2
1. Switching between support and no support modes
The switch can be operated in two modes:
Support mode
Pressing and releasing the UP or DOWN button activates the programmed motor
function (opening or closing the roller shutter). The motor will run until it completely
closes or opens the roller shutter.
No support mode
The motor will work only when we keep the button pressed. Releasing the button causes
the motor to stop working. If the button is held for more than 2 seconds, the motor will
start to operate in the same way as in the support mode, that is, until the roller shutter is
fully closed or opened.
Switching between individual modes is performed in the following way:
1. For the selected drive, press the UP + STOP buttons simultaneously for 6 seconds -
the LED on the switch will light up.
2. After 6 seconds, release the buttons - the LED will start flashing and will go off.
Setting of the operating mode of the selected drive has been changed.
6 sek. (flashing diode)
