Precor CW-113 Bedienungsanleitung

Assembly Guide

CW-113

CW-113 Assembly and Maintenance Guide

page 3

IMPORTANT SAFETY INSTRUCTIONS

Important Safety Instructions

When using exercise equipment, basic precautions

should always be taken, including the following:

• Read all instructions before assembling the

CW-113. These instructions are written for your

safety and to protect the unit.

• Read each step in the assembly instructions and

follow the steps in sequence. Do not skip ahead. If

you skip ahead, you may learn later that you have

to disassemble components and that you may

have damaged the equipment which would void

the Precor Limited Warranty.

• Assemble and operate the CW-113 on a solid,

level surface. Locate the unit a few feet from walls

or furniture to provide easy access.

• Do not allow children or those unfamiliar with its

operation on or near the equipment. Do not leave

children unsupervised around the unit.

• Use the equipment only for its intended purpose.

Do not use accessory attachments that are not

recommended by the manufacturer, as such

attachments may cause injuries.

• Do not attempt to service the CW-113 yourself.

The unit does not contain any user-serviceable

parts.

Obtaining Service

For information about product operation or service,

refer to the Precor web site at www.precor.com where

you can also find customer support numbers or a list of

Precor authorized service centers.

If you call or e-mail Customer Support, have the serial

number available.

You can find the serial number printed on a label

affixed to the CW-113. For future reference, write the

serial number in the space provided below.

Serial number: _______________________

CW-113 Assembly and Maintenance Guide

page 4

Table of Contents

Important Safety Instructions ...................................................................................................3

Obtaining Service .................................................................................................................... 3

Preparations................................................................................................... 5

Unpacking the Equipment ....................................................................................................... 5

Required Tools......................................................................................................................... 5

Installation Requirements ........................................................................................................ 5

Hardware Kit ............................................................................................................................ 6

Assembly Instructions .................................................................................. 7

Open the Box .......................................................................................................................... 7

Assemble the Unit ................................................................................................................... 8

Assemble the Pads .................................................................................................................. 11

Clean the Pads and Assembly ................................................................................................ 12

Limited Warranty Statement .................................................................................................... 13

Specifications ............................................................................................................. Back cover

Table of Contents

CW-113 Assembly and Maintenance Guide

page 5

1Preparations

Preparations

The CW-113 parts are inspected before shipment.

Each unit contains several pieces that require

assembly. You will need to obtain adult assistance

during the assembly process.

Unpacking the Equipment

When you open the box, carefully unpack the pieces

and lay them on the floor near the location where you

plan to use them.

CAUTION: Be careful when you use a utility knife to

remove the packaging material. Do not cut the

upholstery or scratch the paint.

If any items are missing, contact the dealer from whom

you purchased the unit. For more information, refer to

Obtaining Service.

Required Tools

Tools that you need to obtain before assembling the

unit include:

❏Wire cutter or utility knife

❏¾-inch open end wrench

❏

Installation Requirements

Follow these installation requirements when

assembling the unit:

•Review the

Important Safety Instructions

•Assemble the unit where it will be used.

•Install components in the sequence shown.

•Insert all fasteners in the same direction. For

aesthetic purposes, insert all the fasteners in the

same direction unless specified (in text or

illustrations) to do otherwise.

•Leave room for adjustments. Tighten fasteners to

keep the unit stable, but leave room for

adjustments.

3⁄32-inch Allen wrench

CW-113 Assembly and Maintenance Guide

page 6

½ x 5¼-inch Buttonhead screw (E) 1

Fastener Qty

Hardware Kit

³⁄₈ x ¾-inch Buttonhead screw (A) 12

½-inch Washer (F) 2

³⁄₈-inch Washer (D) 2

³⁄₈-inch Split washer (B) 14

³⁄₈ x 2¾-inch Buttonhead screw (C) 2

½-inch Lock nut (G) 1

⁵⁄₁₆ x 3-inch Buttonhead screw (H) 4

⁵⁄₁₆ x 1¼-inch Buttonhead screw (L) 6

⁵⁄₁₆-inch Washer (K) 10

⁵⁄₁₆-inch Split washer (J) 10

Fastener Qty

Preparations, continued

CW-113 Assembly and Maintenance Guide

page 7

2Assembly

Instructions

Assembly Instructions

Assembly of the CW-113 takes about 50 minutes to

complete. If this is the first time you have assembled

this type of equipment, plan on allowing more time.

Be careful to open boxes and assemble components in

the sequence presented in thie manual.

Open the Box

Use wire cutters to open the box and remove packing

materials.

The illustration shows how the CW-113 will look when

you have completed its assembly. The callouts identify

specific pieces.

Back Pad

Thigh Pad

Handlebar

Roller Pads

Back Adjustment

Main Frame

Holder Assembly

Stabilizer

Back

Support

CW-113 Assembly and Maintenance Guide

page 8

Assemble the Unit

1. Attach the Main Frame to the Stabilizer using

four ¾-inch buttonhead screws (A)

four ³⁄₈-inch split washers (B)

Wrench tighten.

Note: Make sure the wheels on the Stabilizer are

positioned as shown in the illustration.

2. Attach two Spring Cushions to the Main Frame

using

two 2¾-inch buttonhead screws (C)

two ³⁄₈-inch split washers (B)

two ³⁄₈-inch washers (D)

Wrench tighten.

3. Insert two Springs onto the Spring Cushions.

4. Turn the Back Support over and attach the Back

Adjustment to the Back Support using

four ¾-inch buttonhead screws (A)

four ³⁄₈-inch split washers (B)

Wrench tighten.

4 - ¾" buttonhead screws

4 - split washers

2 - 2¾" buttonhead screws

2 - washers

2 - split washers

2 - Spring Cushions

Spring Cushion

4 - ¾" buttonhead screws

4 - split washers

CW-113 Assembly and Maintenance Guide

page 9

Assemble the Unit, continued

5. Pull on the Adjustment Pin and slide the Back

Adjustment through the Main Frame. Release the

Adjustment Pin while it is aligned with the Back

Adjustment middle hole.

Note: Make sure the Springs slide onto the posts

on the bottom of the Back Support

6. Slide the Sleeve through the Back Support. Align

the holes and attach the Back Support to the Main

Frame using

one 5¼-inch buttonhead screw (E)

two ½-inch washers (F)

one ½-inch locknut (G)

Wrench tighten using a ¾-inch open end wrench.

7. Attach the Holder Assembly to the Back Support

using

four ¾-inch buttonhead screws (A)

four ³⁄₈-inch split washers (B)

Wrench tighten.

4 - ¾" buttonhead screws

4 - split washers

1 - 5¼" buttonhead screw

1 - sleeve

2 - washers

1 - locknut

Sleeve

CW-113 Assembly and Maintenance Guide

page 10

Assemble the Unit, continued

Roller Bar

8. Slide the Roller Bar through Holder Assembly, and

then place a Round Cap onto each end of the

Roller Bar. Slide the Round Caps against the

Holder Assembly.

9. Slide a Roller Pad onto each end of the Roller Bar,

followed by a Roller Cap. Place an Aluminum Cap

on each end of the Roller Bar and tighten the set

screws.

10. Tighten the set screws at the end of the Holder

Assembly to secure the Roller Bar, then insert the

Square Cap into the Holder Assembly.

11. Insert a Round Cap into each end of the

Handlebar, and then slide the Handlebar through

the Holder Assembly. Slide a Grip onto each end of

the Handlebar, then secure the Handlebar to the

Holder Assembly by tightening the set screws with

a 3⁄32-inch Allen wrench.

Andere Handbücher für CW-113

Inhaltsverzeichnis

Andere Precor Heim-Fitnessstudio Handbücher

Precor

Precor Icarian Line Leitfaden

Precor

Precor Discovery Plate Loaded Pulldown Series Bedienungsanleitung

Precor

Precor DISCOVERY Bedienungsanleitung

Precor

Precor Discovery Plate Loaded Line Low Row Bedienungsanleitung

Precor

Precor Ab-X100 Bedienungsanleitung

Precor

Precor Home Bench Bedienungsanleitung

Precor

Precor Discovery Olympic Bench Series Bedienungsanleitung

Precor

Precor 612 Bedienungsanleitung

Precor

Precor Discovery Series Bedienungsanleitung

Precor

Precor FTS Glide Kurzanleitung

Precor

Precor Discovery Series Bedienungsanleitung

Precor

Precor Discovery Plate Loaded Line Bedienungsanleitung

Precor

Precor Move Beyond EFX556 NAVY Bedienungsanleitung

Precor

Precor FTS Glide Kurzanleitung

Precor

Precor Discovery Plate Loaded Line Bedienungsanleitung

Precor

Precor Vitality Series Selectorized Line Bedienungsanleitung

Beliebte Heim-Fitnessstudio Handbücher anderer Marken

Horizon Fitness

Horizon Fitness OXFORD 6 Bedienungsanleitung

Energetics

Energetics Multi Trainer 5.1 Bedienungsanleitung

Matrix

Matrix MG-PL Series Bedienungsanleitung

Reebok

Reebok Tbr2i Bedienungs- und Wartungshandbuch

Weider

Weider 8300 Hard Drive Bedienungsanleitung

Pure Fitness

Pure Fitness 8526HE Bedienungsanleitung

Weider

Weider 8700 I Kurzanleitung

Bowflex

Bowflex Sport 001-6961 Bedienungsanleitung

NordicTrack

NordicTrack E8200 Competition Bench Kurzanleitung

Weider

Weider WEMC10161 Bedienungsanleitung

Body Solid

Body Solid GHYP-345 Bedienungsanleitung

Evo

Evo TAHOE 5105 Bedienungsanleitung

cardiobull

cardiobull RA17 Bedienungsanleitung

ParaBody

ParaBody 40 Bedienungsanleitung

JLL

JLL Ventus Pro Air Power Bedienungsanleitung

Trojan

Trojan Colorado 370 Bedienungsanleitung

Octane Fitness

Octane Fitness xRide xR650 Bedienungsanleitung

Insportline

Insportline RW600 Bedienungsanleitung