Positron G1002-C Bedienungsanleitung
Document 180-0221-001-R01
G1002-C
Self-installation Guide
WWW.POSITRONACCESS.COM
5101 Buchan Street, Suite 220,
Montreal, QC H4P 2R9 Canada
© Positron Access Solutions
Troubleshooting
The G1002-C has three (3) Status LEDs:
• PWR: it will be ON when connected to
a local power source. If it is OFF, please
verify you have connected the 12V wall
adapter to a working power jack.
• STA: it will be yellow while the G1002-C
is booting and then will be OFF.
• G.hn: it will be ON (green) to indicate
that the link to the Internet is UP. It will
be OFF in the link is DOWN. It will blink
ON and OFF to indicate a bad link. You
can restart the G1002-C if you see a
blinking G.hn LED. If this does not solve
the problem, please reach out to your
Operator for assistance.
G1002-C Port and LED Definition
2 x Gigabit Ethernet (RJ-45)
G.hn Port (F-type)
G1002-C Status LEDs
12Vdc Jack
Step 4. Connect the port labeled as GE1 (on the opposite end of the G1002-C) to your
Residential Gateway using a standard Ethernet cable (usually provided with your
Residential Gateway). Port GE1 is capable of being congured in VLAN Trunk Mode
(over 4000 VLANs). Port GE2 is congurable in VLAN Access Mode (up to 12 VLANs).
Step 2. Connect the port labeled as LINE to your coaxial jack.
Step 3. Connect the 12V wall adapter to a nearby power plug and connect it to the 12V
connector of the G1002-C
Unpacking the G1002-C
Connecting the G1002-C to
your Residential Gateway
Step 1. Find a location close to where you will
install your Residential Gateway. This
location should also be close to the
coaxial jack where you will connect
the G1002-C and to a power outlet.
Power Up
The G1002-C takes less than one (1) minute to power up and establish the connection to the
Internet. The STA LED will turn solid green to indicate that the G1002-C boot sequence is
completed. The G.hn LED will turn green solid to indicate that the link is UP.
Your Residential Gateway will now be able to obtain its conguration and IP address and begin
providing access to the Internet for your in-home devices. Refer to the installation document for
your Residential Gateway if needed.
12V wall adapter
G1002-C
Step 3 Step 2
Coaxial jack
Power plug
12V wall adapter
Step 4
Ethernet Cable
Residential Gateway
G1002-C
Andere Handbücher für G1002-C
2
Andere Positron Drahtloser Zugangspunkt Handbücher
Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken
D-Link
D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung
Ubiquiti
Ubiquiti NanoStation NSM2 Bedienungsanleitung
Cisco
Cisco Aironet 1550 Series Bedienungsanleitung
Aruba
Aruba IAP-335 Bedienungsanleitung
Advantek Networks
Advantek Networks AWN-AP-54MR Bedienungsanleitung
IP-COM
IP-COM AP355 Bedienungsanleitung
Buffalo
Buffalo AirStation WLA-L11G Bedienungsanleitung
EnGenius
EnGenius EnStationACv2 Bedienungsanleitung
D-Link
D-Link DAP-3662 Bedienungsanleitung
xG Technology
xG Technology xMax CN1300 Bedienungsanleitung
Widelink
Widelink ezWave WAP-1100 Series Bedienungsanleitung
Edimax
Edimax CAP1200 Bedienungsanleitung
