitung

WATA

WATA Standard Bedienungsanleitung

Price

Price FFU series Handbuch

Gaggenau

Gaggenau BRITA INTENZA 467873 Bedienungsanleitung

Brita

Brita SAFF-100 Bedienungsanleitung

HEISSNER

HEISSNER FPU24000-00 Bedienungsanleitung

BGS technic

BGS technic 1518 Bedienungsanleitung

Reverse Osmosis

Reverse Osmosis RF Series Bedienungsanleitung

ubbink

ubbink Filtramax Series Bedienungsanleitung