PORT GUARD Bedienungsanleitung
Installation Guide
DEADBOLT LOCK
GUARD
Phillips head Screwdriver
Note: No drill needed
Bolt and strike Exterior Assembly Interior Assembly Screws
Step 2
Step 3
Step 5
What
you'll
need
WHAT'S INCLUDED
Manual Key
Keypad & Fob Reader
USB port
Battery cover
Battery pack
Reset button
PRODUCT OVERVIEW
FRONT PANEL BACK PANEL
EXPLOSIVE VIEW
Battery cover
Screws
Back panel
Front panel
Cable
Mounting plate
Bolt
Adjust the backset of latch (if needed)
Hold the bolt in front of the
door hole, with the latch face
A
Latch adjustmen t (only if needed)
C
If the bolt holes are centered in the door hole, no adjustment
is required. Proceed to step 2. If the bolt holes are NOT
centered, adjust latch. See "bolt Adjustment."
B
60mm(2-3/8 in)
70mm(2-3/8 in)
60mm(2-3/8 in)
1
Install Bolt
2
A B
The knob must
be vertical
Install front panel
3IMPORTANT!
outside
Connect wire connector
Note: Cable goes below deadbolt,The wire connectors can only
be connected in one way.
4
Install back panel
5
inside
6
inside
Install batteries and battery cover
Inhaltsverzeichnis
Andere PORT Sperren Handbücher
