Perle MCR200 Bedienungsanleitung

P/N 5500322-10

Perle MCR200

Installation Guide

Perle MCR200 Guide

Introduction

The Perle MCR200 Chassis is a 2 slot chassis able to

accommodate up to 2 Perle Media Converter modules or 1

Media Converter Module and an MCR-MGT management

Module.

Overview

This guide provides an overview of instructions necessary

for the installation and operation of the MCR200 chassis.

More detailed information is included with the Media

Converter modules or with the management card or this

information can be found on the website:

http://www.perle.com/

Getting to know the MCR200

Unpacking

The MCR200 shipping contents consist of the following

items:

•MCR200 - Two slot chassis

•Grounding screws (for improved chassis grounding)

•Country specific power adapter

•Power cord strain relief clip

•Rubber feet (for desktop installation)

•Installation guide (this guide)

Perle MCR200 Guide

Front and Rear Panel Components

Front View (with modules installed)

Rear View

Powering up the MCR200

Note: The MCR200 should always be grounded for safe and

proper operation. See Grounding the MCR200 Chassis

Install desired Perle modules following the instructions in

this guide or those supplied with the Module.

Using the Perle supplied power adapter, plug the power

cord into the power cord connector at the rear of the

chassis.

Plug the other end of the power adapter into an

appropriate power outlet.

Perle MCR200 Guide

Installing or Removing Modules:

Caution: Observe electrostatic discharge precautions when

installing or removing the Module(s) from the Chassis.

Failure to observe this caution could result in damage to the

Module(s) and/or chassis.

Installing:

If installing or replacing a Media Converter Module,

remove the Module from its packaging.

Using a cross-head screwdriver, remove the screw

holding the face plate (if installed), on the chassis, to

reveal the slot opening.

Set the Module’s DIP switches to the desired operating

mode (refer to the Installation Guide that came with the

Media Converter Module).

Locate the alignment guides inside the slot.

Using the alignment guides gently slide the module into

the slot until it becomes flush with the front of the

chassis. Light pressure may be needed to seat it

properly, however not force the module as this may

cause damage to the connector pins. If there is

resistance, remove the module and check both

connectors for any damage, before re-attempting.

Tighten the Captive retainer screw to ensure the module

is locked in place.

Note: An open slot in the chassis should be covered

with the supplied face plate (available as an accessory).

Removing:

Perle MCR200 Guide

Loosen the Captive retainer screw on the front of the

module and gently pull it towards you.

Once remove you will have access to any jumpers or

DIP switches on the Module that may need to be set.

If not re-inserting or replacing the Media Converter or

management Module then cover the opening slot with a

face plate and secure the screw.

Note: Blanking face plates are available as an accessory.

Grounding the MCR200 Chassis (Optional)

If your installation requires additional grounding the following

procedure can be followed.

Grounding the chassis requires the following items:

•One grounding lug (not provided)

•One 18 - 12 AWG wire (not provided)

•Cross-head screwdriver (not provided)

Note: For your safety, when installing this equipment, always

ensure that the chassis ground connection is installed first and

disconnected last.

Perle MCR200 Guide

Attaching the Grounding Lug

Attach the grounding lug to one end of an 18-12 AWG

wire.

Attach the grounding lug to the chassis and secure with

the grounding screw(s).

Attaching the Power Cord Strain Relief Clip

Feed the power cord through the opening in the power

cord relief clip.

Attach the power cord relief clip to the chassis and

secure with the provided screw.

Plug the power cord into the AC power connector at the

rear of the chassis.

Plug the other end of the power cord into an appropriate

power outlet.

Perle MCR200 Guide

Technical Specifications

Max Power Input/Consumption: 12 VDC/12 Watts

Operating Temperature: 0°C - 50°C (32°F - 122°F)

Storage Temperature: -25°C - 70°C (-13°F - 158°F)

Operating Humidity: 5% to 90% non-condensing

Storage Humidity: 5% to 95% non-condensing

Operating Altitude: Up to 3,048 m (10,000 ft)

Weight without modules: 0.566 kg (1.25 Lbs.)

Dimensions 175 mm 145 mm by 23 m

6.9” in. by 5.7” in. by .90” in.

Compliance Information

FCC

This product has been found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated

in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions in this Guide, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference, in which case the user will be required to correct the interference at

his/her own expense.

EN 55022 Class A

WARNING

This is a Class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take adequate

measures.

EN 55024 Class A

WARNING: Use of controls, adjustments or the performance of procedures other

than those specified herein may result in hazardous radiation exposure.

Perle MCR200 Guide

Warranty / Registration

Perle’s Systems Ltd. standard Lifetime Warranty

provides customers with return to factory repairs for

Perle products that fail under the conditions of the

warranty coverage. Details can be found at:

http://www.perle.com/support_services/warranty.shtml

Contacting Technical Support

Contact information for the Perle Technical Assistance

Center (PTAC) can be found at the link below. A

Technical Support Query may be made via this web

page.

www.perle.com/support_services/support_request.shtml

form without written permission from Perle Systems.

Inhaltsverzeichnis

Andere Perle Medienkonverter Handbücher

Perle

Perle S-1110HP-XT Bedienungsanleitung

Perle

Perle SMI Media Converter Bedienungsanleitung

Perle

Perle S-1110-XT 10 Bedienungsanleitung

Perle

Perle C-1110 Series Bedienungsanleitung

Perle

Perle S-10GRT-SFP Bedienungsanleitung

Perle

Perle S-10GT-SFP Bedienungsanleitung

Perle

Perle S-110-P Bedienungsanleitung

Perle

Perle C-110-XXXXX Bedienungsanleitung

Perle

Perle S-100MM-XXXXX Bedienungsanleitung

Perle

Perle S-1110HP Bedienungsanleitung

Perle

Perle C-10G-STS Bedienungsanleitung

Perle

Perle C-110-M2ST2 Bedienungsanleitung

Perle

Perle SMI Media Converter Bedienungsanleitung

Perle

Perle S-1110-XT Bedienungsanleitung

Perle

Perle MCR1900 Bedienungsanleitung

Perle

Perle CM-10G-STS Bedienungsanleitung

Perle

Perle S-1000-SFP Bedienungsanleitung

Perle

Perle S-10G-XTXH Bedienungsanleitung

Perle

Perle C-1000-XXXXX Bedienungsanleitung

Perle

Perle S-10GR-STS Bedienungsanleitung

Perle

Perle C-1110-XXXXX Bedienungsanleitung

Perle

Perle C-10GT-SFP Bedienungsanleitung

Perle

Perle C-10GRT-SFP Bedienungsanleitung

Perle

Perle MCR1900 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung