The adapter searches for other Bluetooth devices, but can only store 10
devices in its memory. You should therefore try again if synchronisation
does not succeed the rst time. After 30 seconds the adapter will switch off
automatically.
If pairing has been successful, the adapter will be connected and linked to
the other Bluetooth device. If the linked device is replaced, you will have to
pair them again.
2. Connecting the adapter
Connect the adapter to the communication radio or mobile phone.
• Press the On/Off button for at least two seconds. It will glow green while
connection is taking place, then briey ash green every ve seconds.
Adjust the volume of the connected device to the desired level.
3. Automatic switching of sound to communication radio
If a connected communication radio supports the feature, and if switching
is transferred electrically to the adapter, the sound can be automatically
switched to the speaker of a communication radio when the adapter does
not have a connection with the headset over the Bluetooth link.
4. Low battery level warning
When the battery is nearing the end of its useful life, the voltage will drop,
and when around ve minutes of battery life are left the adapter will sound
three low, short tones every 30 seconds to warn you that the battery should
be replaced as soon as possible. The LED on the adapter will glow red. The
adapter will be switched off automatically when the battery is discharged.
5. Range indications
If the range of the Bluetooth link is exceeded, you will hear a low-frequency
tone that lasts for two seconds every 30 seconds, and when the device is
back in range you will hear a short combination of tones with rising fre-
quency.
Also refer to the instructions for your Peltor WS headset.
6. Disconnection
• Press the On/Off button for at least two seconds. The LED will glow red for
one second to conrm disconnection.
The adapter can be switched off manually at any time and will be switched
off automatically after two hours if the headset is switched off or if it is out of
range. Even if it remains within range, it will be switched off 15 hours after
the last transmission.
IMPORTANT USER INFORMATION
• Do not store the adapter at temperatures above +60ºC
• The electronics in the adapter are approved for use at temperatures be-
tween -10ºC and +60ºC, but will also operate outside these limits.
• The material is only marginally affected by most chemical substances. If
you intend to use it in extreme environments, please contact your dealer
or Peltor for further information.
“This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.”
