Philips AVENT SCF430 Bedienungsanleitung
www.philips.com/mybreastpump
SCF430
Manual Breast
Pump
Tire-lait
manuel
Tiralatte
manuale
ﺐﻴﻠﺣ ﺔﻄﻓﺎﺷ
ﺔﻳوﺪﻴﻟا مﻷا
12
3 4 5
6
7
1
English
6English
Introduction
Welcome to Philips Avent! To learn more about Philips Avent product range,
visit us at www.philips.com/avent.
General description (Fig. 1)
Note: The numbers mentioned below refer to the numbers in the figure on
the front foldout page of this user manual.
1 Handle
2 Silicone diaphragm
3 Stem
4 Pump body
5 Cushion
6 White valve
7 Philips Avent Natural bottle
Intended use
The Philips Avent manual breast pump is intended to express and to collect
milk from the breast of a lactating woman. The device is intended for a single
user.
Important safety information
Read this user manual carefully before you use the breast pump and save it for
future reference.
Contraindication
- Never use the breast pump while you are pregnant, as pumping
can induce labor.
WARNING!
Warnings to avoid choking, strangulation and injury:
- Do not allow children or pets to play with the breast pump parts,
packaging materials or accessories.
- Inspect the breast pump for signs of damage before each use. Do not use
the breast pump if it is damaged or if it does not work properly.
Warnings to avoid contamination and to ensure hygiene:
- For hygienic reasons, the breast pump is only intended for repeated use by
a single user.
7
English
- Clean and disinfect all parts before first use and after each use.
- Do not use antibacterial or abrasive cleaning agents to clean the breast
pump parts as this may cause damage.
- Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the
inside of containers or lids.
Warnings to avoid breast and nipple problems including pain:
- Always release the handle before you remove the pump body from your
breast in order to release the vacuum.
- If the vacuum is uncomfortable or causes pain, stop pumping and remove
the breast pump from your breast.
- Do not continue pumping for more than five minutes at a time if you do
not succeed in expressing any milk. Try to express at another time during
the day.
- If the process becomes very uncomfortable or painful, stop using the pump
and consult your healthcare professional.
- Only use accessories and parts recommended by Philips Avent.
- No modification of the breast pump is allowed.
Warning: If you are infected with Human Immunodeficiency Virus (HIV) or
Hepatitis B or C, using the breast pump will not reduce or remove the risk of
transmitting the virus to your baby through breast milk.
Caution
Caution to prevent damage to and malfunctioning of the breast pump:
- Keep the parts away from heated surfaces to avoid deformation of these
parts.
Preparing for use
Disassemble, clean and disinfect all parts before you use the breast pump for
the first time and after every use.
Caution: Be careful when you remove and clean the white valve. Do not
insert objects into the white valve, as this may cause damage.
Cleaning and disinfecting
Step 1: Disassembling
Disassemble the breast pump and bottle completely. Also remove the white
valve from the pump body and the stem from the silicone diaphragm.
8English
Step 2: Cleaning
The parts can be cleaned manually or in the dishwasher.
Step 2A: Manual cleaning
1Rinse all parts under a running tap with lukewarm water.
2Clean all parts with a cleaning brush in warm water with some mild
dishwashing liquid.
3Thoroughly rinse all parts under a running tap with cold clear water.
4Leave all parts to air-dry on a clean tea towel or drying rack.
Step 2B: Cleaning in the dishwasher
Note: Food colorings may discolor parts.
1Place all parts on the top rack of the dishwasher.
2Put dishwashing liquid or a tablet in the machine and run a standard
program.
3Leave all parts to air-dry on a clean tea towel or drying rack.
Step 3: Disinfecting
Caution: During disinfection with boiling water, prevent the
bottle or other parts from touching the side of the pot. This can
cause irreversible product deformation or damage that Philips
cannot be held liable for.
1Fill a household pot with enough water to cover all parts and place all parts
in the pot. Let the water boil for 5minutes. Make sure the parts do not
touch the side of the pot.
2Allow the water to cool down.
3Gently remove the parts from the water. Place the parts on a clean surface,
tea towel or drying rack to air-dry.
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that
come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump
parts by boiling them, they can be very hot. To prevent burns, only
start assembling the breast pump when disinfected parts have
cooled down.
Check the breast pump kit parts for wear or damage before use and replace
them if necessary.
9
English
Note: Correct placement of the cushion and the silicone diaphragm is
essential for the breast pump to form a proper vacuum.
Note: The figure numbers mentioned below refer to the numbers of the
figures on the back foldout page of this user manual.
1Insert the white valve into the pump body from underneath. Push the valve
in as far as possible (Fig. 2).
2Screw the pump body clockwise onto the bottle until it is securely fixed
(Fig. 3).
3Push the stem into the silicone diaphragm fully to the end (Fig. 4).
4Insert the silicone diaphragm into the pump body from above. Make sure it
fits securely around the rim by pressing down with your fingers to ensure a
perfect seal (Fig. 5).
5Attach the handle onto the diaphragm with stem by hooking the hole in
the handle over the end of the stem. Push down the handle onto the pump
body until it clicks into place (Fig. 6).
6Place the cushion into the pump body (Fig. 7) and make sure that the rim
covers the pump body. Push the inner part of the cushion into the funnel.
Make sure that you push the cushion inwards completely, up to the line
indicated with an arrow on the pump body (Fig. 8).
Using the breast pump
Warning: Always use the breast pump with the cushion.
Note: Contact your healthcare professional in case of questions or if you
experience side effects.
Operating the breast pump
1Wash your hands thoroughly with soap and water and make sure that your
breast is clean.
2Press the assembled pump body against your breast. Make sure that your
nipple is centered, so that the cushion creates an airtight seal.
3Gently start to press down the handle until you feel the suction on your
breast (Fig. 9). Then allow the handle to return to its resting position.
Repeat this step rapidly 5 or 6times to initiate the ‘let-down’ reflex.
Note: You do not have to press down the handle fully. Press it down as
much as is comfortable for you. Your milk will soon start flowing, even
though you are not using all the suction the pump can generate.
10 English
4When the milk starts flowing, adopt a slower rhythm by pressing down the
handle and keeping it pressed down for a moment before you let it return
to its resting position. Continue with this rhythm while your milk is flowing.
If your hand becomes tired, try to use the other hand or pump from the
other breast.
Note: Do not worry if your milk does not flow immediately. Relax and
continue pumping. Repositioning the breast pump on your breast from
time to time can help stimulate milk flow.
5Continue pumping until you feel your breast is empty.
6When you have finished expressing, carefully remove the breast pump
from your breast and unscrew the bottle or storage cup from the pump
body. Clean the other used parts of the breast pump (see 'Cleaning and
disinfecting').
After use
Warning: Only store breast milk collected with a clean and
disinfected pump.
If you intend to feed your baby with the expressed breast milk within 4days,
you can store the breast milk in the refrigerator in an assembled Philips Avent
bottle or storage cup. Otherwise, you can store breast milk in the freezer for up
to 6months.
1To store the breast milk, pour the milk in a cleaned and disinfected bottle,
storage cup or in a new breast milk storage bag. Make sure you properly
close it to avoid leakage.
2Disassemble and clean all parts that have been in contact with breast milk
(see 'Cleaning and disinfecting').
Warning: Refrigerate or freeze expressed breast milk immediately,
label with date and time, or keep it at a room temperature for a
maximum of 4hours before you feed your baby. Never refreeze
thawed breast milk to avoid a decrease in milk quality. Never add
fresh breast milk to frozen breast milk to avoid a decrease in milk
quality and unintended thawing of the frozen milk.
Note: For more information about the breast pump and tips for expressing
milk, visit www.philips.com/avent.
Andere Handbücher für AVENT SCF430
2
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere Philips Brustpumpe Handbücher
Philips
Philips AVENT SCF396 Bedienungsanleitung
Philips
Philips Avent Premium Plus SCF394/11 Bedienungsanleitung
Philips
Philips AVENT Bedienungsanleitung
Philips
Philips AVENT SCF301/02 Bedienungsanleitung
Philips
Philips Avent SCF393/61 Bedienungsanleitung
Philips
Philips Isis Bedienungsanleitung
Philips
Philips SCF304 Bedienungsanleitung
Philips
Philips SCF330 Bedienungsanleitung
Philips
Philips AVENT SCF300 Bedienungsanleitung
Philips
Philips SCF330 Bedienungsanleitung
Philips
Philips AVENT SCF430 Bedienungsanleitung
Philips
Philips AVENT SCF397 Bedienungsanleitung
Philips
Philips SCF294 Bedienungsanleitung
Philips
Philips AVENT SCF300/20 Bedienungsanleitung
Philips
Philips SCF330 Bedienungsanleitung
Philips
Philips AVENT SCF363/11 Bedienungsanleitung
Philips
Philips SCF300/60 Bedienungsanleitung
Philips
Philips AVENT SCF310/60 Bedienungsanleitung
Philips
Philips Avent SCF308/02 Bedienungsanleitung
Philips
Philips SCF300/13 Bedienungsanleitung
