Picote Soluons Oy Ltd 9www.picoteinstute.com
Ensure that the supply voltage is correct. The voltage of the power source must be within the voltage
range given on the nameplate of the machine.
The machine should be connected only to a 3 phase 400-480 V power supply as indicated on the name-
plate, and can only be operated on three-phase AC supply rated for at least 16 A current
(EU/UK) and 30A (USA). The machine has been double-sealed according to European standards. The
power source has to be grounded. The frequency transformer of the motor can cause residual current device to
go o. If this happens frequently, change the power source to one with slower residual current device. Residual
current device should be type A and residual current permission should be 30 mA. Use only residual current de-
vices which are permied in power feed from main power source.
SAFETY FEATURES
There is a safety gear with a Lock/Emergency Stop Buon on the machine. The power supply to the
motor is cut o when the Emergency Stop Buon is pushed. Always make sure the Emergency Stop
Buon is pressed or completely unplug the machine when the machine accessories (e.g. Cuer or
Grinding Chains) are not inside the drain. An addional on/o switch is located in the main frame of the
machine for increased safety of operaon.
The machine has an Operator Presence Control or ‘OPC’ (foot control). When the control is not held down, the
machine stops. OPC is the most important safety device of the Miller machines. Never place anything in place of a
foot (for example a brick).
POWER PLUGS
For safety purposes, this machine may be equipped with a specialty plug. If the plug does not t securely or match
the outlet, do not force it — contact an electrician to determine the required power supply. Never alter the plug in
any way. Use the plug with an extension cord only if it can be fully inserted into the cord’s socket. Use the Maxi
Miller Power+ with a heavy duty extension cord only.
EU/UK extension cord lead minimum thickness is 2.5 mm2 / 14 AWG.
USA extension cord lead minimum thickness is 4.0 mm2 / 12 AWG.
If a power generator is used, make sure that power rang is sucient, at least 8 kVA measured, connuous
output. Only a clean and stable sine wave is acceptable. Contact your reseller or Picote Soluons technical support
for more informaon.
400/480 V The Maxi Miller Power+ (EU/UK) is equipped with a 5-pin
400 V / 16Amp plug and for the USA a 480V / 30Amp plug. The plug ts into a
three-phase 400 V socket shown in the picture on the le. The Maxi Miller
Power+ must be supplied with sucient power and proper current rang.
If power generator is used, minimum of 8 kVA is
required. An adapter is provided to connect the Maxi Miller Power+ into a
5-pin 400 V / 32 A socket.
Other adapters may be necessary for use with a generator
connecons.
The machine has an automac safety clutch which shuts down the machine when the tools get stuck.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
VOLTAGE & POWER SUPPLY
3
