PheeNet MJCAS-210IR Bedienungsanleitung
MJPEG IP Camera
User Manual Version 2.1.7.1
MJCAS-210IR
Network Camera User’s Guide
2/83
© 2005.
Owner's Record
The model and serial numbers are located at the bottom. Record these numbers in the spaces provided
below. Refer to these numbers whenever you call upon your dealer regarding this product.
Model No. ______________ Serial No. ____________________
To prevent fire or shock hazard, do not expose the unit to rain or
moisture.
For AC Adaptor to avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
For customers in the U.S.A.
This equipment has been tested and found to comply with the limits for a digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void
your authority to operate this equipment.
The shielded interface cable recommended in this manual must be used with this equipment in
order to comply with the limits for a digital device pursuant to Part 15 of FCC Rules.
Declaration of Conformity
Network Camera User’s Guide
3/83
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTICE TO USERS
© 2005. All rights reserved. This manual or the software described herein, in whole or in part, may not
be reproduced, translated or reduced to any machine readable form without prior written approval.
WE PROVIDES NO WARRANTY WITH REGARD TO THIS MANUAL, THE SOFTWARE OR
OTHER INFORMATION CONTAINED HEREIN AND HEREBY EXPRESSLY DISCLAIMS
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY
PARTICULAR PURPOSE WITH REGARD TO THIS MANUAL, THE SOFTWARE OR SUCH
OTHER INFORMATION. IN NO EVENT SHALL WE BE LIABLE FOR ANY INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES, WHETHER BASED ON TORT, CONTRACT, OR
OTHERWISE, ARISING OUT OF OR IN CONNECTION WITH THIS MANUAL, THE
SOFTWARE OR OTHER INFORMATION CONTAINED HEREIN OR THE USE THEREOF.
We reserves the right to make any modification to this manual or the information contained herein at
any time without notice. The software described herein may also be governed by the terms of a
separate user license agreement.
Network Camera User’s Guide
4/83
Table of Contents
Overview ............................................................................................................................. 6
Package Contents................................................................................................................ 8
Connections......................................................................................................................... 9
Hardware Installation ....................................................................................................... 11
Logging in to Homepage................................................................................................... 12
Before Operation....................................................................................................... 12
Access the MJPEG IR IP Camera from the Internet Explorer for the first time....... 16
Logging in as an ordinary User................................................................................. 18
Logging in as an Administrator................................................................................. 18
Operating the MJPEG IR IP Camera............................................................................... 19
Control Panel ............................................................................................................ 20
Advanced Function Area........................................................................................... 22
Basic Setting ..................................................................................................... 22
System .......................................................................................... 23
Camera.......................................................................................... 25
Network ........................................................................................ 27
User............................................................................................... 33
IP Filter ......................................................................................... 34
FTP Client..................................................................................... 37
SMTP............................................................................................ 39
Schedule ....................................................................................... 41
Motion Detection.......................................................................... 42
Time Setting ................................................................................. 43
Network Camera User’s Guide
5/83
Popup............................................................................................ 45
Firmware upgrade:........................................................................ 46
Factory Default............................................................................. 49
Reboot........................................................................................... 50
Trigger............................................................................................................... 51
Capture.............................................................................................................. 52
RightMouseButton of ActiveX Control.............................................................................. 53
View Menu................................................................................................................ 54
“Image Recording…-> Save as JPEG” .................................................................... 60
“Save Current Picture As …” ................................................................................... 66
Appendix A: Troubleshooting & Frequently Asked Questions.......................................... 68
Appendix A: Troubleshooting & Frequently Asked Questions.......................................... 68
Appendix B: PING IP Address.......................................................................................... 73
Appendix C: Bandwidth Estimation.................................................................................. 74
Appendix D: Specifications............................................................................................... 75
Appendix E: Time Zone Table ........................................................................................... 77
Appendix F: DDNS Application........................................................................................ 79
Network Camera User’s Guide
6/83
Overview
This user’s guide explains how to operate the Infra-Red (IR) IP Camera from a computer.
Basically, the user’s guide is written to be read on the computer display. However, users
might consider printing it out to access easily and read it before you operate the MJPEG
IR IP Camera.
Introduction
This MJPEG IR IP Camera is an inexpensive fully scalable surveillance technology.
Because the MJPEG IR IP Cameras can be plugged in to your existing computer
network infrastructure, you will potentially save thousands of dollars on unnecessary
cabling. By using IR technology, this MJPEG IR IP Camera is not only working on day
but also on night.
The MJPEG IR IP Camera is accessible via the LAN or Internet connection. Connect
your MJPEG IR IP Camera directly to a computer network or DSL modem, and with a
standard Web browser you get instant, on demand video streams. Within minutes you
can set up the MJPEG IR IP Camera to capture a video sequence to a PC. Live video
image can be uploaded to a website for the world to see or made available only to select
users on the network.
Features:
zHigh quality 1/3” Sony CCD sensor
zComposite video output
zHigh-Light LED offers greater image quality and longer life span
z30M/50M IR distance
zJPEG video compression
zRemote-Control via Internet Explorer
zSupport statistic and dynamic IP address
zDDNS and PPPoE
zMulti-channel control software for surveillance application
zOn-line firmware upgrade
Network Camera User’s Guide
7/83
Application:
zRemote monitoring
zSurveillance
Minimum System Requirement
zMicrosoft Internet Explorer 5.0 or later
zVGA Monitor resolution 1024 x 768
zPentium 4 1.3GHz or above
zMemory Size: 256MB or above
zWindows ME, 2000, XP, or 2003
Network Camera User’s Guide
8/83
Package Contents
User can find the following items in the package:
MJPEG IR IP Camera x 1
RS-485 terminal x 1
Installation software and manual CD x 1
Quick installation guide
If any of the above items are missing, please contact your dealer immediately.
Network Camera User’s Guide
9/83
Connections
Rear Panel Connections:
1. RS-485: To connect to an indoor/outdoor Pan/Tilt scanner unit.
Definition of the RS-485:
Orange: D-
Blue: D+
2. LAN port: To connect to PC or Hub.
The LAN socket is an RJ-45 connector for connections to 10Base-T Ethernet or
100Base-TX Fast Ethernet cabling. This Ethernet port built NWay protocol can detect or
negotiate the transmission speed of the network automatically. Please use Category 5
“straight through” cable to connect the MJPEG IR IP Camera to a 100Mbps Fast
Ethernet network switch or hub.
Network Camera User’s Guide
10/83
3. AC power cord & Local Video out (BNC port)
The AC power input and video output cable are located on the MJPEG IR IP Camera’s
back panel. The input power is 85~260VAC..
The MJPEG IR IP Camera also provides composite video output. User can use BNC
video cable to connect the MJPEG IR IP Camera with a TV monitor or VCR.
Andere Handbücher für MJCAS-210IR
1
Inhaltsverzeichnis
Andere PheeNet IP-Kamera Handbücher
