5 6
TROUBLESHOOTING
Unit shows fully charged but unit
is not fully charged
unplug the charging adaptor and
then plug in again.
No response when pressing
power button
Low voltage protection may be
active. Recharge the battery unit.
Battery unit is generating
excessive heat
if charging a laptop, try removing
the laptop battery. If still hot,
disconnect, allow unit to cool and
charge again later.
INDICATOR/ALARM STATUS PROBABLE CAUSE/SOLUTION
Red indicator LED is blinking, fuse
holder alarms 1 long tone and 2
short tones.
Short circuit protection. Check
clamps for proper connection.
Red indicator LED is blinking, fuse
holder alarms, continuous tone.
Reverse connection protection.
Check clamps for proper
connection.
Red indicator LED is on. Over discharge protection. Check
Jump Starter battery indicator
LEDs; battery may be too low;
recharge jump starter. If jump
starter is full, there may be
insufficient amperage in the
vehicle’sbattery,anditmayneed
to be replaced.
The Red indicator LED is blinking
and black fuse holder alarms.
Reverse charge protection.
Disconnect jump starter from
battery.
Red and green indicator LEDs
light up together.
Over current protection. Vehicle
may require additional amperage,
and may not be able to be jumped
by this unit.
• Disconnect the plug from the power source before making any adjustments
or changing accessories. Such preventive safety measures reduce the risk
of starting the power tool accidentally.
• Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can
be attached to your power tool, it does not assure safe operation.
• Store idle equipment. When not in use, tools must be stored in a dry
location to inhibit rust. Always lock up tools and keep out of reach of
children and other untrained persons. Switch off all unused electrical tools
when stored. Disconnect battery from unit. Tools are dangerous in the
hands of untrained users.
• Properly dispose of batteries once depleted. Do not dispose of in a fire.
Check local regulations and follow proper disposal.
WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contains chemicals known [to the State of
California] to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
-Leadfromlead-basedpaints.
-Crystallinesilicafrombricksandcementorothermasonryproducts.
-Arsenicandchromiumfromchemicallytreatedlumber.
• Your risk from these exposures varies, depending on how often you do this
typeofwork.Toreduceyourexposuretothesechemicals:workinawell-
ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5, et seq.)
• The warnings, precautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
WARNING: BATTERIES CONTAIN ACID AND PRODUCE EXPLOSIVE
GASES. DO NOT OPERATE JUMP STARTER NEAR ANY OPEN FLAME OR
SPARKS. DO NOT SMOKE, EXTINGUISH ANY FLAMES, AND ALWAYS
WORK IN A WELL VENTILATED AREA.
WARNING: This product and its packaging contain a chemical known to the
State of California to cause cancer, birth defects, or other reproductive harm.
