Pioneer DE-SH9101 Handbuch

PRODUCT INFORMATION BULLETIN No. PB _ _ _ _ _ _ _ _-0198

Optical Drive Summary

Page 1of 5

Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111

There have been five (5) series of Pioneer optical drives: 5000, 5100, 7000, 7100 and 9100. The 5000,

5100 and 7000 series were all SCSI-1 type devices and are no longer in production. The 7100 and 9100

series are switchable SCSI-1 and SCSI-2 devices and are still being produced.

NOTE: SCSI-2 is the current prevalent industry standard.

DE-7001 Series

The DE-7001 series includes the DE-S7001 and DE-U7001 models. The DE-S7001 is an external

subsytem including drive unit, SCSI controller and DC power supply. The DE-U7001 is an internal full

height drive unit with SCSI controller. Both models use the DEC-702 rewritable (MO) magneto-optical

disk media and the DC-502AWORM (Write Once Read Many) optical disk media.

The 7001 series drives must be set to Mode 0 when using Rewritable media and to Mode 1 when using

WORM media. The settings of the dip switch bits 7 and 8 determine which mode the drive is set to. The

dip switch is located on the rear of the DE-S7001 and on the controller board of the DE-U7001.

The bit settings are read by the controller at Power ON and RESET. If the settings of the bits have

changed, the unit must be reset or turned OFF and then ON before the new setting will take place.

IMPORTANT: You should only change the bit settings when power to the device is OFF.

NOTE: The Mode setting may also be changed by sending the SCSI command CHANGE MODE. Refer

to the SCSI specifications for the corresponding drive for more details.

The Modes are set as described in the table below:

Mode Bit 7 Bit 8 Name Description

0OFF OFF Rewritable Mode Read and write operations are enabled only with ISO

standard (sampled servo format) rewritable disks. Read

and write operations with WORM disks are disabled.

1OFF ON WORM Mode Read and write operations are enabled only with ISO

standard (sampled servo (SS) format WORM disks.

Read and write operations with rewritable disks are

disabled.

PRODUCT INFORMATION BULLETIN No. PB _ _ _ _ _ _ _ _-0198

Page 2of 5

Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111

The 7000 series drives have two BUSY LEDs. One is labeled RW for Rewritable and the other is labeled

WO for WORM.

When the drive is in Mode 0 (Rewritable), WO is OFF and RW blinks when no disk in inserted. If WO is

blinking, the drive detects the presence of a WORM disk. If RW is ON, the disk detects a rewritable disk.

When the drive is in Mode 1 (WORM), RW is OFF and WO blinks when no disk in inserted. If RW is

blinking, the drive detects a rewritable disk. If WO is ON, the drive detects a WORM disk.

DE-H7101 Series

The DE-H7101 series includes the DE-UH7101 and DE-SH7101 models. The DE-UH7101 is an internal

5.25-inch half-height multifunction optical disk drive. The DE-SH7101 is an external half-height

multifunction optical disk drive subsystem. Both use the media types DEC-702 magneto-optical disk and

DEC-502AWORM optical disk.

The DE-H7101 series optical drives fit into industry standard 5.25-inch half-height drive bays. They

conform to ISO 9171 and ISO 10089 (Format B) standards for true Write Once and Rewritable media

and are compatible with DE-7001 series multifunction drives. The DE-H7101 series support SCSI-2.

The 7101 series drives must be set to Mode 0 or Mode 2 when using Rewritable media and to Mode 1 or

Mode 2 when using WORM media. The drives must be set to Mode 2 when used as a SCSI-2 device.

The drive mode is determined by the settings of the dip switch bits 4 and 5. The dip switch is located on

the rear of the drives.

NOTE: The DE-UH7101 has jumper settings instead of a dip switch. The jumper is set by shorting the

pins. Pins 7 and 8 correspond to bits 4 and 5, respectively.

NOTE: The bit settings are read by the controller at Power ON and RESET. If the settings of the bits

have changed, the unit must be reset or turned OFF and then ON before the new setting will take place.

IMPORTANT: You should only change the bit settings when power to the device is OFF.

PRODUCT INFORMATION BULLETIN No. PB _ _ _ _ _ _ _ _-0198

Page 3of 5

Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111

The Modes are set as described in the table below (factory default is Mode 0):

Mode Bit 4 Bit 5 Name Description

0OFF OFF Rewritable Read and write operations are enabled only with ISO

standard (sampled servo format) rewritable disks. Read and

write operations with WORM disks are disabled. (DE-

C7001)

1ON OFF WORM Read and write operations are enabled only with ISO

standard (sampled servo (SS) format WORM disks. Read

and write operations with rewritable disks are disabled.

SCSI specifications are same as that of DD-5101 series

except DE-SH7101 enables RDBC (Read Blank Check) as

default. (DD-C5001)

2OFF ON SCSI-2 Read and write operations are enabled with both ISO

standard (sampled servo (SS) format) rewritable and

WORM disks. SCSI specifications are based on SCSI-2.

(DE-C7101)

IMPORTANT: Because Mode 2 supports both WORM and MO type media as well as SCSI-2

command set, it is recommended that the user use the drive in Mode 2.

The 7101 series has a dual-color BUSY LED. The meaning of the light indications of the LED is listed in

the table below.

Drive Status Rewritable Mode WORM Mode

no disk inserted flashing green flashing yellow

MO disk present dim flashing yellow

WORM media present flashing green dim

BUSY steady green steady yellow

overheat orange orange

Note: The two colors of the LED are yellow and green. When both colors are lit, the result is orange.

DE-SH9101

The DE-SH9101 is a half-height external multifunction optical disk drive subsystem that can handle large

capacity (1.7 GB) utilizing the sampled servo format Multiplexed Address Sampled Servo (MASS).

MASS is a high density data recording system.

PRODUCT INFORMATION BULLETIN No. PB _ _ _ _ _ _ _ _-0198

Page 4of 5

Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111

The DE-SH9101 uses both MASS format optical disks and ISO standardized Type-B format (SS) optical

disks (MO and WORM). It is upward compatible with the DE-SH7101 optical drive.

The media types used by the DE-SH9101 are the DEC-17GMO rewritable (MO) 1.7GB capacity

magneto-optical disk, DC-17GWO 1.7 GB capacity WORM (write once read many) optical disk, DEC-

702 654 MB capacity MO disk, and DC-502A654 MB capacity WORM disk.

The SCSI command set for the 9101 conforms to the 7101 series SCSI specifications (upward

compatible Mode 0, Mode 1 and Mode 2). It has plug-in compatibility with DE-7001 or DD-5101 (Mode

0 and Mode 1).

The 9101 supports both synchronous and asynchronous data transfers.

The DE-SH9101 drive must be set to Mode 0 or Mode 2 when using Rewritable media and to Mode 1 or

Mode 2 when using WORM media. The drive must be set to Mode 2 when used as a SCSI-2 device. The

drive mode is determined by the settings of the dip switch bits 4 and 5. The dip switch is located on the

rear of the drive.

IMPORTANT: Because Mode 2 supports both WORM and MO type media as well as SCSI-2

command set, it is recommended that the user use the drive in Mode 2.

NOTE: The bit settings are read by the controller at Power ON and RESET. If the settings of the bits

have changed, the unit must be reset or turned OFF and then ON before the new setting will take place.

IMPORTANT: You should only change the bit settings when power to the device is OFF.

The Modes are set as described in the table on the next page (factory default is Mode 0):

PRODUCT INFORMATION BULLETIN No. PB _ _ _ _ _ _ _ _-0198

Page 5of 5

Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111

Mode Bit 4 Bit 5 Name Description

0OFF OFF Rewritable Read and write operations are enabled only with ISO

standard (sampled servo format) rewritable disks. Read and

write operations with WORM disks are disabled. (DE-

C7001)

1ON OFF WORM Read and write operations are enabled only with ISO

standard (sampled servo (SS) format WORM disks. Read

and write operations with rewritable disks are disabled.

SCSI specifications are same as that of DD-5101 series

except DE-SH7101 enables RDBC (Read Blank Check) as

default. (DD-C5001)

2OFF ON SCSI-2 Read and write operations are enabled with both ISO

standard (sampled servo (SS) format) rewritable and

WORM disks. SCSI specifications are based on SCSI-2.

(DE-C7101)

The DE-SH9101 series has a dual-color BUSY LED. The meaning of the light indications of the LED is

listed in the table below.

Drive Status Mode 0 Mode 1

no disk inserted flashing green flashing yellow

MO disk present dim flashing yellow

WORM media present flashing green dim

BUSY steady green steady yellow

overheat orange orange

Note: The two colors of the LED are yellow and green. When both colors are lit, the result is orange.

Andere Handbücher für DE-SH9101

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Pioneer DVD-Laufwerk Handbücher

Pioneer

Pioneer dvr 106 - DVD RW Drive - IDE Bedienungsanleitung

Pioneer

Pioneer PRA-DW11 Bedienungsanleitung

Pioneer

Pioneer DVR-710 Installationshandbuch

Pioneer

Pioneer LaserMemory DVD-U02 Bedienungsanleitung

Pioneer

Pioneer DRM-3000 Bedienungsanleitung

Pioneer

Pioneer DVD-304S Bedienungsanleitung

Pioneer

Pioneer DVR-XD10 Bedienungsanleitung

Pioneer

Pioneer DVR 115D - DVD±RW Drive - IDE Bedienungsanleitung

Pioneer

Pioneer DVR-A04 Bedienungsanleitung

Pioneer

Pioneer DE-UH7101 Montageanleitung

Pioneer

Pioneer DCR-111 Bedienungsanleitung

Pioneer

Pioneer DVR-S201 Bedienungsanleitung

Pioneer

Pioneer DVR-A03-J Bedienungsanleitung

Pioneer

Pioneer LaserMemory DVD-303S Bedienungsanleitung

Pioneer

Pioneer BDR-XD07UHD Bedienungsanleitung

Pioneer

Pioneer DVR-1910LS - DVD±RW / DVD-RAM Drive Bedienungsanleitung

Pioneer

Pioneer DVR-S20MBK Bedienungsanleitung

Pioneer

Pioneer DVR-115D Series Bedienungsanleitung

Pioneer

Pioneer DVD-R7783 Bedienungsanleitung

Pioneer

Pioneer DVR-116D Bedienungsanleitung

Pioneer

Pioneer DVD-D7563 Bedienungsanleitung

Pioneer

Pioneer DVR 117D - DVD±RW Drive - IDE Bedienungsanleitung

Pioneer

Pioneer LaserMemory DVD-117 Bedienungsanleitung

Pioneer

Pioneer DVR-115DBK Bedienungsanleitung

Beliebte DVD-Laufwerk Handbücher anderer Marken

Panasonic

Panasonic CFVDM732U - DVD Bedienungsanleitung

LG GSA-4160B Bedienungsanleitung

Panasonic

Panasonic VW-BN1 - DVD-RW / DVD-RAM Drive Bedienungsanleitung

Sony

Sony DRU-500AX Bedienungsanleitung

LG GSA-2164D Bedienungsanleitung

Plextor

Plextor PX-755SA Bedienungsanleitung

Samsung

Samsung SM-332B Bedienungsanleitung

Freecom

Freecom MOBILE DVD RW II Bedienungsanleitung

Plextor

Plextor PX-712 Bedienungsanleitung

NEC

NEC ND-3550A Bedienungsanleitung

Emprex

Emprex Slim Writer DVD R/RW USB 2.0 External Drive Bedienungsanleitung

Philips

Philips PCA532K Bedienungsanleitung

Sony

Sony AD-7740H Bedienungsanleitung

Philips

Philips PCDV5016 Series Referenzhandbuch

Samsung

Samsung SE-S224Q Bedienungsanleitung

IBM

IBM 71P7285 Bedienungsanleitung

IBM

IBM 27L2579 Bedienungsanleitung

Samsung

Samsung SH-D162D Bedienungsanleitung