Content advising by Jason Lee.
SolidWorks® Composer™ renderings by Tim Lankford. Keyshot® cover renders by Jason Redd.
Desktop publishing by Todd McGeorge.
©2020 Pitsco, Inc., 915 E. Jefferson, Pittsburg, KS 66762
All rights reserved. This product and related documentation are protected by copyright and are distributed under licenses
restricting their use, copying, and distribution. No part of this product or related documentation may be reproduced in any
form by any means without prior written authorization of Pitsco, Inc.
All other product names mentioned herein might be the trademarks of their respective owners.
V1.0
07/20
Safety
• Always wear safety glasses when using a drill to tighten screws.
• Keep fingers and loose articles of clothing clear of the drill.
Recommended/Required Tools
• Corded or cordless drill/driver
• 1/4" drill bit
• Driver bits including #2 Phillips head and 5/32" hex (Confirmat screw)
• Phillips-head screwdriver
• Rubber mallet/hammer
