PipeHawk E-Safe + Bedienungsanleitung

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or

translated into any language in any form without the written permission of PIPEHAWK PLC. Brand

names, company names and product names which are trademarks or registered trademarks of their

respective companies are fully acknowledged.

Whilst every care has been taken in preparing this document to ensure that the information herein is

correct as at the time of publication, no warranties or representations are given nor implied hereby

and no use is authorised in respect of this document except for the specific purposes for which it is

supplied. This document does not form part of or constitute any contract with PIPEHAWK PLC

unless attached to and expressly stated to be incorporated therein.

PIPEHAWK PLC reserves the right to revise and improve its products as it sees fit.

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

COMPLIANCE WITH MANUFACTURER’S DESIGN-MODIFICATION

Changes or modifications not expressly approved by the party for compliance could void the user’s

authority to operate the equipment.

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

RADIO LICENSING AND PRODUCT COMPLIANCE NOTICE

This product has been designed to comply with the relevant standards and regulations that apply

within Europe. If you intend to use this product outside of Europe: You MUST ensure that it complies

with all relevant local and national standards & regulations PRIOR to use

PRODUCT COMPLIANCE - EUROPE

PipeHawk Plc ensures compliance with this R&TTE Directive 1999/5/EC –20 April 2009 by applying

relevant harmonised product standards issued by the European Telecommunications Standards

Institute (ETSI) and the

European Committee for Electrotechnical Standardisation

(CENELEC). For this

product we have determined these to be as follows:-

Section 3.1a

Protection of the health and safety of the user and any other person, including the objectives set out

in with respect to the safety requirements in the Low Voltage Directive 2006/95/EC -

January 2012, but with no voltage limit applying.

CENELEC EN60950-1:2006/A2:2013 Conformance with Information technology requirements:

Part 1-Safety

CENELEC EN50371:2002 conformance with health and safety in respect of human exposure to

Radio frequency Electromagnetic fields (10MHz-300GHz) - General public

Section 3.1b

Protection requirements with respect to electromagnetic compatibility (EMC) contained in Directive

2004/108/EC.

ETSI EN 301 489-1 V1.9.2 (2011-09) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 1:

common technical requirements.

ETSI EN 301 489-32 V1.1.1 (2005-09) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 32:

specific conditions for Ground and Wall Probing Radar applications and conformity to article 3.1b of

the R&TTE Directive 89/336/EEC

ETSI TR 101 994-2 V1.1.2 (2008-03) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Short Range Devices (SRD); Technical characteristics for SRD equipment using Ultra Wide

Band technology (UWB); Part 2: Ground- and Wall- Probing Radar applications; System Reference

Document

Section 3.2

Radio equipment shall be constructed that it effectively uses the spectrum allocated to

terrestrial/space radio communication and orbital resources so as to avoid harmful interference.

ETSI EN 302 066-1 V1.2.1 (2007-12) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Ground and Wall Probing Radar applications (GPR/WPR) imaging systems; Part 1: Technical

characteristics and test methods

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

ETSI EN 302 066-2 V1.2.1 (2007-12) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Ground and Wall Probing Radar applications (GPR/WPR) imaging systems; Part 2:

Harmonized standards covering essential requirements of article 3.2 of the R&TTE Directive

1999/5/EC

ETSI TR 102 070-1 V1.2.1 (2003-12) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Guide to the application of harmonized standards to multi-radio and combined radio and non-

radio equipment; Part 1: Electromagnetic Compatibility

ETSI TR 102 070-2 V1.1.1 (2002-11) Electromagnetic compatibility and Radio spectrum Matters

(ERM); Guide to the application of harmonized standards to multi-radio and combined radio and non-

radio equipment; Part 2: Effective use of the radio frequency spectrum

RADIO LICENSING - EUROPE

In European countries it may be necessary to obtain a radio licence from the relevant National Radio

Licensing Authority before operating the e-Safe. This provision is seen by some National Radio

Licensing Authorities as a consequence of allowing higher power levels than in for example the USA

and restricting use to trained competent professionals. The requirements of radio licensing regimes

for GPR are defined in CEPT ECC Decision ECC/DEC/ (06)08 and require the user to keep a Log

of GPR Use.

CODE OF PRACTICE FOR USERS

The radio regulatory regime is based upon the users observing appropriate operating procedures as

defined in:

ETSI EG 202 730 V1.1.1 (2009-09) Electromagnetic compatibility and radio spectrum Matters

(ERM); Code of Practice in respect of the control, use and application of Ground probing radar (GPR)

and Wall probing radar (WPR) systems and equipment. This supersedes the earlier guidance given in

ETSI

Technical Report, TR 102 554.

Failure to operate in accordance with these requirements may void the entitlement of the user to

operate the equipment. An important element of the radio licensing regime and Code of Practice is

that use is restricted to trained competent professionals.

EUROPEAN GPR ASSOCIATION

To be kept aware of licensing developments e-Safe Users are strongly advised to become members of

the European GPR Association (EuroGPR), the industry trade association which represents GPR users

in negotiations with radio licensing bodies.

Further details may be found at www.eurogpr.org

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

EC DECLARATION OF CONFORMITY

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

COMPLIANCE WITH WEEE REGULATIONS

In accordance with Regulation 9 (2) of The Waste Electrical and Electronic Regulations 2013

‘WEEE’ means waste electrical and electronic equipment as defined in the WEEE Regulations

‘WEEE Regulations’ means The Waste Electrical and Electronic Regulations 2013.

1.1 The Customer shall:

1.1.1 be responsible for financing the collection, treatment, recovery and environmentally sound

disposal of:

1.1.1.1 all WEEE arising or deriving from the Products; and

1.1.1.2 all WEEE arising or deriving from products placed on the market prior to 13 August

2005 where such products are to be replaced by the Products and the Products are of

an equivalent type or are fulfilling the same function as that of such products;

1.1.2 comply with all additional obligations placed upon the Customer by the WEEE Regulations

by virtue of the Customer accepting the responsibility set out in clause 1.1.1; and

1.1.3 provide the Seller’s WEEE compliance scheme operator with such data, documents,

information and other assistance as such scheme operator may from time to time

reasonably require to enable such operator to satisfy the obligations assumed by it as a

result of the Seller’s membership of the operator’s compliance scheme.

1.2 The Customer shall be responsible for all costs and expenses arising from and relating to its

obligations in clause 1.1.

1.3 Further information in respect of the arrangements set out in clause 1.1 can be found at

www.electrolink.eu.com by clicking on ‘BUSINESS WEEE COLLECTIONS’, then clicking ‘continue’

under final users, and then entering WEEE registration number WEE/HA0060TU where prompted.

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

PREFACE

e-Safe has been built to very high standards but requires care and attention to maintain peak

performance. This manual has been designed to provide the operator with information on the

operating and maintenance procedures necessary for the machine to function reliably and give the

designed performance.

Please read this manual carefully before operating your e-Safe. It should be kept with or near the

system for easy reference.

SAFETY NOTICE

The e-Safe is designed for deployment in a Live Site Environment. All operators must

therefore ensure they take all precautions, observe all relevant safety procedures,

follow industry standards and recommended best practice regarding operation in this

or any other operating environment. All road traffic and other regulations must be

observed and high visibility and other safety clothing worn.

PipeHawk plc accepts no responsibility whatsoever for the safety of operators.

Service of this machine is to be carried out only by fully trained and authorised

personnel.

PH 13672-2 e-Safe+/e-SafeLOG v3.0 Operator Manual

RECORD OF REVISIONS

REVISION

DATE

CHANGE

NAME

First Issue

01/09/2015

N/A

A Jones

V1.1

01/06/2016

Inclusion of New features:

Power On Self test (P.O.S.T);

Service Due Date Check;

Display Brightness Adjustment.

A Jones

v2.0

01/04/2018

New Icon for changing wheel size

Display Brightness Adjustment moved

to first screen

A Jones

v2.1

01/02/2019

Addition of information on Sellers/Final

Users responsibilities under EU WEEE

Regulations

A Jones

V3.0

01/03/2019

Combined Manual for e-SafePlus & e-

SafeLOG modes

A Jones

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere PipeHawk Werkzeuge Handbücher

PipeHawk

PipeHawk E-Safe Pro Bedienungsanleitung

Beliebte Werkzeuge Handbücher anderer Marken

Martor

Martor SECUNORM 175 Bedienungsanleitung

ERKCO

ERKCO 1000 Bedienungsanleitung

jbc

jbc N4473 Bedienungsanleitung

FEINMETALL

FEINMETALL FZWZ-SET-001 Bedienungsanleitung

Worx Professional

Worx Professional Sonicrafter WU676 Bedienungsanleitung

Gage Bilt

Gage Bilt GB713SH Bedienungsanleitung

Hilti

Hilti DX 9-ENP Bedienungsanleitung

norbar

norbar NORTRONIC 34399 Bedienungsanleitung

BGS technic

BGS technic 8578 Bedienungsanleitung

Makita

Makita DHR241 Bedienungsanleitung

Motor Guard

Motor Guard JMB-1250 Bedienungsanleitung

Power Adhesives

Power Adhesives 805-12 Bedienungsanleitung

Clemco

Clemco 24189 Bedienungsanleitung

VVG

VVG VNG 903 Series Bedienungsanleitung

Hilti

Hilti FX 3-A Bedienungsanleitung

Grizzly

Grizzly H6472 Bedienungsanleitung

axing

axing BWZ 5-02 Bedienungsanleitung

Dh-Robotics

Dh-Robotics RGI-100 Anleitung zur Verwendung