4
●There are safety cord holes at the bottom of the base of a projector. In view of safety, please run the safety
cord suppliedthroughthesafetycord holesfor safetysupport.
●Before any installation, maintenance and cleaning work, please ensure the projector is disconnected from
powermains.
●After runningfor30minutes, thetemperatureofthehousingoftheprojectoris45℃.After stableoperation,
itstemperature is90℃.
●Whilethelamp is strickenforthefirsttime, therewillbesmoke andstrangesmell.It’s normal and does not
mean theprojectorhas somedefects.
●Donotmounttheprojectordirectlyoninflammable surface.
●Donotproject thebeamstraightlyoncombustibleitems andthe minimumdistancebetweenthe projector
and illuminateditemsis18m.
●Aprojector should be installed with good ventilation and the minimum distance between the projector and
wallsis50cm.Atthesametime,pleaseensure thefansand airinletsand outletsareworkable.
2. INSTRUCTIONS
●CLEANINGANDMAINTENANCE
If a projector can’t start. Please check if the fuse is blown up. If it does, replace it with a new fuse with same ratings. And the
projector has over-temperature protective device. Ifthe temperature is too high, the protective device will be triggered to shut the
projector off. When it happens, please check if the fans run normally or fan shield is blocked by dust. After the issue is solved,
restartthe projector.
The accumulation of oil, smoke and dust onthe lens will compromise the light output. Cleaning a projector is very necessary to
ensure a reliable use of it. Cooling fans need to be cleaned every 15days. Internal lens, reflectorand hot mirror need to be cleaned
periodicallytooptimize lightoutput.
Cleaning frequencyis to be decided byoperations and its environment. Use soft cloth and normaldetergent for glass for cleaning
work. It’s advised external optical system be cleaned every 20days and internal optical systems every 30/60days. Keep lens clean
and do not touchoptical partswith bare hands.
●Beforeanymaintenanceand cleaning,please ensuretheprojectisoffthepower.
●Onlyqualifiedpersonis allowedto domaintenance.
●Duringmaintenanceandbefore maintenance, theprojector mustbeoffpower.
●To avoid sunlight or other light penetrating into the head via the front lens,resulting in
high temperature interally causing damages to the projector. Before power-off, please
use Tilt channel to move the head and make it facing downward.
●Donot usealcoholorother organicsolventto cleanthe housingto avoiddamage.
●Donotuseanysolvent withchemicalelementsto cleancolor filtersor hotmirror.
●LUBRICATION
To ensure smooth movement of gobos and zoom and focus lens, it’s advised rotators’ bearings and 2 sliding bars for zoom and
focuslensbelubricatedevery2 months.Highqualityand hightemperaturelubricant/greaseisadvised..
●TROUBLESHOOTING
The projector doesn’t switch on
Checkthefuseonthepowersocket.
Checkthe lamp.
The lamp ison but the projector doesn’t respond
to thecontroller
Makesurethatthe fixture’s start address is right
Replaceorrepair theXLRsignalcable.
The projector functionsintermittently
Makesurethefanisworkingwellorfansandtheirshieldsarenotblocked
Beamappears dim, Lowinbrightness
Makesurethe lamp is withinitslifespan
Removedustorgrease fromthe lenses.
The projectimageappearstohavea halo
Carefullycleanthe lamp,opticallensesandothercomponents.
