TABLE OF CONTENTS
1) Safety instructions
2)
Technical data
3)
Warranty and liability
4)
Installation
5)
Operating elements / adjustments
6)
Operation
7)
Servicing and cleaning
8)
Troubleshooting
9)
Layout – spare parts list
READ THE OPERATING INSTRUCTIONS CAREFULLY
WEAR EYE, FACE, AND HAND PROTECTION WHEN OPERATING
THE TOOL.
GENERAL SAFETY INSTRUCTIONS:
The tool must be used by properly trained people. Failure to follow the operating instructions or
improper use could cause strap breakage, injuries, or package damages.
Check tool daily, do not use tool with worn or damaged parts. Use original spare parts for
replacement. Never modify any tool part.
Do not put fingers, hands or other body parts between the strap and package during the cycle.
It is your responsibility to check the seal joints made by your tool. Training about the weld time
adjustment will be useful to check the seal quality in order to avoid severe injury. Never move goods
with bad quality seals. Only use specific strap dispenser to dispense the strap. Keep your working
area clean and always use the tool in good balance and safety conditions. Never use straps as a
means of pulling or lifting goods.
Always use a proper safety strap cutter and keep other people and yourself at a safe distance from
strap, always stand to side of strap, away from direction of strap trajectory once cut. Hold the upper
strap portion and pay attention that the lower strap will snap forward away from you.
Improper operation, excessive tensioning, use of non-recommended strap, or sharp corners on the
package could cause a loss of strap tension and/or strap breakage that could lead to packaging
failure or injury. The following is recommended; use edge protectors if package has sharp corners,
place the strap correctly around a properly positioned package, stand in safety position (on one side
of strap) during strapping cycle, and use the correct strap quality, width, thickness, and break
strength as recommended in this manual.
Please save this manual, as it is a part of the tool. This tool is manufactured without any substances
which could be dangerous to health. National instructions must be observed for disposal of all the
parts.
GENERAL SAFETY INSTRUCTIONS FOR COMPRESSED AIR:
Never operate this tool using bottled air or other gas source. Do not exceed the air pressure range
as shown in this operation manual. For all adjustments, repairs or cleaning of the tool, always
disconnect air supply. Always use dry, clean and lubricated compressed air.
