Planet IPX-1900 Bedienungsanleitung

Internet Telephony PBX system

IPX-1900

Quick Installation Guide

Table of Content

Document Objectives ....................................................................................... 3

Equipment Packaging & Overview .................................................................... 3

Installation Connect the IP PBX......................................................................... 4

Physical Introduction................................................................................... 4

Physical Installation .................................................................................... 5

Basic Conguration .................................................................................... 6

A. Web conguration access ................................................................. 6

B. IP PBX Quick Conguration .............................................................. 6

Step 1. Internet Setting ....................................................................... 7

Step 2. NAT setup ............................................................................... 8

Step 3. IP PBX Setup........................................................................... 9

Quick reference in CD-ROM guide ...............................................................10

Document Objectives

This guide provides physical installation, network congurations, and Internet

access establishment information for the PLANET Internet Telephony PBX System.

Equipment Packaging & Overview

Package Contents

IP PBX Unit

Power adapter (12V)

Quick Installation Guide

User’s Manual CD

RJ-45 cable

RS-232 cable

Rack mount

Installation Connect the IP PBX

Physical Introduction

Figure1. Font Panel of IP-1900

Front Panel LED State Descriptions

PWR On

Off

PBX Power ON

PBX Power OFF

SYS On

Flashing

System is booting

System is ready

LAN

Flashing

Off

LAN is connected successfully

Data is transmitting

Ethernet not connected to PC

WAN

Flashing

Off

PBX network connection established

Data trafc on cable network

Waiting for network connection

FXO/FXS Port

Flashing

Off

Port is busy

Ring indication. (FXS only)

Port is not enabled.

Table 1. Font Panel description of IP PBX

Figure 2. Rear Panel of IPX-1900

12V DC 12V DC Power input outlet

Power Switch “|” power is on, “O” Power is off

Reset

(Rest Button)

Push this button until 3 -5 seconds, and IP PBX will be

set to factory default conguration.

RS – 232 Port 9 pin RS232 Serial port, Data rates 57600 bits.

LAN

(Local Area network)

Connect to PC with Ethernet cable. 1 port allows your

PC or Switch/Hub to be connected to the IPBX through

a networking cable with RJ-45 connectors used on

10Base-T and 100Base-TX networks.

WAN

(Wide Area network)

Connect to the network with an Ethernet cable. This

port allows your IPBX to be connected to an Internet

Access device, e.g. router, cable modem, ADSL modem,

through a networking cable with RJ-45 connectors used

on 10Base-T and 100Base-TX networks.

Slot A/B 2 external slots with compliance FXO/FXS/FSL module.

FXS Port

(Modular IPX-19FS)

Connect to Phone with RJ-11 (Black) analog line. FXS

port was connected to your telephone sets, FAX, or

Trunk Line of PBX.

FXO Port

(Modular IPX-19FO)

Connect to PBX or CO line with RJ-11 (Write) analog

line. FXO port was connected to the extension port of a

PBX or directly connected to a PSTN line of carrier

Note: IPX-19SL 2-Port PBX Life Line Module IPX-1900 (1FXO, 1FXS)

Table 2. Rear Panel description of IP PBX

Internet

Internet IPX-1900 IP Phone

Physical Installation

Step 1: Connecting Power AC Power (12V DC).

Note

Use only the power adapter shipped with the unit to ensure correct

functionality.

Step 2: Connecting LAN to a PC

1. Connect the Ethernet cable (with RJ-45 connector) to LAN port.

2. Connect the other end of the Ethernet cable to your PC’s installed network inter-

face card (NIC).

Step 3: Connecting WAN to Internet

1. Connect the Ethernet cable (with RJ-45 connector) to WAN port.

2. Connect the other end of the Ethernet cable to DSL/Cable modem or the

external Ethernet hub or switch.

Basic Conguration

A. Web conguration access

The IP PBX provides GUI (Web based, Graphical User Interface) for machine

management and administration.

The default IP address of IP PBX LAN side is 192.168.0.1. You may now open

your web browser, and insert http://192.168.0.1 in the address bar of your web

browser to logon Internet IP PBX web conguration page.

The IP PBX will prompt for logon username/password, please enter: admin / 123

to continue device’s administration.

Note

In order to connect the IP PBX for administration, please locate

your PC in the same network segment (192.168.0.x) of IP PBX. If

you’re not familiar with TCP/IP, please refer to related chapter on

user’s manual CD or consult your network administrator for proper

network configurations.

B. IP PBX Quick Conguration

After pass the authentication, please click for quick IP PBX

setup.

For most users, Internet access is the primary application. The IP PBX supports the

WAN interface for Internet access and remote access. The following sections will

explain more details of WAN Port Internet access and broadband access setup.

Step 1. Internet Setting

Three modes are available for WAN setup

I. Fixed – IP User: If you are a leased line user with a xed IP address, ll out

the following items with the information provided by your ISP.

Figure 3. Wizard-NAT Static Setting Screen

II.DHCP – Cable Modem User: Get WAN IP Address automatically

Figure 4. Wizard-DHCP Setting Screen

III. ADSL Dial-Up User (PPPoE Enable): Some ISP’s provide DSL-based service and

use PPPoE to establish communication link with end-users. If you are connected

to the Internet through a DSL line, check with your ISP to see if they use

PPPoE. If they do, you need to select this item.

Figure 5. Wizard-PPPoE Setting Screen

Step 2. NAT setup

NAT (Network Address Translation) is a method of connecting multiple computers

to the Internet using one IP address.

Figure 6. Wizard-LAN IP Setting Screen

LAN IP Address: Private IP address for connecting to a local private network

Subnet Mask: Subnet mask for the local private network (Default:

255.255.255.0).

DHCP Server: Enable to open LAN port DHCP server.

Assigned DHCP IP Address: DHCP server range from start IP to end IP.

DHCP IP Lease Time: Client to ask DHCP server refresh time, range from 60 to

86400 seconds

Step 3. IP PBX Setup

The IP PBX allows multiple ITSP providers / User Extensions registration by simply

ll-in the required information in the provided table.

Figure 7. Wizard-IP PBX Setting Screen

Service Provider:

Caller id: Input service provider caller id / name

Username: Input Provider name

Password: Input Provider password

Host: Input Providers server address.

Port: Input Providers Port

User Extensions：

User Extension: Input Extension number

Password: Input Extension password

Caller id: Input Extension caller id

Andere Handbücher für IPX-1900

Inhaltsverzeichnis

Andere Planet Telefonanlage Handbücher

Planet

Planet IPX-330 Bedienungsanleitung

Planet

Planet IPX-2000v2 Bedienungsanleitung

Planet

Planet IPX-2100 Bedienungsanleitung

Planet

Planet IPX-1500 Bedienungsanleitung

Planet

Planet Internet Telephony PBX System IPX-300 Series Bedienungsanleitung

Planet

Planet IPX-330 Bedienungsanleitung

Planet

Planet Internet Telephony PBX System IPX-300 Series Bedienungsanleitung

Planet

Planet IPX-2500 Bedienungsanleitung

Planet

Planet IPX-1800 Bedienungsanleitung

Planet

Planet IPX-1000 Bedienungsanleitung

Planet

Planet ISDN Internet Telephony PBX System IPX-1800N Bedienungsanleitung

Planet

Planet IPX-600 Bedienungsanleitung

Planet

Planet IPX-330 Bedienungsanleitung

Planet

Planet Internet Telephony PBX System IPX-300 Series Bedienungsanleitung

Planet

Planet IPX-2500 Bedienungsanleitung

Planet

Planet IPX-1980 Bedienungsanleitung

Planet

Planet IPX-1000 Bedienungsanleitung

Planet

Planet IPX-1900 Bedienungsanleitung

Planet

Planet IPX-330 Bedienungsanleitung

Beliebte Telefonanlage Handbücher anderer Marken

Allo.com

Allo.com Nano 2 Bedienungsanleitung

ZYCOD

ZYCOD ZX50 Bedienungsanleitung

Panasonic

Panasonic KX-TDA100BX Bedienungsanleitung

LV switch

LV switch IPPBX800 Gebrauchsanweisung

Edge-Core

Edge-Core VST3305 Bedienungsanleitung

Panasonic

Panasonic KX-T7625 - Digital Proprietary Speakerphone 24... Bedienungsanleitung

Rauland-Borg

Rauland-Borg Telecenter IV Bedienungsanleitung

Grandstream Networks

Grandstream Networks UCM6208 Bedienungsanleitung

ATCOM

ATCOM IPPBX IP02 Bedienungsanleitung

Panasonic

Panasonic KX-TVS50 - 2 Port Voicemail System Bedienungsanleitung

bintec elmeg

bintec elmeg elmeg hybird 600 Bedienungsanleitung

Panasonic

Panasonic KX-NS300 Bedienungsanleitung

MCK

MCK EXTender PBXgateway Bedienungsanleitung

Panasonic

Panasonic KX-NS300CN Betriebsanleitung

NEC

NEC SL1000 Bedienungsanleitung

Epygi

Epygi Quadro Quadro 2xi Bedienungsanleitung

SMC Networks

SMC Networks TigerVoIP SMCPBX10 Bedienungsanleitung

AGFEO

AGFEO AC 14 analog Bedienungsanleitung