Philips DVR7100/75 Bedienungsanleitung

Service Manual

Service

DVR5100/75 & DVR7100/75

transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise

without the prior permission of Philips.

Published by ZW-KC 0716 AV System Printed in The Netherlands Subject to modification

3139 785 32780

HDD Recorder

Version 1.0

TABLE OF CONTENT

1 General

1.1 Scope

1.2 Operating Conditions

2 H/W Speci ication

3 Adjustment & Setting

3.1 Re-install the set to actory settings a ter repair

3.2 Re- ormat HDD

4 S/W Upgrade Procedure

5 Troubleshooting Flowchart

6 Block Diagram & Wiring diagram

7 Mechanical Exploded view & Packaging drawing

8 Service Parts list

9 Annex - Circuit Diagram attachments

1. General

1. 1 Scope

This is the product sheet for the High-Definition (HD) Free to Air (FTA) MPEG2

Digital Video ecorder Set top box (STB) model DV 5100/75 with 160GB HDD and

DV 7100/75 with 250GB HDD. This HD DV is fully MPEG2 / DVB-T compliant,

supporting channel frequencies range of 51 – 858MHz.

DV 5100/75 and DV 7100/75 is a custom made product for Philips Consumer

Electronics, and has HDMI feature connectors for Digital Audio/Video output along

with S-Video, YPbPr and Composite connectors.

1.2. Operating Conditions

Operating Temperature : +/- 0°C ~ +55°C

Before delivery of the product, the supplier shall submit the specification drawing, the

sample, the test report and the QC (quality control) process flow chart to Philips

Singapore.

2. Hardware Speci ication

System

Tuners: Two digital HD tuners (to receive digital

transmission, see Basic Connection page 12-15)

Transmission standards: DVB-T

Channel coverage: 51 - 858 MHz. The above channel coverage merely ensures the

channel reception within these ranges. It does not guarantee the ability to receive signals in

all circumstances.

Aerial out: 75-ohm asymmetrical aerial socket

Video ormat: MP@ML, MP@HL

Audio ormat: Dolby Digital, MPEG (I and II)

Outputs

AUDIO OUT: CA jacks (2 each)/2 Vrms/10 kilo ohms

VIDEO OUT: CA jack/1.0 Vp-p/75 ohms

S VIDEO OUT: 4-pin mini DIN/Y:1.0 Vp-p,C: 0.3 Vp-p (PAL)/75 ohms

DIGITAL AUDIO OUT (OPTICAL): Opticaloutput jack/–18 dBm (wave length: 660

nm)

DIGITAL AUDIO OUT (COAXIAL): CAjack/0.5 Vp-p/75 ohms

COMPONENT VIDEO OUT

(Y, PB/CB, PR/CR):

CA jack/Y: 1.0 Vp-p, PB/CB: 0.7 Vp-p,

P /C : 0.7 Vp-p/75 ohms

HDMI OUT:Type A (19-pin)

General

Power requirements: 220-240 V AC, 50 Hz

Power consumption:

DV 7100 : 30 W

DV 5100 : 29 W

Dimensions (approx.): 430 _ 80 _ 290 mm

(width/height/depth) incl. projecting parts

Hard disk drive capacity:

DV 7100 : 250GB

DV 5100 : 160GB

Mass (approx.): 4.0 kg

Operating temperature: 5ºC to 40ºC

Storage temperature: -40ºC to +65ºC

3. Adjustments & Settings :

3.1 Re-install the Set to Factory Settings a ter Repair:

Goto Main Menu -> General -> Reset settings:

This feature enables you to return the setup settings to their defaults without affecting

the recorded titles in the HDD.

Select { Yes }, and press OK.

The setup settings return to their defaults, and the recorder automatically turns off.

3.2 Re- ormat HDD:

Goto Main Menu -> HDD Setting -> Erase HDD:

Erases all the recorded titles in the HDD at once. Note that protected titles are also

erased.

Press OK to confirm and press BACK to exit.

4. S/W UPGRADE PROCEDURE

4.1 Use a crossover RS232 cable to connect ZINWELL Set-top Box and PC COM

port.

4.2 On PC side:

Launch Hyperterminal in MS Windows, and set the parameters as follow “115200-N-

8-N”. (It is in “Programs”-> “Accessories-> “Communication” -> “Hyperterminal” )

Enter the properties setting page:

Set the COM port

Press Configure Button to Configure

Setting the configure as following picture:

All settings are done. Press Call button to connect the Set-top box.

4.3 On Set-top box side:

Use OSD to upgrade s/w. Then you see “C C C C ...” shown on PC Hyperterminal

screen.

4.5 On PC side:

Enter Hyper terminal menu, “ Transfer” -> “Send file” -> “B OWSE”, and select new

software file (set protocol in 1K Xmodem)-> press “Send”

Ps. Set-top-box will wait PC to transmit the s/w. If you doesn’t send file to box, it will

timeout then exit the upgrade status. You should redo these actions again.

“Transfer” -> “Send file” -> “B OWSE”, and select new software file (set protocol in

1K Xmodem)-> press “Send”

6. When s/w update completed, the box will shut down automatically.

7. Restart box, it will boot up with new so tware.

Andere Handbücher für DVR7100/75

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Philips Diktiergerät Handbücher

Philips

Philips VTR7610 Bedienungsanleitung

Philips

Philips LFH9398/00 Bedienungsanleitung

Philips

Philips 9600 SERIES Bedienungsanleitung

Philips

Philips LFH0955/12 Bedienungsanleitung

Philips

Philips VoiceTracer VTR5166 Bedienungsanleitung

Philips

Philips LFH7655 - Digital Voice Tracer 7655 64 MB... Bedienungsanleitung

Philips

Philips speechair psp1000 series Bedienungsanleitung

Philips

Philips VTR8060 Bedienungsanleitung

Philips

Philips VoiceTracer DVT2050 Bedienungsanleitung

Philips

Philips VOICE TRACER DVT2510 Bedienungsanleitung

Philips

Philips LFH0655/00 Bedienungsanleitung

Philips

Philips VTR8000 Bedienungsanleitung

Philips

Philips Voice Tracer LFH0888 Bedienungsanleitung

Philips

Philips Voice Tracer LFH0646 Bedienungsanleitung

Philips

Philips SpeechExec Pro Dictate 11.5 Bedienungsanleitung

Philips

Philips Voice Tracer LFH0652 Bedienungsanleitung

Philips

Philips Voice Tracer LFH0895/00 Bedienungsanleitung

Philips

Philips SpeechMike Premium Bedienungsanleitung

Philips

Philips Pocket Memo LFH9380/27 Bedienungsanleitung

Philips

Philips AQ 6345 Bedienungsanleitung

Philips

Philips DPM6700 Bedienungsanleitung

Philips

Philips LFH 0388 Bedienungsanleitung

Philips

Philips DPM8000 Leitfaden

Philips

Philips voice tracer DVT1200 Bedienungsanleitung

Beliebte Diktiergerät Handbücher anderer Marken

Sony

Sony ICD-UX533F Bedienungsanleitung

RCA

RCA VR5230 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics BULLSHOOTER ENDLESS LOOP BS2C Benutzerhandbuch

Sony

Sony TCM-400DV Bedienungsanleitung

LogTag

LogTag TREL30-16 Bedienungsanleitung

SVAT

SVAT CVP800 Bedienungsanleitung

Marantz

Marantz PMD620 Bedienungsanleitung

Zoom

Zoom H4next Bedienungsanleitung

Roland

Roland BR-900CD Bedienungsanleitung

JVC

JVC ProHD GY-HMZ1U Bedienungs- und Wartungshandbuch

Panasonic

Panasonic PQT8531-P Bedienungsanleitung

Sanyo

Sanyo TRC-6400 Bedienungsanleitung

Tascam

Tascam DR-07 Bedienungsanleitung

Olympus

Olympus DW-90 Bedienungsanleitung

Sanyo

Sanyo ICR-B150 Bedienungsanleitung

Korg

Korg D4 Bedienungsanleitung

Sony

Sony ICD-SX46 - Ic Recorder Bedienungsanleitung

Olympus

Olympus DIGITAL VOICE RECORDER WS-200S Montageanleitung